bnx2: Allow flexible VLAN tag settings.

Negotiate with boot code and ASF firmware to see if it can
support keeping VLAN tags in the RX packets.  If supported
by firmware, the VLAN tag will be kept in the RX packet
unless VLAN acceleration is registered.

Signed-off-by: Michael Chan <mchan@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/bnx2.c b/drivers/net/bnx2.c
index 4dfd439..2d0213e 100644 (file)
--- a/drivers/net/bnx2.c
+++ b/drivers/net/bnx2.c
@@ -4255,35 +4255,43 @@ nvram_write_end:
 }
 
 static void
-bnx2_init_remote_phy(struct bnx2 *bp)
+bnx2_init_fw_cap(struct bnx2 *bp)
 {
-       u32 val;
+       u32 val, sig = 0;
 
        bp->phy_flags &= ~BNX2_PHY_FLAG_REMOTE_PHY_CAP;
-       if (!(bp->phy_flags & BNX2_PHY_FLAG_SERDES))
-               return;
+       bp->flags &= ~BNX2_FLAG_CAN_KEEP_VLAN;
+
+       if (!(bp->flags & BNX2_FLAG_ASF_ENABLE))
+               bp->flags |= BNX2_FLAG_CAN_KEEP_VLAN;
 
        val = bnx2_shmem_rd(bp, BNX2_FW_CAP_MB);
        if ((val & BNX2_FW_CAP_SIGNATURE_MASK) != BNX2_FW_CAP_SIGNATURE)
                return;
 
-       if (val & BNX2_FW_CAP_REMOTE_PHY_CAPABLE) {
+       if ((val & BNX2_FW_CAP_CAN_KEEP_VLAN) == BNX2_FW_CAP_CAN_KEEP_VLAN) {
+               bp->flags |= BNX2_FLAG_CAN_KEEP_VLAN;
+               sig |= BNX2_DRV_ACK_CAP_SIGNATURE | BNX2_FW_CAP_CAN_KEEP_VLAN;
+       }
+
+       if ((bp->phy_flags & BNX2_PHY_FLAG_SERDES) &&
+           (val & BNX2_FW_CAP_REMOTE_PHY_CAPABLE)) {
+               u32 link;
+
                bp->phy_flags |= BNX2_PHY_FLAG_REMOTE_PHY_CAP;
 
-               val = bnx2_shmem_rd(bp, BNX2_LINK_STATUS);
-               if (val & BNX2_LINK_STATUS_SERDES_LINK)
+               link = bnx2_shmem_rd(bp, BNX2_LINK_STATUS);
+               if (link & BNX2_LINK_STATUS_SERDES_LINK)
                        bp->phy_port = PORT_FIBRE;
                else
                        bp->phy_port = PORT_TP;
 
-               if (netif_running(bp->dev)) {
-                       u32 sig;
-
-                       sig = BNX2_DRV_ACK_CAP_SIGNATURE |
-                             BNX2_FW_CAP_REMOTE_PHY_CAPABLE;
-                       bnx2_shmem_wr(bp, BNX2_DRV_ACK_CAP_MB, sig);
-               }
+               sig |= BNX2_DRV_ACK_CAP_SIGNATURE |
+                      BNX2_FW_CAP_REMOTE_PHY_CAPABLE;
        }
+
+       if (netif_running(bp->dev) && sig)
+               bnx2_shmem_wr(bp, BNX2_DRV_ACK_CAP_MB, sig);
 }
 
 static void
@@ -4380,7 +4388,7 @@ bnx2_reset_chip(struct bnx2 *bp, u32 reset_code)
 
        spin_lock_bh(&bp->phy_lock);
        old_port = bp->phy_port;
-       bnx2_init_remote_phy(bp);
+       bnx2_init_fw_cap(bp);
        if ((bp->phy_flags & BNX2_PHY_FLAG_REMOTE_PHY_CAP) &&
            old_port != bp->phy_port)
                bnx2_set_default_remote_link(bp);
@@ -5879,6 +5887,8 @@ bnx2_vlan_rx_register(struct net_device *dev, struct vlan_group *vlgrp)
 
