Blackfin: clean up isp1362 board resources

Drop the CONFIG_USB_ISP1362_BFIN_GPIO_IRQ Kconfig as it never made it into
mainline and it was a bad interface into the board resources.  For boards
that actually used this, replace it with an actual IRQ define.  For boards
that didn't, simply drop the resources.

Signed-off-by: Mike Frysinger <vapier@gentoo.org>

diff --git a/arch/blackfin/mach-bf527/boards/cm_bf527.c b/arch/blackfin/mach-bf527/boards/cm_bf527.c
index f1996b1..40b9934 100644 (file)
--- a/arch/blackfin/mach-bf527/boards/cm_bf527.c
+++ b/arch/blackfin/mach-bf527/boards/cm_bf527.c
@@ -15,9 +15,6 @@
 #include <linux/spi/spi.h>
 #include <linux/spi/flash.h>
 #include <linux/etherdevice.h>
-#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
-#include <linux/usb/isp1362.h>
-#endif
 #include <linux/i2c.h>
 #include <linux/irq.h>
 #include <linux/interrupt.h>
@@ -317,45 +314,6 @@ static struct platform_device sl811_hcd_device = {
 };
 #endif
 
-#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
-static struct resource isp1362_hcd_resources[] = {
-       {
-               .start = 0x20360000,
-               .end = 0x20360000,
-               .flags = IORESOURCE_MEM,
-       }, {
-               .start = 0x20360004,
-               .end = 0x20360004,
-               .flags = IORESOURCE_MEM,
-       }, {
-               .start = CONFIG_USB_ISP1362_BFIN_GPIO_IRQ,
-               .end = CONFIG_USB_ISP1362_BFIN_GPIO_IRQ,
-               .flags = IORESOURCE_IRQ | IORESOURCE_IRQ_HIGHLEVEL,
-       },
-};
-
-static struct isp1362_platform_data isp1362_priv = {
-       .sel15Kres = 1,
-       .clknotstop = 0,
-       .oc_enable = 0,
-       .int_act_high = 0,
-       .int_edge_triggered = 0,
-       .remote_wakeup_connected = 0,
-       .no_power_switching = 1,
-       .power_switching_mode = 0,
-};
-
-static struct platform_device isp1362_hcd_device = {
-       .name = "isp1362-hcd",
-       .id = 0,
-       .dev = {
-               .platform_data = &isp1362_priv,
-       },
-       .num_resources = ARRAY_SIZE(isp1362_hcd_resources),
-       .resource = isp1362_hcd_resources,
-};
-#endif
-
 #if defined(CONFIG_BFIN_MAC) || defined(CONFIG_BFIN_MAC_MODULE)
 static struct platform_device bfin_mii_bus = {
        .name = "bfin_mii_bus",
@@ -841,10 +799,6 @@ static struct platform_device *cmbf527_devices[] __initdata = {
        &sl811_hcd_device,
 #endif
 
-#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
-       &isp1362_hcd_device,
-#endif
-
 #if defined(CONFIG_USB_ISP1760_HCD) || defined(CONFIG_USB_ISP1760_HCD_MODULE)
        &bfin_isp1760_device,
 #endif

diff --git a/arch/blackfin/mach-bf527/boards/ezkit.c b/arch/blackfin/mach-bf527/boards/ezkit.c
index 45db07b..6ffbefc 100644 (file)
--- a/arch/blackfin/mach-bf527/boards/ezkit.c
+++ b/arch/blackfin/mach-bf527/boards/ezkit.c
@@ -13,9 +13,6 @@
 #include <linux/mtd/physmap.h>
 #include <linux/spi/spi.h>
 #include <linux/spi/flash.h>
-#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
-#include <linux/usb/isp1362.h>
-#endif
 #include <linux/i2c.h>
 #include <linux/irq.h>
 #include <linux/interrupt.h>
@@ -373,45 +370,6 @@ static struct platform_device sl811_hcd_device = {
 };
 #endif
 
-#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
-static struct resource isp1362_hcd_resources[] = {
-       {
-               .start = 0x20360000,
-               .end = 0x20360000,
-               .flags = IORESOURCE_MEM,
-       }, {
-               .start = 0x20360004,
-               .end = 0x20360004,
-               .flags = IORESOURCE_MEM,
-       }, {
-               .start = CONFIG_USB_ISP1362_BFIN_GPIO_IRQ,
-               .end = CONFIG_USB_ISP1362_BFIN_GPIO_IRQ,
-               .flags = IORESOURCE_IRQ | IORESOURCE_IRQ_HIGHLEVEL,
-       },
-};
-
-static struct isp1362_platform_data isp1362_priv = {
-       .sel15Kres = 1,
-       .clknotstop = 0,
-       .oc_enable = 0,
-       .int_act_high = 0,
-       .int_edge_triggered = 0,
-       .remote_wakeup_connected = 0,
-       .no_power_switching = 1,
-       .power_switching_mode = 0,
-};
-
-static struct platform_device isp1362_hcd_device = {
-       .name = "isp1362-hcd",
-       .id = 0,
-       .dev = {
-               .platform_data = &isp1362_priv,
-       },
-       .num_resources = ARRAY_SIZE(isp1362_hcd_resources),
-       .resource = isp1362_hcd_resources,
-};
-#endif
-
 #if defined(CONFIG_BFIN_MAC) || defined(CONFIG_BFIN_MAC_MODULE)
 static struct platform_device bfin_mii_bus = {
        .name = "bfin_mii_bus",
@@ -918,10 +876,6 @@ static struct platform_device *stamp_devices[] __initdata = {
        &sl811_hcd_device,
 #endif
 
