alim15x3: fix handling of DMA timings
authorBartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Mon, 18 Jan 2010 07:21:19 +0000 (07:21 +0000)
committerDavid S. Miller <davem@davemloft.net>
Tue, 19 Jan 2010 09:52:31 +0000 (01:52 -0800)
Stop depending on the BIOS setup.

Based on libata pata_ali host driver.

Signed-off-by: Bartlomiej Zolnierkiewicz <bzolnier@gmail.com>
Signed-off-by: David S. Miller <davem@davemloft.net>
drivers/ide/alim15x3.c

index 529f8e2..3ba7d0b 100644 (file)
@@ -61,6 +61,25 @@ static void ali_fifo_control(ide_hwif_t *hwif, ide_drive_t *drive, int on)
        pci_write_config_byte(pdev, pio_fifo, fifo);
 }
 
+static void ali_program_timings(ide_hwif_t *hwif, ide_drive_t *drive,
+                               struct ide_timing *t)
+{
+       struct pci_dev *dev = to_pci_dev(hwif->dev);
+       int port = hwif->channel ? 0x5c : 0x58;
+       u8 unit = drive->dn & 1;
+
+       t->setup = clamp_val(t->setup, 1, 8) & 7;
+       t->act8b = clamp_val(t->act8b, 1, 8) & 7;
+       t->rec8b = clamp_val(t->rec8b, 1, 16) & 15;
+       t->active = clamp_val(t->active, 1, 8) & 7;
+       t->recover = clamp_val(t->recover, 1, 16) & 15;
+
+       pci_write_config_byte(dev, port, t->setup);
+       pci_write_config_byte(dev, port + 1, (t->act8b << 4) | t->rec8b);
+       pci_write_config_byte(dev, port + unit + 2,
+                             (t->active << 4) | t->recover);
+}
+
 /**
  *     ali_set_pio_mode        -       set host controller for PIO mode
  *     @hwif: port
@@ -71,12 +90,9 @@ static void ali_fifo_control(ide_hwif_t *hwif, ide_drive_t *drive, int on)
 
 static void ali_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)
 {
-       struct pci_dev *dev = to_pci_dev(hwif->dev);
        ide_drive_t *pair = ide_get_pair_dev(drive);
        int bus_speed = ide_pci_clk ? ide_pci_clk : 33;
        unsigned long T =  1000000 / bus_speed; /* PCI clock based */
-       int port = hwif->channel ? 0x5c : 0x58;
-       u8 unit = drive->dn & 1;
        struct ide_timing t;
 
        ide_timing_compute(drive, drive->pio_mode, &t, T, 1);
@@ -93,21 +109,12 @@ static void ali_set_pio_mode(ide_hwif_t *hwif, ide_drive_t *drive)
                }
        }
 
-       t.setup = clamp_val(t.setup, 1, 8) & 7;
-       t.act8b = clamp_val(t.act8b, 1, 8) & 7;
-       t.rec8b = clamp_val(t.rec8b, 1, 16) & 15;
-       t.active = clamp_val(t.active, 1, 8) & 7;
-       t.recover = clamp_val(t.recover, 1, 16) & 15;
-
        /* 
         * PIO mode => ATA FIFO on, ATAPI FIFO off
         */
        ali_fifo_control(hwif, drive, (drive->media == ide_disk) ? 0x05 : 0x00);
 
-       pci_write_config_byte(dev, port, t.setup);
-       pci_write_config_byte(dev, port + 1, (t.act8b << 4) | t.rec8b);
-       pci_write_config_byte(dev, port + unit + 2,
-                             (t.active << 4) | t.recover);
+       ali_program_timings(hwif, drive, &t);
 }
 
 /**
@@ -146,11 +153,15 @@ static u8 ali_udma_filter(ide_drive_t *drive)
 static void ali_set_dma_mode(ide_hwif_t *hwif, ide_drive_t *drive)
 {
        struct pci_dev *dev     = to_pci_dev(hwif->dev);
+       ide_drive_t *pair       = ide_get_pair_dev(drive);
+       int bus_speed           = ide_pci_clk ? ide_pci_clk : 33;
+       unsigned long T         =  1000000 / bus_speed; /* PCI clock based */
        const u8 speed          = drive->dma_mode;
        u8 speed1               = speed;
        u8 unit                 = drive->dn & 1;
        u8 tmpbyte              = 0x00;
        int m5229_udma          = (hwif->channel) ? 0x57 : 0x56;
+       struct ide_timing t;
 
        if (speed == XFER_UDMA_6)
                speed1 = 0x47;
@@ -164,9 +175,21 @@ static void ali_set_dma_mode(ide_hwif_t *hwif, ide_drive_t *drive)
                tmpbyte &= ultra_enable;
                pci_write_config_byte(dev, m5229_udma, tmpbyte);
 
-               /*
-                * FIXME: Oh, my... DMA timings are never set.
-                */
+               ide_timing_compute(drive, drive->dma_mode, &t, T, 1);
+               if (pair) {
+                       struct ide_timing p;
+
+                       ide_timing_compute(pair, pair->pio_mode, &p, T, 1);
+                       ide_timing_merge(&p, &t, &t,
+                               IDE_TIMING_SETUP | IDE_TIMING_8BIT);
+                       if (pair->dma_mode) {
+                               ide_timing_compute(pair, pair->dma_mode,
+                                               &p, T, 1);
+                               ide_timing_merge(&p, &t, &t,
+                                       IDE_TIMING_SETUP | IDE_TIMING_8BIT);
+                       }
+               }
+               ali_program_timings(hwif, drive, &t);
        } else {
                pci_read_config_byte(dev, m5229_udma, &tmpbyte);
                tmpbyte &= (0x0f << ((1-unit) << 2));