        bp->vlgrp = vlgrp;
        bnx2_set_rx_mode(dev);
+       if (bp->flags & BNX2_FLAG_CAN_KEEP_VLAN)
+               bnx2_fw_sync(bp, BNX2_DRV_MSG_CODE_KEEP_VLAN_UPDATE, 0, 1);
 
        bnx2_netif_start(bp);
 }
@@ -7483,8 +7493,6 @@ bnx2_init_board(struct pci_dev *pdev, struct net_device *dev)
                        if (reg & BNX2_SHARED_HW_CFG_PHY_2_5G)
                                bp->phy_flags |= BNX2_PHY_FLAG_2_5G_CAPABLE;
                }
-               bnx2_init_remote_phy(bp);
-
        } else if (CHIP_NUM(bp) == CHIP_NUM_5706 ||
                   CHIP_NUM(bp) == CHIP_NUM_5708)
                bp->phy_flags |= BNX2_PHY_FLAG_CRC_FIX;
@@ -7493,6 +7501,8 @@ bnx2_init_board(struct pci_dev *pdev, struct net_device *dev)
                  CHIP_REV(bp) == CHIP_REV_Bx))
                bp->phy_flags |= BNX2_PHY_FLAG_DIS_EARLY_DAC;
 
+       bnx2_init_fw_cap(bp);
+
        if ((CHIP_ID(bp) == CHIP_ID_5708_A0) ||
            (CHIP_ID(bp) == CHIP_ID_5708_B0) ||
            (CHIP_ID(bp) == CHIP_ID_5708_B1)) {

diff --git a/drivers/net/bnx2.h b/drivers/net/bnx2.h
index efa0ca9..7b882fd 100644 (file)
--- a/drivers/net/bnx2.h
+++ b/drivers/net/bnx2.h
@@ -6670,6 +6670,7 @@ struct bnx2 {
 #define BNX2_FLAG_USING_MSI_OR_MSIX    (BNX2_FLAG_USING_MSI | \
                                         BNX2_FLAG_USING_MSIX)
 #define BNX2_FLAG_JUMBO_BROKEN         0x00000800
+#define BNX2_FLAG_CAN_KEEP_VLAN                0x00001000
 
        struct bnx2_napi        bnx2_napi[BNX2_MAX_MSIX_VEC];
 
@@ -6951,6 +6952,7 @@ struct fw_info {
 #define BNX2_DRV_MSG_CODE_DIAG                  0x07000000
 #define BNX2_DRV_MSG_CODE_SUSPEND_NO_WOL        0x09000000
 #define BNX2_DRV_MSG_CODE_UNLOAD_LNK_DN                 0x0b000000
+#define BNX2_DRV_MSG_CODE_KEEP_VLAN_UPDATE      0x0d000000
 #define BNX2_DRV_MSG_CODE_CMD_SET_LINK          0x10000000
 
 #define BNX2_DRV_MSG_DATA                       0x00ff0000
@@ -7279,6 +7281,10 @@ struct fw_info {
 #define BNX2_FW_CAP_SIGNATURE_MASK              0xffff0000
 #define BNX2_FW_CAP_REMOTE_PHY_CAPABLE          0x00000001
 #define BNX2_FW_CAP_REMOTE_PHY_PRESENT          0x00000002
+#define BNX2_FW_CAP_MFW_CAN_KEEP_VLAN           0x00000008
+#define BNX2_FW_CAP_BC_CAN_KEEP_VLAN            0x00000010
+#define BNX2_FW_CAP_CAN_KEEP_VLAN      (BNX2_FW_CAP_BC_CAN_KEEP_VLAN | \
+                                        BNX2_FW_CAP_MFW_CAN_KEEP_VLAN)
 
 #define BNX2_RPHY_SIGNATURE                    0x36c
 #define BNX2_RPHY_LOAD_SIGNATURE                0x5a5a5a5a