-#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
-       &isp1362_hcd_device,
-#endif
-
 #if defined(CONFIG_USB_ISP1760_HCD) || defined(CONFIG_USB_ISP1760_HCD_MODULE)
        &bfin_isp1760_device,
 #endif

diff --git a/arch/blackfin/mach-bf537/boards/pnav10.c b/arch/blackfin/mach-bf537/boards/pnav10.c
index 9ba2904..4e0afda 100644 (file)
--- a/arch/blackfin/mach-bf537/boards/pnav10.c
+++ b/arch/blackfin/mach-bf537/boards/pnav10.c
@@ -13,9 +13,6 @@
 #include <linux/mtd/partitions.h>
 #include <linux/spi/spi.h>
 #include <linux/spi/flash.h>
-#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
-#include <linux/usb/isp1362.h>
-#endif
 #include <linux/irq.h>
 #include <asm/dma.h>
 #include <asm/bfin5xx_spi.h>
@@ -147,45 +144,6 @@ static struct platform_device sl811_hcd_device = {
 };
 #endif
 
-#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
-static struct resource isp1362_hcd_resources[] = {
-       {
-               .start = 0x20360000,
-               .end = 0x20360000,
-               .flags = IORESOURCE_MEM,
-       }, {
-               .start = 0x20360004,
-               .end = 0x20360004,
-               .flags = IORESOURCE_MEM,
-       }, {
-               .start = CONFIG_USB_ISP1362_BFIN_GPIO_IRQ,
-               .end = CONFIG_USB_ISP1362_BFIN_GPIO_IRQ,
-               .flags = IORESOURCE_IRQ | IORESOURCE_IRQ_HIGHLEVEL,
-       },
-};
-
-static struct isp1362_platform_data isp1362_priv = {
-       .sel15Kres = 1,
-       .clknotstop = 0,
-       .oc_enable = 0,
-       .int_act_high = 0,
-       .int_edge_triggered = 0,
-       .remote_wakeup_connected = 0,
-       .no_power_switching = 1,
-       .power_switching_mode = 0,
-};
-
-static struct platform_device isp1362_hcd_device = {
-       .name = "isp1362-hcd",
-       .id = 0,
-       .dev = {
-               .platform_data = &isp1362_priv,
-       },
-       .num_resources = ARRAY_SIZE(isp1362_hcd_resources),
-       .resource = isp1362_hcd_resources,
-};
-#endif
-
 #if defined(CONFIG_BFIN_MAC) || defined(CONFIG_BFIN_MAC_MODULE)
 static struct platform_device bfin_mii_bus = {
        .name = "bfin_mii_bus",
@@ -492,10 +450,6 @@ static struct platform_device *stamp_devices[] __initdata = {
        &sl811_hcd_device,
 #endif
 
-#if defined(CONFIG_USB_ISP1362_HCD) || defined(CONFIG_USB_ISP1362_HCD_MODULE)
-       &isp1362_hcd_device,
-#endif
-
 #if defined(CONFIG_SMC91X) || defined(CONFIG_SMC91X_MODULE)
        &smc91x_device,
 #endif

diff --git a/arch/blackfin/mach-bf537/boards/stamp.c b/arch/blackfin/mach-bf537/boards/stamp.c
index 6a09b71..514d994 100644 (file)
--- a/arch/blackfin/mach-bf537/boards/stamp.c
+++ b/arch/blackfin/mach-bf537/boards/stamp.c
@@ -272,8 +272,8 @@ static struct resource isp1362_hcd_resources[] = {
                .end = 0x20360004,
                .flags = IORESOURCE_MEM,
        }, {
-               .start = CONFIG_USB_ISP1362_BFIN_GPIO_IRQ,
-               .end = CONFIG_USB_ISP1362_BFIN_GPIO_IRQ,
+               .start = IRQ_PF3,
+               .end = IRQ_PF3,
                .flags = IORESOURCE_IRQ | IORESOURCE_IRQ_HIGHLEVEL,
        },
 };