atm: [iphase] doesn't call phy->start due to a bogus #ifndef

This causes the suni driver to oops if you try to use sonetdiag to get
the statistics. Also add the corresponding phy->stop call to fix another
oops if you try to remove the module.

Signed-off-by: Jorge Boncompte [DTI2] <jorge@dti2.net>
Signed-off-by: Chas Williams <chas@cmf.nrl.navy.mil>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/atm/iphase.c b/drivers/atm/iphase.c
index 800c09e..139fce6 100644 (file)
--- a/drivers/atm/iphase.c
+++ b/drivers/atm/iphase.c
@@ -2562,17 +2562,11 @@ static int __devinit ia_start(struct atm_dev *dev)
                error = suni_init(dev);
                if (error)
                        goto err_free_rx;
-               /* 
-                * Enable interrupt on loss of signal
-                * SUNI_RSOP_CIE - 0x10
-                * SUNI_RSOP_CIE_LOSE - 0x04
-                */
-               ia_phy_put(dev, ia_phy_get(dev, 0x10) | 0x04, 0x10);
-#ifndef MODULE
-               error = dev->phy->start(dev);
-               if (error)
-                       goto err_free_rx;
-#endif
+               if (dev->phy->start) {
+                       error = dev->phy->start(dev);
+                       if (error)
+                               goto err_free_rx;
+               }
                /* Get iadev->carrier_detect status */
                IaFrontEndIntr(iadev);
        }
@@ -3238,9 +3232,14 @@ static void __devexit ia_remove_one(struct pci_dev *pdev)
        struct atm_dev *dev = pci_get_drvdata(pdev);
        IADEV *iadev = INPH_IA_DEV(dev);
 
-       ia_phy_put(dev, ia_phy_get(dev,0x10) & ~(0x4), 0x10); 
+       /* Disable phy interrupts */
+       ia_phy_put(dev, ia_phy_get(dev, SUNI_RSOP_CIE) & ~(SUNI_RSOP_CIE_LOSE),
+                                  SUNI_RSOP_CIE);
        udelay(1);
 
+       if (dev->phy && dev->phy->stop)
+               dev->phy->stop(dev);
+
        /* De-register device */  
        free_irq(iadev->irq, dev);
        iadev_count--;