From 0a2fea2e0dea9df8ead1cb45e4b9cd68e1b1d29b Mon Sep 17 00:00:00 2001 From: Lothar Wassmann Date: Fri, 15 Jan 2010 14:42:02 -0500 Subject: [PATCH] USB: isp1362: fix build failure on ARM systems via irq_flags cleanup There was some left over #ifdef ARM logic that is outdated but no one really noticed. So instead of relying on this tricky logic, properly load and utilize the platform irq_flags resources. Reported-by: Ben Hutchings Signed-off-by: Lothar Wassmann Signed-off-by: Mike Frysinger Signed-off-by: Greg Kroah-Hartman --- drivers/usb/host/isp1362-hcd.c | 21 ++++++++++++++------- 1 file changed, 14 insertions(+), 7 deletions(-) diff --git a/drivers/usb/host/isp1362-hcd.c b/drivers/usb/host/isp1362-hcd.c index 8d31044..4297165 100644 --- a/drivers/usb/host/isp1362-hcd.c +++ b/drivers/usb/host/isp1362-hcd.c @@ -2697,6 +2697,8 @@ static int __init isp1362_probe(struct platform_device *pdev) void __iomem *data_reg; int irq; int retval = 0; + struct resource *irq_res; + unsigned int irq_flags = 0; /* basic sanity checks first. board-specific init logic should * have initialized this the three resources and probably board @@ -2710,11 +2712,12 @@ static int __init isp1362_probe(struct platform_device *pdev) data = platform_get_resource(pdev, IORESOURCE_MEM, 0); addr = platform_get_resource(pdev, IORESOURCE_MEM, 1); - irq = platform_get_irq(pdev, 0); - if (!addr || !data || irq < 0) { + irq_res = platform_get_resource(pdev, IORESOURCE_IRQ, 0); + if (!addr || !data || !irq_res) { retval = -ENODEV; goto err1; } + irq = irq_res->start; #ifdef CONFIG_USB_HCD_DMA if (pdev->dev.dma_mask) { @@ -2781,12 +2784,16 @@ static int __init isp1362_probe(struct platform_device *pdev) } #endif -#ifdef CONFIG_ARM - if (isp1362_hcd->board) - set_irq_type(irq, isp1362_hcd->board->int_act_high ? IRQT_RISING : IRQT_FALLING); -#endif + if (irq_res->flags & IORESOURCE_IRQ_HIGHEDGE) + irq_flags |= IRQF_TRIGGER_RISING; + if (irq_res->flags & IORESOURCE_IRQ_LOWEDGE) + irq_flags |= IRQF_TRIGGER_FALLING; + if (irq_res->flags & IORESOURCE_IRQ_HIGHLEVEL) + irq_flags |= IRQF_TRIGGER_HIGH; + if (irq_res->flags & IORESOURCE_IRQ_LOWLEVEL) + irq_flags |= IRQF_TRIGGER_LOW; - retval = usb_add_hcd(hcd, irq, IRQF_TRIGGER_LOW | IRQF_DISABLED | IRQF_SHARED); + retval = usb_add_hcd(hcd, irq, irq_flags | IRQF_DISABLED | IRQF_SHARED); if (retval != 0) goto err6; pr_info("%s, irq %d\n", hcd->product_desc, irq); -- 1.8.2.3