Blackfin: BF518F-EZBRD: handle required portmuxing of async pins

The two high address lines on the BF51x are not dedicated which means we
need to handle them like any other peripheral pin if we want to access the
upper 2MB of parallel flash.

Signed-off-by: Graf Yang <graf.yang@analog.com>
Signed-off-by: Mike Frysinger <vapier@gentoo.org>

diff --git a/arch/blackfin/mach-bf518/boards/ezbrd.c b/arch/blackfin/mach-bf518/boards/ezbrd.c
index 41f2eac..602dce0 100644 (file)
--- a/arch/blackfin/mach-bf518/boards/ezbrd.c
+++ b/arch/blackfin/mach-bf518/boards/ezbrd.c
@@ -82,7 +82,11 @@ static struct physmap_flash_data ezbrd_flash_data = {
 
 static struct resource ezbrd_flash_resource = {
        .start = 0x20000000,
+#if defined(CONFIG_SPI_BFIN) || defined(CONFIG_SPI_BFIN_MODULE)
+       .end   = 0x202fffff,
+#else
        .end   = 0x203fffff,
+#endif
        .flags = IORESOURCE_MEM,
 };
 
@@ -678,6 +682,11 @@ static int __init ezbrd_init(void)
                                ARRAY_SIZE(bfin_i2c_board_info));
        platform_add_devices(stamp_devices, ARRAY_SIZE(stamp_devices));
        spi_register_board_info(bfin_spi_board_info, ARRAY_SIZE(bfin_spi_board_info));
+       /* setup BF518-EZBRD GPIO pin PG11 to AMS2, PG15 to AMS3. */
+       peripheral_request(P_AMS2, "ParaFlash");
+#if !defined(CONFIG_SPI_BFIN) && !defined(CONFIG_SPI_BFIN_MODULE)
+       peripheral_request(P_AMS3, "ParaFlash");
+#endif
        return 0;
 }
 

diff --git a/arch/blackfin/mach-bf518/include/mach/portmux.h b/arch/blackfin/mach-bf518/include/mach/portmux.h
index f618b48..a0fc77f 100644 (file)
--- a/arch/blackfin/mach-bf518/include/mach/portmux.h
+++ b/arch/blackfin/mach-bf518/include/mach/portmux.h
@@ -185,6 +185,10 @@
 #define P_PTP_PPS              (P_DEFINED | P_IDENT(GPIO_PG12) | P_FUNCT(2))
 #define P_PTP_CLKOUT           (P_DEFINED | P_IDENT(GPIO_PG13) | P_FUNCT(2))
 
-#define P_HWAIT                (P_DEFINED | P_IDENT(GPIO_PG000000000) | P_FUNCT(1))
+/* AMS */
+#define P_AMS2                 (P_DEFINED | P_IDENT(GPIO_PG11) | P_FUNCT(1))
+#define P_AMS3                 (P_DEFINED | P_IDENT(GPIO_PG15) | P_FUNCT(2))
+
+#define P_HWAIT                        (P_DEFINED | P_IDENT(GPIO_PG000000000) | P_FUNCT(1))
 
 #endif                         /* _MACH_PORTMUX_H_ */