ixgbe: fix link down initial state

As reported by Andrew Lutomirski <amluto@gmail.com>

All the intel wired ethernet drivers were calling netif_carrier_off
and netif_stop_queue (or variants) before calling register_netdevice

This is incorrect behavior as was pointed out by davem, and causes
ifconfig and friends to report a strange state before first link
after the driver was loaded, since without a netif_carrier_off, the stack
assumes carrier_on, but before register_netdev, netlink messages are not
sent out telling link state.

This apparently confused *some* versions of networkmanager.

Signed-off-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Reported-by: Andrew Lutomirski <amluto@gmail.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/ixgbe/ixgbe_main.c b/drivers/net/ixgbe/ixgbe_main.c
index 0d9a3ac..d5d9589 100644 (file)
--- a/drivers/net/ixgbe/ixgbe_main.c
+++ b/drivers/net/ixgbe/ixgbe_main.c
@@ -3459,6 +3459,8 @@ static int ixgbe_open(struct net_device *netdev)
        if (test_bit(__IXGBE_TESTING, &adapter->state))
                return -EBUSY;
 
+       netif_carrier_off(netdev);
+
        /* allocate transmit descriptors */
        err = ixgbe_setup_all_tx_resources(adapter);
        if (err)
@@ -4772,13 +4774,14 @@ static int __devinit ixgbe_probe(struct pci_dev *pdev,
        /* reset the hardware with the new settings */
        hw->mac.ops.start_hw(hw);
 
-       netif_carrier_off(netdev);
-
        strcpy(netdev->name, "eth%d");
        err = register_netdev(netdev);
        if (err)
                goto err_register;
 
+       /* carrier off reporting is important to ethtool even BEFORE open */
+       netif_carrier_off(netdev);
+
 #ifdef CONFIG_IXGBE_DCA
        if (dca_add_requester(&pdev->dev) == 0) {
                adapter->flags |= IXGBE_FLAG_DCA_ENABLED;