[PATCH] uml: line_setup interface change

line_setup is changed to return the device which it set up, rather than just
success or failure.  This will be important in the line-config patch.

Signed-off-by: Jeff Dike <jdike@addtoit.com>
Cc: Paolo 'Blaisorblade' Giarrusso <blaisorblade@yahoo.it>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

diff --git a/arch/um/drivers/line.c b/arch/um/drivers/line.c
index 1c2cc5d..1352a21 100644 (file)
--- a/arch/um/drivers/line.c
+++ b/arch/um/drivers/line.c
@@ -555,12 +555,13 @@ int line_setup(struct line *lines, unsigned int num, char *init)
                        }
                }
        }
-       return 1;
+       return n == -1 ? num : n;
 }
 
 int line_config(struct line *lines, unsigned int num, char *str)
 {
        char *new;
+       int n;
 
        if(*str == '='){
                printk("line_config - can't configure all devices from "
@@ -573,7 +574,8 @@ int line_config(struct line *lines, unsigned int num, char *str)
                printk("line_config - kstrdup failed\n");
                return -ENOMEM;
        }
-       return !line_setup(lines, num, new);
+       n = line_setup(lines, num, new);
+       return n < 0 ? n : 0;
 }
 
 int line_get_config(char *name, struct line *lines, unsigned int num, char *str,
@@ -624,10 +626,14 @@ int line_id(char **str, int *start_out, int *end_out)
 
 int line_remove(struct line *lines, unsigned int num, int n)
 {
+       int err;
        char config[sizeof("conxxxx=none\0")];
 
        sprintf(config, "%d=none", n);
-       return !line_setup(lines, num, config);
+       err = line_setup(lines, num, config);
+       if(err >= 0)
+               err = 0;
+       return err;
 }
 
 struct tty_driver *line_register_devfs(struct lines *set,