Merge branch 'for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/dtor/input
[safe/jmp/linux-2.6] / arch / arm / mach-omap2 /
2009-06-09 Santosh ShilimkarARM: OMAP4: SMP: Enable SMP support for OMAP4430
2009-06-09 Santosh ShilimkarARM: OMAP4: SMP: Add mpu timer support for OMAP4430
2009-06-09 Santosh ShilimkarARM: OMAP4: SMP: Add OMAP4430 SMP board files
2009-05-29 Russell KingMerge branch 'for-next' of git://git./linux/kernel...
2009-05-29 Russell KingMerge branch 'for-next' of git://git./linux/kernel...
2009-05-28 Tony LindgrenMerge branch 'omap4' into for-next
2009-05-28 Tony LindgrenMerge branch 'omap3-boards' into for-next
2009-05-28 Tony LindgrenMerge branch 'omap3-upstream' into for-next
2009-05-28 Tony LindgrenMerge branch 'omap-upstream' into for-next
2009-05-28 Santosh ShilimkarARM: OMAP4: Add support for 4430 SDP
2009-05-28 Santosh ShilimkarARM: OMAP4: Add minimal support for omap4
2009-05-28 Grazvydas IgnotasARM: OMAP3: pandora: add support for mode devices
2009-05-28 Syed Mohammed KhasimARM: OMAP3: Add omap3 EVM support
2009-05-28 Vikram PanditaARM: OMAP3: Add support for OMAP3 Zoom2 board
2009-05-28 Adrian HunterARM: OMAP3: RX51: Connect VAUX3 to MMC2
2009-05-28 Grazvydas IgnotasARM: OMAP3: pandora: setup regulator framework for MMC
2009-05-28 David BrownellARM: OMAP3: Initialize regulators for Beagle and Overo
2009-05-28 David BrownellARM: OMAP3: mmc-twl4030 uses regulator framework
2009-05-28 Tony LindgrenARM: OMAP3: Initialize more devices for LDP
2009-05-28 Imre DeakARM: OMAP3: ZOOM MDK: Add FB support to board file
2009-05-28 Paul WalmsleyARM: OMAP3: SDRC: add timing data for Qimonda HYB18M512...
2009-05-28 Paul WalmsleyARM: OMAP3: SDRC: add timing data for Micron MT46H32M32...
2009-05-28 Vikram PanditaARM: OMAP2/3: Serial: Remove arch_initcall dependency
2009-05-28 Imre DeakARM: OMAP2: 2430SDP: Add FB support to board file
2009-05-28 Tony LindgrenARM: OMAP2/3: Add generic smc91x support when connected...
2009-05-28 Juha YrjolaARM: OMAP2/3: Add generic onenand support when connecte...
2009-05-28 Kevin HilmanOMAP3: PM: prevent module wakeups from waking IVA2
2009-05-28 Kevin HilmanOMAP3: PM: Clear pending PRCM reset flags on init
2009-05-28 Kevin HilmanOMAP3: PM: Ensure PRCM interrupts are cleared at boot
2009-05-28 Peter 'p2' De Schr... OMAP3: PM: Ensure MUSB block can idle when driver not...
2009-05-28 Kevin HilmanOMAP3: PM: D2D clockdomain supports SW supervised trans...
2009-05-28 Kevin HilmanOMAP3: PM: Add D2D clocks and auto-idle setup to PRCM...
2009-05-28 Jouni HoganderOMAP: UART: Add sysfs interface for adjusting UART...
2009-05-28 Kevin HilmanOMAP3: PM: UART: disable clocks when idle and off-mode...
2009-05-28 Kevin HilmanOMAP3: PM: Force IVA2 into idle during bootup
2009-05-28 Jouni HoganderOMAP: Add new function to check wether there is irq...
2009-05-28 Kevin HilmanOMAP2/3: PM: push core PM code from linux-omap
2009-05-26 Kevin HilmanRevert "ARM: OMAP: Mask interrupts when disabling inter...
2009-05-26 Tony LindgrenMerge branch 'omap-clock-upstream' of git://git.pwsan...
2009-05-25 Tony LindgrenARM: OMAP2/3: Reorganize Makefile to add omap4 support
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP_CM_REGADDR
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP_PRM_REGADDR and OMAP2_PRM_BASE
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP2_32KSYNCT_BASE
2009-05-25 Tony LindgrenARM: OMAP2/3: Reorganize Makefile to add omap4 support
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP_CM_REGADDR
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP_PRM_REGADDR and OMAP2_PRM_BASE
2009-05-25 Tony LindgrenARM: OMAP2/3: Remove OMAP2_32KSYNCT_BASE
2009-05-25 Russell KingMerge branch 'iommu' of git://git./linux/kernel/git...
2009-05-22 Hiroshi DOYUomap iommu: add MPU_BRIDGE_IOMMU for tidspbridge migration
2009-05-22 Hiroshi DOYUomap2 iommu: entries for Kconfig and Makefile
2009-05-19 Hiroshi DOYUomap iommu: omap3 iommu device registration
2009-05-16 Tony LindgrenARM: OMAP2/3: Change omapfb to use clkdev for dispc...
