genirq: Wake up irq thread after action has been installed

The wake_up_process() of the new irq thread in __setup_irq() is too
early as the irqaction is not yet fully initialized especially
action->irq is not yet set. The interrupt thread might dereference the
wrong irq descriptor.

Move the wakeup after the action is installed and action->irq has been
set.

Reported-by: Michael Buesch <mb@bu3sch.de>
Signed-off-by: Thomas Gleixner <tglx@linutronix.de>
Tested-by: Michael Buesch <mb@bu3sch.de>

diff --git a/kernel/irq/manage.c b/kernel/irq/manage.c
index d222515..0ec9ed8 100644 (file)
--- a/kernel/irq/manage.c
+++ b/kernel/irq/manage.c
@@ -607,7 +607,6 @@ __setup_irq(unsigned int irq, struct irq_desc *desc, struct irqaction *new)
                 */
                get_task_struct(t);
                new->thread = t;
-               wake_up_process(t);
        }
 
        /*
@@ -690,6 +689,7 @@ __setup_irq(unsigned int irq, struct irq_desc *desc, struct irqaction *new)
                                (int)(new->flags & IRQF_TRIGGER_MASK));
        }
 
+       new->irq = irq;
        *old_ptr = new;
 
        /* Reset broken irq detection when installing new handler */
@@ -707,7 +707,13 @@ __setup_irq(unsigned int irq, struct irq_desc *desc, struct irqaction *new)
 
        spin_unlock_irqrestore(&desc->lock, flags);
 
-       new->irq = irq;
+       /*
+        * Strictly no need to wake it up, but hung_task complains
+        * when no hard interrupt wakes the thread up.
+        */
+       if (new->thread)
+               wake_up_process(new->thread);
+
        register_irq_proc(irq, desc);
        new->dir = NULL;
        register_handler_proc(irq, new);