safe/jmp/linux-2.6
2010-04-16 Grazvydas Ignotaswl1251: add support for dedicated IRQ line
2010-04-16 Sujithath9k_htc: Fix sparse endian warnings
2010-04-16 Sujithath9k_htc: Handle WMI timeouts properly
2010-04-16 Sujithath9k_htc: Add dropped SKB count to debugfs
2010-04-16 Sujithath9k_htc: Remove GPIO set on unload
2010-04-16 Sujithath9k_hw: Use buffered register writes
2010-04-16 Sujithath9k_hw: Relocate Opmode initialization
2010-04-16 Sujithath9k_hw: Add macros for multiple register writes
2010-04-16 Sujithath9k_htc: Implement multiple register write support
2010-04-16 Sujithath: Add buffered register write operations
2010-04-16 Sujithath9k_htc: Cleanup beacon configuration
2010-04-16 Samuel Ortiziwmc3200wifi: check sparse endianness annotations
2010-04-16 Samuel Ortiziwmc3200wifi: Fix sparse warnings
2010-04-16 Benoit Papillaultath5k/ath9k: Fix 64 bits TSF reads
2010-04-16 Luis R. Rodriguezath9k_hw: add the PCI ID for the first AR9300 device
2010-04-16 Vasanthakumar... ath9k_hw: Abort rx if hw is not coming out of full...
2010-04-16 Vasanthakumar... ath9k: Enable TXOK and TXERR interrupts for TX EDMA
2010-04-16 Luis R. Rodriguezath9k: add LDPC support
2010-04-16 Luis R. Rodriguezath9k_hw: add LDPC support for AR9003
2010-04-16 Luis R. Rodriguezmac80211: add LDPC control flag
2010-04-16 Vasanthakumar... ath9k: Add Tx EDMA support
2010-04-16 Vasanthakumar... ath9k_hw: Compute pointer checksum over the link descriptor
2010-04-16 Vasanthakumar... ath9k: Initialize and configure tx status for EDMA
2010-04-16 Vasanthakumar... ath9k: Setup appropriate tx desc for regular dma and...
2010-04-16 Luis R. Rodriguezath9k_hw: set cwmin and cwmax to 0 for for AR9003 upon...
2010-04-16 Luis R. Rodriguezath9k_hw: enable CRC check of descriptors for AR9003
2010-04-16 Luis R. Rodriguezath9k: add RXLP and RXHP to debugfs counters
2010-04-16 Vasanthakumar... ath9k_hw: Fill descriptor abstrations for AR9003
2010-04-16 Luis R. Rodriguezath9k_hw: move AR9002 mac ops to its own file
2010-04-16 Vasanthakumar... ath9k_hw: Add function to configure tx status ring...
2010-04-16 Vasanthakumar... ath9k_hw: Define abstraction for tx desc access
2010-04-16 Vasanthakumar... ath9k: Load SW filtered NF values and start NF cal...
2010-04-16 Luis R. Rodriguezath9k_hw: skip WEP aggregation enable code for AR9003
2010-04-16 Luis R. Rodriguezath9k_hw: skip asynch fifo enablement to AR9003
2010-04-16 Felix Fietkauath9k_hw: Update ath9k_hw_set_dma for AR9300
2010-04-16 Luis R. Rodriguezath9k_hw: add TX/RX gain register initialization for...
2010-04-16 Luis R. Rodriguezath9k_hw: add the AR9300 SREV hw name print
2010-04-16 Vasanthakumar... ath9k_hw: Configure Tx interrupt mitigation timer
2010-04-16 Luis R. Rodriguezath9k_hw: move the RF claim stuff to AR9002 hardware...
2010-04-16 Felix Fietkauath9k_hw: move AR9280 PCI EEPROM fix to eeprom_def.c
2010-04-16 Vasanthakumar... ath9k_hw: Fill get_isr() for AR9003
2010-04-16 Luis R. Rodriguezath9k_hw: add OFDM spur mitigation for AR9003
2010-04-16 Senthil Balasubramanianath9k_hw: Implement AR9003 eeprom callbacks
2010-04-16 Luis R. Rodriguezath9k_hw: restore mac address reading logic
2010-04-16 Luis R. Rodriguezath9k_hw: rename eep_AR9287_ops to eep_ar9287_ops
2010-04-16 Luis R. Rodriguezath9k_hw: complete AR9003 calibration
2010-04-16 Luis R. Rodriguezath9k_hw: fill in the callbacks for calibration for...
2010-04-16 Luis R. Rodriguezath9k_hw: abstract loading noisefloor
2010-04-16 Luis R. Rodriguezath9k_hw: abstract the AR_PHY_AGC_CONTROL register...
2010-04-16 Vasanthakumar... ath9k_hw: Initialize interrupt mask for AR9003
2010-04-16 Vasanthakumar... ath9k_hw: Abstract the routine which returns interrupt...