2009-05-16 Kalle JokiniemiARM: OMAP3: Fix HW SAVEANDRESTORE shift define
2009-05-12 Paul WalmsleyOMAP2xxx clock: rename clk_init_one() to clk_preinit()
2009-05-12 Artem BityutskiyOMAP3 clock: lessen amount of noisy messages
2009-05-12 Paul WalmsleyOMAP3 clock: use pr_debug() rather than pr_info() in...
2009-05-12 Paul WalmsleyOMAP3 clock: only unlock SDRC DLL if SDRC clk < 83MHz
2009-05-12 Paul WalmsleyOMAP3 SRAM: renumber registers to make space for argume...
2009-05-12 Paul WalmsleyOMAP3 SDRC: initialize SDRC_POWER at boot
2009-05-12 Paul WalmsleyOMAP3 SRAM: clear the SDRC PWRENA bit during SDRC frequ...
2009-05-12 Paul WalmsleyOMAP3 clock: add interconnect barriers to CORE DPLL...
2009-05-12 Paul WalmsleyOMAP3 SRAM: add ARM barriers to omap3_sram_configure_co...
2009-05-12 Tony LindgrenARM: OMAP2/3: Add name for musb clocks
2009-05-12 Jarkko NikulaARM: OMAP2: Fix SPI driver failure on 2420 when running...
2009-05-12 Jarkko NikulaARM: OMAP2: Fix tusb6010 init error and compilation...
2009-05-12 Paul WalmsleyARM: OMAP: GPIO de-bounce clocks don't affect module...
2009-05-05 Hiroshi DOYUomap iommu: omap2 architecture specific functions
2009-04-24 Tony LindgrenMerge branch 'omap-clock-fixes' into omap-fixes
2009-04-24 Paul WalmsleyOMAP2/3 GPTIMER: allow system tick GPTIMER to be change...
2009-04-24 Sergio AguirreOMAP3: clock: Camera module doesn't have IDLEST bit
2009-04-24 Paul WalmsleyOMAP2xxx clock: fix broken cpu_mask code
2009-04-23 Roger QuadrosARM: OMAP3: Clean up spurious interrupt check logic
2009-04-23 Huang WeiyiARM: OMAP3: remove duplicated #include
2009-04-23 Roel KluinARM: OMAP2: possible division by 0
2009-04-23 Jarkko NikulaARM: OMAP2: Remove defines and resource init for OMAP24...
2009-04-23 Tony LindgrenARM: OMAP: Remove old dead gpio expander code
2009-04-23 Paul WalmsleyOMAP2xxx clock: pre-initialize struct clks early
2009-04-21 Magnus Dammclocksource: pass clocksource to read() callback
2009-04-13 Yang HongyangReplace all DMA_nBIT_MASK macro with DMA_BIT_MASK(n)
2009-04-02 Russell KingMerge branch 'smsc911x-armplatforms' of git://github...
2009-04-02 Steve SakomanARM: Add SMSC911X support to Overo platform (V2)
2009-04-02 Steve Glendinningarm: convert omap ldp platform to use smsc911x
2009-04-01 Tony Lindgren[ARM] 5436/1: ARM: OMAP: Fix compile for rx51
2009-03-25 Tony Lindgren[ARM] OMAP: Fix compile for omap2_init_common_hw()
2009-03-25 Russell KingMerge branch 'for-next' of git://git./linux/kernel...
2009-03-25 Russell King[ARM] acorn,ebsa110,footbridge,integrator,sa1100: Conve...
2009-03-24 Alan Cox[ARM] twl4030 - leak fix
2009-03-24 Lauri LeukkunenARM OMAP3: Initial support for Nokia RX-51, v3
2009-03-24 Syed Mohammed KhasimARM: OMAP3: Add support for 3430 SDP, v4
2009-03-24 Steve SakomanARM: OMAP3: Add ADS7846 touchscreen support to Overo...
2009-03-24 Felipe BalbiARM: OMAP3: MUSB initialization for omap hw, v2
2009-03-24 Tony LindgrenARM: OMAP3: Add base address definitions and resources...
2009-03-24 Adrian HunterARM: OMAP3: mmc-twl4030 allow arbitrary slot names, v3
2009-03-24 Adrian HunterARM: OMAP3: mmc-twl4030 add cover switch
2009-03-24 David BrownellARM: OMAP3: mmc-twl4030 fix for vmmc = 0
2009-03-24 Grazvydas IgnotasARM: OMAP3: mmc-twl4030 add MMC3 support, v2
2009-03-24 David BrownellARM: OMAP3: mmc-twl4030 init passes device nodes back, v2
2009-03-24 David BrownellARM: OMAP3: mmc-twl4030 voltage cleanup
2009-03-24 Adrian HunterARM: OMAP3: mmc-twl4030 fix name buffer length, v2
2009-03-24 Tony LindgrenARM: OMAP3: Add more GPIO mux options
next