fs/Kconfig: move bfs out

Signed-off-by: Alexey Dobriyan <adobriyan@gmail.com>

diff --git a/fs/Kconfig b/fs/Kconfig
index cfddc0a..9acf3a2 100644 (file)
--- a/fs/Kconfig
+++ b/fs/Kconfig
@@ -207,28 +207,7 @@ source "fs/ecryptfs/Kconfig"
 source "fs/hfs/Kconfig"
 source "fs/hfsplus/Kconfig"
 source "fs/befs/Kconfig"
-
-config BFS_FS
-       tristate "BFS file system support (EXPERIMENTAL)"
-       depends on BLOCK && EXPERIMENTAL
-       help
-         Boot File System (BFS) is a file system used under SCO UnixWare to
-         allow the bootloader access to the kernel image and other important
-         files during the boot process.  It is usually mounted under /stand
-         and corresponds to the slice marked as "STAND" in the UnixWare
-         partition.  You should say Y if you want to read or write the files
-         on your /stand slice from within Linux.  You then also need to say Y
-         to "UnixWare slices support", below.  More information about the BFS
-         file system is contained in the file
-         <file:Documentation/filesystems/bfs.txt>.
-
-         If you don't know what this is about, say N.
-
-         To compile this as a module, choose M here: the module will be called
-         bfs.  Note that the file system of your root partition (the one
-         containing the directory /) cannot be compiled as a module.
-
-
+source "fs/bfs/Kconfig"
 
 config EFS_FS
        tristate "EFS file system support (read only) (EXPERIMENTAL)"

diff --git a/fs/bfs/Kconfig b/fs/bfs/Kconfig
new file mode 100644 (file)
index 0000000..c2336c6
--- /dev/null
+++ b/fs/bfs/Kconfig
@@ -0,0 +1,19 @@
+config BFS_FS
+       tristate "BFS file system support (EXPERIMENTAL)"
+       depends on BLOCK && EXPERIMENTAL
+       help
+         Boot File System (BFS) is a file system used under SCO UnixWare to
+         allow the bootloader access to the kernel image and other important
+         files during the boot process.  It is usually mounted under /stand
+         and corresponds to the slice marked as "STAND" in the UnixWare
+         partition.  You should say Y if you want to read or write the files
+         on your /stand slice from within Linux.  You then also need to say Y
+         to "UnixWare slices support", below.  More information about the BFS
+         file system is contained in the file
+         <file:Documentation/filesystems/bfs.txt>.
+
+         If you don't know what this is about, say N.
+
+         To compile this as a module, choose M here: the module will be called
+         bfs.  Note that the file system of your root partition (the one
+         containing the directory /) cannot be compiled as a module.