2010-04-16 Luis R. Rodriguezath9k_hw: move TX/RX gain INI stuff to its own hardware...
2010-04-16 Luis R. Rodriguezath9k_hw: move the cck channel 14 INI to the AR9002...
2010-04-16 Luis R. Rodriguezath9k_hw: split the generic hardware code by hardware...
2010-04-16 Luis R. Rodriguezath9k_hw: add the config_pci_powersave AR9003 callback
2010-04-16 Luis R. Rodriguezath9k_hw: add the AR9003 ar9003_hw_init_cal callback
2010-04-16 Luis R. Rodriguezath9k_hw: split calib code by hardware families
2010-04-16 Luis R. Rodriguezath9k_hw: move the cal AR9100 calibration settings
2010-04-16 Luis R. Rodriguezath9k_hw: rename getNoiseFloorThresh() to ath9k_hw_loadnf()
2010-04-16 Luis R. Rodriguezath9k_hw: rename the PA calib routines to match their...
2010-04-16 Luis R. Rodriguezath9k_hw: simplify OLC temp compensation for AR9002
2010-04-16 Luis R. Rodriguezath9k_hw: move the AR9280 OLC temp comp to its own...
2010-04-16 Luis R. Rodriguezath9k_hw: shift code for AR9280 OLC temp comp
2010-04-16 Luis R. Rodriguezath9k_hw: rename PA calib for AR9287
2010-04-16 Luis R. Rodriguezath9k_hw: add a helper for the OLC tem compensation...
2010-04-16 Luis R. Rodriguezath9k_hw: add a helper for Power Amplifier calibration...
2010-04-16 Senthil Balasubramanianath9k_hw: the eep_map is used only for AR9280 PCI card...
2010-04-16 Felix Fietkauath9k_hw: Split out the function for reading the noise...
2010-04-16 Felix Fietkauath9k: Add Rx EDMA support
2010-04-16 Vasanthakumar... ath9k: Make bf_desc of ath_buf opaque
2010-04-16 Vasanthakumar... ath9k: Remove ATH9K_TX_SW_ABORTED and introduce a bool...
2010-04-16 Vasanthakumar... ath9k: Use memcpy in ath_clone_txbuf()
2010-04-16 Vasanthakumar... ath9k: Use abstraction to get link pointer
2010-04-16 Vasanthakumar... ath9k_hw: Add abstraction to set/get link pointer
2010-04-16 Vasanthakumar... ath9k_hw: Move code which populates ds_data to ath9k_hw
2010-04-16 Vasanthakumar... ath9k_hw: Define tx control struct for AR9003
2010-04-16 Luis R. Rodriguezath9k_hw: add all the AR9003 PHY callbacks
2010-04-16 Felix Fietkauath9k_hw: Split off ANI control to the PHY ops
2010-04-16 Luis R. Rodriguezath9k_hw: add helpers for processing the AR9003 INI
2010-04-16 Luis R. Rodriguezath9k_hw: add initvals for the AR9003 hardware family
2010-04-16 Luis R. Rodriguezath9k_hw: split initvals.h by hardware family
2010-04-16 Felix Fietkauath9k_hw: Implement spur mitigation on AR9003
2010-04-16 Felix Fietkauath9k_hw: Implement PLL control on AR9003
2010-04-16 Felix Fietkauath9k_hw: Set the channel on AR9003
2010-04-16 Luis R. Rodriguezath9k_hw: add common channel select helpers for ar900[23]
2010-04-16 Felix Fietkauath9k_hw: Add AR9003 PHY register definitions
2010-04-16 Senthil Balasubramanianath9k_hw: prevent reset control register zeroing on...
2010-04-16 Senthil Balasubramanianath9k_hw: update the chip tests for AR9003
2010-04-16 Vasanthakumar... ath9k_hw: Add few routines for rx edma support
2010-04-16 Vasanthakumar... ath9k_hw: Fill rx_enable() for the AR9003 hardware...
2010-04-16 Vasanthakumar... ath9k_hw: Add abstraction for rx enable
2010-04-16 Vasanthakumar... ath9k_hw: Fill few hw cap for edma
2010-04-16 Vasanthakumar... ath9k_hw: Add hw cap flag for EDMA for the AR9003 family
2010-04-16 Luis R. Rodriguezath9k: disable the MIB interrupt if ANI is disabled
2010-04-16 Luis R. Rodriguezath9k_hw: disable ANI for AR9003
2010-04-16 Luis R. Rodriguezath9k_hw: add the AR9003 ar9003_hw_macversion_supported()
2010-04-16 Luis R. Rodriguezath9k_hw: move init config and default after chip is up
2010-04-16 Luis R. Rodriguezath9k_hw: Add AR9003 PHY support
2010-04-16 Senthil Balasubramanianath9k_hw: Add the PCI IDs for AR9300 and fill up the...
2010-04-16 Luis R. Rodriguezath9k_hw: add a private callback for PLL control comput...
next