ucc_geth: use correct thread number for 10/100Mbps link

Use thread number of 1 for 10/100Mbps link instead of 4.

Signed-off-by: Joakim Tjernlund <Joakim.Tjernlund@transmode.se>
Signed-off-by: Li Yang <leoli@freescale.com>
Signed-off-by: Jeff Garzik <jeff@garzik.org>

diff --git a/drivers/net/ucc_geth.c b/drivers/net/ucc_geth.c
index fba0811..8cc3166 100644 (file)
--- a/drivers/net/ucc_geth.c
+++ b/drivers/net/ucc_geth.c
@@ -154,8 +154,8 @@ static struct ucc_geth_info ugeth_primary_info = {
        .rxQoSMode = UCC_GETH_QOS_MODE_DEFAULT,
        .aufc = UPSMR_AUTOMATIC_FLOW_CONTROL_MODE_NONE,
        .padAndCrc = MACCFG2_PAD_AND_CRC_MODE_PAD_AND_CRC,
-       .numThreadsTx = UCC_GETH_NUM_OF_THREADS_4,
-       .numThreadsRx = UCC_GETH_NUM_OF_THREADS_4,
+       .numThreadsTx = UCC_GETH_NUM_OF_THREADS_1,
+       .numThreadsRx = UCC_GETH_NUM_OF_THREADS_1,
        .riscTx = QE_RISC_ALLOCATION_RISC1_AND_RISC2,
        .riscRx = QE_RISC_ALLOCATION_RISC1_AND_RISC2,
 };
@@ -3975,6 +3975,8 @@ static int ucc_geth_probe(struct of_device* ofdev, const struct of_device_id *ma
                ug_info->uf_info.utfs = UCC_GETH_UTFS_GIGA_INIT;
                ug_info->uf_info.utfet = UCC_GETH_UTFET_GIGA_INIT;
                ug_info->uf_info.utftt = UCC_GETH_UTFTT_GIGA_INIT;
+               ug_info->numThreadsTx = UCC_GETH_NUM_OF_THREADS_4;
+               ug_info->numThreadsRx = UCC_GETH_NUM_OF_THREADS_4;
        }
 
        /* Set the bus id */