[POWERPC] Fix interrupts on 8540 ADS board
authorAndy Fleming <afleming@freescale.com>
Fri, 18 Aug 2006 23:03:08 +0000 (18:03 -0500)
committerPaul Mackerras <paulus@samba.org>
Wed, 23 Aug 2006 05:51:18 +0000 (15:51 +1000)
* Fixed 8540 ADS support for the new irq layer
* Fixed 8540 ADS support for mapping PCI interrupts
* Updated 8540 ADS to use device tree for interrupt assignment
  and sense values

Signed-off-by: Paul Mackerras <paulus@samba.org>
arch/powerpc/platforms/85xx/mpc85xx_ads.c

index 06a4976..9d2acfb 100644 (file)
@@ -37,79 +37,7 @@ unsigned long isa_io_base = 0;
 unsigned long isa_mem_base = 0;
 #endif
 
-/*
- * Internal interrupts are all Level Sensitive, and Positive Polarity
- *
- * Note:  Likely, this table and the following function should be
- *        obtained and derived from the OF Device Tree.
- */
-static u_char mpc85xx_ads_openpic_initsenses[] __initdata = {
-       MPC85XX_INTERNAL_IRQ_SENSES,
-       0x0,                    /* External  0: */
-#if defined(CONFIG_PCI)
-       (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE),      /* Ext 1: PCI slot 0 */
-       (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE),      /* Ext 2: PCI slot 1 */
-       (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE),      /* Ext 3: PCI slot 2 */
-       (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE),      /* Ext 4: PCI slot 3 */
-#else
-       0x0,                    /* External  1: */
-       0x0,                    /* External  2: */
-       0x0,                    /* External  3: */
-       0x0,                    /* External  4: */
-#endif
-       (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE),      /* External 5: PHY */
-       0x0,                    /* External  6: */
-       (IRQ_SENSE_LEVEL | IRQ_POLARITY_NEGATIVE),      /* External 7: PHY */
-       0x0,                    /* External  8: */
-       0x0,                    /* External  9: */
-       0x0,                    /* External 10: */
-       0x0,                    /* External 11: */
-};
-
 #ifdef CONFIG_PCI
-/*
- * interrupt routing
- */
-
-int
-mpc85xx_map_irq(struct pci_dev *dev, unsigned char idsel, unsigned char pin)
-{
-       static char pci_irq_table[][4] =
-           /*
-            * This is little evil, but works around the fact
-            * that revA boards have IDSEL starting at 18
-            * and others boards (older) start at 12
-            *
-            *      PCI IDSEL/INTPIN->INTLINE
-            *       A      B      C      D
-            */
-       {
-               {PIRQA, PIRQB, PIRQC, PIRQD},   /* IDSEL 2 */
-               {PIRQD, PIRQA, PIRQB, PIRQC},
-               {PIRQC, PIRQD, PIRQA, PIRQB},
-               {PIRQB, PIRQC, PIRQD, PIRQA},   /* IDSEL 5 */
-               {0, 0, 0, 0},   /* -- */
-               {0, 0, 0, 0},   /* -- */
-               {0, 0, 0, 0},   /* -- */
-               {0, 0, 0, 0},   /* -- */
-               {0, 0, 0, 0},   /* -- */
-               {0, 0, 0, 0},   /* -- */
-               {PIRQA, PIRQB, PIRQC, PIRQD},   /* IDSEL 12 */
-               {PIRQD, PIRQA, PIRQB, PIRQC},
-               {PIRQC, PIRQD, PIRQA, PIRQB},
-               {PIRQB, PIRQC, PIRQD, PIRQA},   /* IDSEL 15 */
-               {0, 0, 0, 0},   /* -- */
-               {0, 0, 0, 0},   /* -- */
-               {PIRQA, PIRQB, PIRQC, PIRQD},   /* IDSEL 18 */
-               {PIRQD, PIRQA, PIRQB, PIRQC},
-               {PIRQC, PIRQD, PIRQA, PIRQB},
-               {PIRQB, PIRQC, PIRQD, PIRQA},   /* IDSEL 21 */
-       };
-
-       const long min_idsel = 2, max_idsel = 21, irqs_per_slot = 4;
-       return PCI_IRQ_TABLE_LOOKUP;
-}
-
 int
 mpc85xx_exclude_device(u_char bus, u_char devfn)
 {
@@ -119,44 +47,63 @@ mpc85xx_exclude_device(u_char bus, u_char devfn)
                return PCIBIOS_SUCCESSFUL;
 }
 
