ieee1394: sbp2: pass REQUEST_SENSE through to the target

Delete some incorrect code, left over from the initial driver submission
in March 2001.

SBP-2 targets should provide sense data via the SBP-2 status block
(autosense).  We have to pass the REQUEST_SENSE command through to
targets which don't implement autosense, if there are any, and to
accomodate application clients which use this command.

Signed-off-by: Stefan Richter <stefanr@s5r6.in-berlin.de>

diff --git a/drivers/ieee1394/sbp2.c b/drivers/ieee1394/sbp2.c
index e68b80b..d804283 100644 (file)
--- a/drivers/ieee1394/sbp2.c
+++ b/drivers/ieee1394/sbp2.c
@@ -1882,16 +1882,6 @@ static int sbp2scsi_queuecommand(struct scsi_cmnd *SCpnt,
        if (unlikely(SCpnt->device->lun))
                goto done;
 
-       /* handle the request sense command here (auto-request sense) */
-       if (SCpnt->cmnd[0] == REQUEST_SENSE) {
-               memcpy(SCpnt->request_buffer, SCpnt->sense_buffer,
-                      SCpnt->request_bufflen);
-               memset(SCpnt->sense_buffer, 0, sizeof(SCpnt->sense_buffer));
-               sbp2scsi_complete_command(lu, SBP2_SCSI_STATUS_GOOD, SCpnt,
-                                         done);
-               return 0;
-       }
-
        if (unlikely(!hpsb_node_entry_valid(lu->ne))) {
                SBP2_ERR("Bus reset in progress - rejecting command");
                result = DID_BUS_BUSY << 16;