cxgb3 - Add EEH support

Add PCI recovery support

Signed-off-by: Divy Le Ray <divy@chelsio.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

diff --git a/drivers/net/cxgb3/cxgb3_main.c b/drivers/net/cxgb3/cxgb3_main.c
index 9d14652..1b9a711 100644 (file)
--- a/drivers/net/cxgb3/cxgb3_main.c
+++ b/drivers/net/cxgb3/cxgb3_main.c
@@ -2316,6 +2316,112 @@ void t3_fatal_err(struct adapter *adapter)
 
 }
 
+/**
+ * t3_io_error_detected - called when PCI error is detected
+ * @pdev: Pointer to PCI device
+ * @state: The current pci connection state
+ *
+ * This function is called after a PCI bus error affecting
+ * this device has been detected.
+ */
+static pci_ers_result_t t3_io_error_detected(struct pci_dev *pdev,
+                                            pci_channel_state_t state)
+{
+       struct net_device *dev = pci_get_drvdata(pdev);
+       struct port_info *pi = netdev_priv(dev);
+       struct adapter *adapter = pi->adapter;
+       int i;
+
+       /* Stop all ports */
+       for_each_port(adapter, i) {
+               struct net_device *netdev = adapter->port[i];
+
+               if (netif_running(netdev))
+                       cxgb_close(netdev);
+       }
+
+       if (is_offload(adapter) && 
+           test_bit(OFFLOAD_DEVMAP_BIT, &adapter->open_device_map))
+               offload_close(&adapter->tdev);
+
+       /* Free sge resources */
+       t3_free_sge_resources(adapter);
+
+       adapter->flags &= ~FULL_INIT_DONE;
+
+       pci_disable_device(pdev);
+
+       /* Request a slot slot reset. */
+       return PCI_ERS_RESULT_NEED_RESET;
+}
+
+/**
+ * t3_io_slot_reset - called after the pci bus has been reset.
+ * @pdev: Pointer to PCI device
+ *
+ * Restart the card from scratch, as if from a cold-boot.
+ */
+static pci_ers_result_t t3_io_slot_reset(struct pci_dev *pdev)
+{
+       struct net_device *dev = pci_get_drvdata(pdev);
+       struct port_info *pi = netdev_priv(dev);
+       struct adapter *adapter = pi->adapter;
+
+       if (pci_enable_device(pdev)) {
+               dev_err(&pdev->dev,
+                       "Cannot re-enable PCI device after reset.\n");
+               return PCI_ERS_RESULT_DISCONNECT;
+       }
+       pci_set_master(pdev);
+
+       t3_prep_adapter(adapter, adapter->params.info, 1);
+
+       return PCI_ERS_RESULT_RECOVERED;
+}
+
+/**
+ * t3_io_resume - called when traffic can start flowing again.
+ * @pdev: Pointer to PCI device
+ *
+ * This callback is called when the error recovery driver tells us that
+ * its OK to resume normal operation.
+ */
+static void t3_io_resume(struct pci_dev *pdev)
+{
+       struct net_device *dev = pci_get_drvdata(pdev);
+       struct port_info *pi = netdev_priv(dev);
+       struct adapter *adapter = pi->adapter;
+       int i;
+
+       /* Restart the ports */
+       for_each_port(adapter, i) {
+               struct net_device *netdev = adapter->port[i];
+
+               if (netif_running(netdev)) {
+                       if (cxgb_open(netdev)) {
+                               dev_err(&pdev->dev,
+                                       "can't bring device back up"
+                                       " after reset\n");
+                               continue;
+                       }
+                       netif_device_attach(netdev);
+               }
+       }
+
+       if (is_offload(adapter)) {
+               __set_bit(OFFLOAD_DEVMAP_BIT, &adapter->registered_device_map);
+               if (offload_open(dev))
+                       printk(KERN_WARNING
+                              "Could not bring back offload capabilities\n");
+       }
+}
+
+static struct pci_error_handlers t3_err_handler = {
+       .error_detected = t3_io_error_detected,
+       .slot_reset = t3_io_slot_reset,
+       .resume = t3_io_resume,
+};
+
 static int __devinit cxgb_enable_msix(struct adapter *adap)
 {
        struct msix_entry entries[SGE_QSETS + 1];
@@ -2616,6 +2722,7 @@ static struct pci_driver driver = {
        .id_table = cxgb3_pci_tbl,
        .probe = init_one,
        .remove = __devexit_p(remove_one),
+       .err_handler = &t3_err_handler,
 };
 
 static int __init cxgb3_init_module(void)