qlge: bugfix: Pad outbound frames smaller than 60 bytes.
[safe/jmp/linux-2.6] / drivers / block / cciss.h
1 #ifndef CCISS_H
2 #define CCISS_H
3
4 #include <linux/genhd.h>
5
6 #include "cciss_cmd.h"
7
8
9 #define NWD_SHIFT       4
10 #define MAX_PART        (1 << NWD_SHIFT)
11
12 #define IO_OK           0
13 #define IO_ERROR        1
14
15 struct ctlr_info;
16 typedef struct ctlr_info ctlr_info_t;
17
18 struct access_method {
19         void (*submit_command)(ctlr_info_t *h, CommandList_struct *c);
20         void (*set_intr_mask)(ctlr_info_t *h, unsigned long val);
21         unsigned long (*fifo_full)(ctlr_info_t *h);
22         unsigned long (*intr_pending)(ctlr_info_t *h);
23         unsigned long (*command_completed)(ctlr_info_t *h);
24 };
25 typedef struct _drive_info_struct
26 {
27         __u32   LunID;  
28         int     usage_count;
29         struct request_queue *queue;
30         sector_t nr_blocks;
31         int     block_size;
32         int     heads;
33         int     sectors;
34         int     cylinders;
35         int     raid_level; /* set to -1 to indicate that
36                              * the drive is not in use/configured
37                             */
38         int     busy_configuring; /*This is set when the drive is being removed
39                                    *to prevent it from being opened or it's queue
40                                    *from being started.
41                                   */
42         __u8 serial_no[16]; /* from inquiry page 0x83, */
43                             /* not necc. null terminated. */
44 } drive_info_struct;
45
46 #ifdef CONFIG_CISS_SCSI_TAPE
47
48 struct sendcmd_reject_list {
49         int ncompletions;
50         unsigned long *complete; /* array of NR_CMDS tags */
51 };
52
53 #endif
54 struct ctlr_info 
55 {
56         int     ctlr;
57         char    devname[8];
58         char    *product_name;
59         char    firm_ver[4]; // Firmware version 
60         struct pci_dev *pdev;
61         __u32   board_id;
62         void __iomem *vaddr;
63         unsigned long paddr;
64         int     nr_cmds; /* Number of commands allowed on this controller */
65         CfgTable_struct __iomem *cfgtable;
66         int     interrupts_enabled;
67         int     major;
68         int     max_commands;
69         int     commands_outstanding;
70         int     max_outstanding; /* Debug */ 
71         int     num_luns;
72         int     highest_lun;
73         int     usage_count;  /* number of opens all all minor devices */
74 #       define DOORBELL_INT     0
75 #       define PERF_MODE_INT    1
76 #       define SIMPLE_MODE_INT  2
77 #       define MEMQ_MODE_INT    3
78         unsigned int intr[4];
79         unsigned int msix_vector;
80         unsigned int msi_vector;
81         int     cciss_max_sectors;
82         BYTE    cciss_read;
83         BYTE    cciss_write;
84         BYTE    cciss_read_capacity;
85
86         // information about each logical volume
87         drive_info_struct drv[CISS_MAX_LUN];
88
89         struct access_method access;
90
91         /* queue and queue Info */ 
92         struct hlist_head reqQ;
93         struct hlist_head cmpQ;
94         unsigned int Qdepth;
95         unsigned int maxQsinceinit;
96         unsigned int maxSG;
97         spinlock_t lock;
98
99         //* pointers to command and error info pool */ 
100         CommandList_struct      *cmd_pool;
101         dma_addr_t              cmd_pool_dhandle; 
102         ErrorInfo_struct        *errinfo_pool;
103         dma_addr_t              errinfo_pool_dhandle; 
104         unsigned long           *cmd_pool_bits;
105         int                     nr_allocs;
106         int                     nr_frees; 
107         int                     busy_configuring;
108         int                     busy_initializing;
109
110         /* This element holds the zero based queue number of the last
111          * queue to be started.  It is used for fairness.
112         */
113         int                     next_to_run;
114
115         // Disk structures we need to pass back
116         struct gendisk   *gendisk[CISS_MAX_LUN];
117 #ifdef CONFIG_CISS_SCSI_TAPE
118         void *scsi_ctlr; /* ptr to structure containing scsi related stuff */
119         /* list of block side commands the scsi error handling sucked up */
120         /* and saved for later processing */
121         struct sendcmd_reject_list scsi_rejects;
122 #endif
123         unsigned char alive;
124 };
125
126 /*  Defining the diffent access_menthods */
127 /*
128  * Memory mapped FIFO interface (SMART 53xx cards)
129  */
130 #define SA5_DOORBELL    0x20
131 #define SA5_REQUEST_PORT_OFFSET 0x40
132 #define SA5_REPLY_INTR_MASK_OFFSET      0x34
133 #define SA5_REPLY_PORT_OFFSET           0x44
134 #define SA5_INTR_STATUS         0x30
135 #define SA5_SCRATCHPAD_OFFSET   0xB0
136
137 #define SA5_CTCFG_OFFSET        0xB4
138 #define SA5_CTMEM_OFFSET        0xB8
139
140 #define SA5_INTR_OFF            0x08
141 #define SA5B_INTR_OFF           0x04
142 #define SA5_INTR_PENDING        0x08
143 #define SA5B_INTR_PENDING       0x04
144 #define FIFO_EMPTY              0xffffffff      
145 #define CCISS_FIRMWARE_READY    0xffff0000 /* value in scratchpad register */
146
147 #define  CISS_ERROR_BIT         0x02
148
149 #define CCISS_INTR_ON   1 
150 #define CCISS_INTR_OFF  0
151 /* 
152         Send the command to the hardware 
153 */
154 static void SA5_submit_command( ctlr_info_t *h, CommandList_struct *c) 
155 {
156 #ifdef CCISS_DEBUG
157          printk("Sending %x - down to controller\n", c->busaddr );
158 #endif /* CCISS_DEBUG */ 
159          writel(c->busaddr, h->vaddr + SA5_REQUEST_PORT_OFFSET);
160          h->commands_outstanding++;
161          if ( h->commands_outstanding > h->max_outstanding)
162                 h->max_outstanding = h->commands_outstanding;
163 }
164
165 /*  
166  *  This card is the opposite of the other cards.  