+void __init
+mpc85xx_pcibios_fixup(void)
+{
+       struct pci_dev *dev = NULL;
+
+       for_each_pci_dev(dev)
+               pci_read_irq_line(dev);
+}
 #endif /* CONFIG_PCI */
 
 
 void __init mpc85xx_ads_pic_init(void)
 {
-       struct mpic *mpic1;
-       phys_addr_t OpenPIC_PAddr;
-
-       /* Determine the Physical Address of the OpenPIC regs */
-       OpenPIC_PAddr = get_immrbase() + MPC85xx_OPENPIC_OFFSET;
-
-       mpic1 = mpic_alloc(OpenPIC_PAddr,
-                          MPIC_PRIMARY | MPIC_WANTS_RESET | MPIC_BIG_ENDIAN,
-                          4, MPC85xx_OPENPIC_IRQ_OFFSET, 0, 250,
-                          mpc85xx_ads_openpic_initsenses,
-                          sizeof(mpc85xx_ads_openpic_initsenses),
-                          " OpenPIC  ");
-       BUG_ON(mpic1 == NULL);
-       mpic_assign_isu(mpic1, 0, OpenPIC_PAddr + 0x10200);
-       mpic_assign_isu(mpic1, 1, OpenPIC_PAddr + 0x10280);
-       mpic_assign_isu(mpic1, 2, OpenPIC_PAddr + 0x10300);
-       mpic_assign_isu(mpic1, 3, OpenPIC_PAddr + 0x10380);
-       mpic_assign_isu(mpic1, 4, OpenPIC_PAddr + 0x10400);
-       mpic_assign_isu(mpic1, 5, OpenPIC_PAddr + 0x10480);
-       mpic_assign_isu(mpic1, 6, OpenPIC_PAddr + 0x10500);
-       mpic_assign_isu(mpic1, 7, OpenPIC_PAddr + 0x10580);
-
-       /* dummy mappings to get to 48 */
-       mpic_assign_isu(mpic1, 8, OpenPIC_PAddr + 0x10600);
-       mpic_assign_isu(mpic1, 9, OpenPIC_PAddr + 0x10680);
-       mpic_assign_isu(mpic1, 10, OpenPIC_PAddr + 0x10700);
-       mpic_assign_isu(mpic1, 11, OpenPIC_PAddr + 0x10780);
-
-       /* External ints */
-       mpic_assign_isu(mpic1, 12, OpenPIC_PAddr + 0x10000);
-       mpic_assign_isu(mpic1, 13, OpenPIC_PAddr + 0x10080);
-       mpic_assign_isu(mpic1, 14, OpenPIC_PAddr + 0x10100);
-       mpic_init(mpic1);
+       struct mpic *mpic;
+       struct resource r;
+       struct device_node *np = NULL;
+
+       np = of_find_node_by_type(np, "open-pic");
+
+       if (np == NULL) {
+               printk(KERN_ERR "Could not find open-pic node\n");
+               return;
+       }
+
+       if(of_address_to_resource(np, 0, &r)) {
+               printk(KERN_ERR "Could not map mpic register space\n");
+               of_node_put(np);
+               return;
+       }
+
+       mpic = mpic_alloc(np, r.start,
+                       MPIC_PRIMARY | MPIC_WANTS_RESET | MPIC_BIG_ENDIAN,
+                       4, 0, " OpenPIC  ");
+       BUG_ON(mpic == NULL);
+       of_node_put(np);
+
+       mpic_assign_isu(mpic, 0, r.start + 0x10200);
+       mpic_assign_isu(mpic, 1, r.start + 0x10280);
+       mpic_assign_isu(mpic, 2, r.start + 0x10300);
+       mpic_assign_isu(mpic, 3, r.start + 0x10380);
+       mpic_assign_isu(mpic, 4, r.start + 0x10400);
+       mpic_assign_isu(mpic, 5, r.start + 0x10480);
+       mpic_assign_isu(mpic, 6, r.start + 0x10500);
+       mpic_assign_isu(mpic, 7, r.start + 0x10580);
+
+       /* Unused on this platform (leave room for 8548) */
+       mpic_assign_isu(mpic, 8, r.start + 0x10600);
+       mpic_assign_isu(mpic, 9, r.start + 0x10680);
+       mpic_assign_isu(mpic, 10, r.start + 0x10700);
+       mpic_assign_isu(mpic, 11, r.start + 0x10780);
+
+       /* External Interrupts */
+       mpic_assign_isu(mpic, 12, r.start + 0x10000);
+       mpic_assign_isu(mpic, 13, r.start + 0x10080);
+       mpic_assign_isu(mpic, 14, r.start + 0x10100);
+
+       mpic_init(mpic);
 }
 
 /*
@@ -165,7 +112,9 @@ void __init mpc85xx_ads_pic_init(void)
 static void __init mpc85xx_ads_setup_arch(void)
 {
        struct device_node *cpu;
+#ifdef CONFIG_PCI
        struct device_node *np;
+#endif
 
        if (ppc_md.progress)
                ppc_md.progress("mpc85xx_ads_setup_arch()", 0);
@@ -186,8 +135,7 @@ static void __init mpc85xx_ads_setup_arch(void)
        for (np = NULL; (np = of_find_node_by_type(np, "pci")) != NULL;)
                add_bridge(np);
 
-       ppc_md.pci_swizzle = common_swizzle;
-       ppc_md.pci_map_irq = mpc85xx_map_irq;
+       ppc_md.pcibios_fixup = mpc85xx_pcibios_fixup;
        ppc_md.pci_exclude_device = mpc85xx_exclude_device;
 #endif