167  *   0 turns interrupts on... 
168  *   0x08 turns them off... 
169  */
170 static void SA5_intr_mask(ctlr_info_t *h, unsigned long val)
171 {
172         if (val) 
173         { /* Turn interrupts on */
174                 h->interrupts_enabled = 1;
175                 writel(0, h->vaddr + SA5_REPLY_INTR_MASK_OFFSET);
176         } else /* Turn them off */
177         {
178                 h->interrupts_enabled = 0;
179                 writel( SA5_INTR_OFF, 
180                         h->vaddr + SA5_REPLY_INTR_MASK_OFFSET);
181         }
182 }
183 /*
184  *  This card is the opposite of the other cards.
185  *   0 turns interrupts on...
186  *   0x04 turns them off...
187  */
188 static void SA5B_intr_mask(ctlr_info_t *h, unsigned long val)
189 {
190         if (val)
191         { /* Turn interrupts on */
192                 h->interrupts_enabled = 1;
193                 writel(0, h->vaddr + SA5_REPLY_INTR_MASK_OFFSET);
194         } else /* Turn them off */
195         {
196                 h->interrupts_enabled = 0;
197                 writel( SA5B_INTR_OFF,
198                         h->vaddr + SA5_REPLY_INTR_MASK_OFFSET);
199         }
200 }
201 /*
202  *  Returns true if fifo is full.  
203  * 
204  */ 
205 static unsigned long SA5_fifo_full(ctlr_info_t *h)
206 {
207         if( h->commands_outstanding >= h->max_commands)
208                 return(1);
209         else 
210                 return(0);
211
212 }
213 /* 
214  *   returns value read from hardware. 
215  *     returns FIFO_EMPTY if there is nothing to read 
216  */ 
217 static unsigned long SA5_completed(ctlr_info_t *h)
218 {
219         unsigned long register_value 
220                 = readl(h->vaddr + SA5_REPLY_PORT_OFFSET);
221         if(register_value != FIFO_EMPTY)
222         {
223                 h->commands_outstanding--;
224 #ifdef CCISS_DEBUG
225                 printk("cciss:  Read %lx back from board\n", register_value);
226 #endif /* CCISS_DEBUG */ 
227         } 
228 #ifdef CCISS_DEBUG
229         else
230         {
231                 printk("cciss:  FIFO Empty read\n");
232         }
233 #endif 
234         return ( register_value); 
235
236 }
237 /*
238  *      Returns true if an interrupt is pending.. 
239  */
240 static unsigned long SA5_intr_pending(ctlr_info_t *h)
241 {
242         unsigned long register_value  = 
243                 readl(h->vaddr + SA5_INTR_STATUS);
244 #ifdef CCISS_DEBUG
245         printk("cciss: intr_pending %lx\n", register_value);
246 #endif  /* CCISS_DEBUG */
247         if( register_value &  SA5_INTR_PENDING) 
248                 return  1;      
249         return 0 ;
250 }
251
252 /*
253  *      Returns true if an interrupt is pending..
254  */
255 static unsigned long SA5B_intr_pending(ctlr_info_t *h)
256 {
257         unsigned long register_value  =
258                 readl(h->vaddr + SA5_INTR_STATUS);
259 #ifdef CCISS_DEBUG
260         printk("cciss: intr_pending %lx\n", register_value);
261 #endif  /* CCISS_DEBUG */
262         if( register_value &  SA5B_INTR_PENDING)
263                 return  1;
264         return 0 ;
265 }
266
267
268 static struct access_method SA5_access = {
269         SA5_submit_command,
270         SA5_intr_mask,
271         SA5_fifo_full,
272         SA5_intr_pending,
273         SA5_completed,
274 };
275
276 static struct access_method SA5B_access = {
277         SA5_submit_command,
278         SA5B_intr_mask,
279         SA5_fifo_full,
280         SA5B_intr_pending,
281         SA5_completed,
282 };
283
284 struct board_type {
285         __u32   board_id;
286         char    *product_name;
287         struct access_method *access;
288         int nr_cmds; /* Max cmds this kind of ctlr can handle. */
289 };
290
291 #define CCISS_LOCK(i)   (&hba[i]->lock)
292
293 #endif /* CCISS_H */
294