sky2: receive checksum refactoring

Break the largish case for handling receive checksum into a separate
function, and if there is a problem use dev_XXX routines to
show which hardware is the problem.

Turn one corner case into a BUG().  This only happens if the driver
is expecting one behavior but the chip does the old behavior;
only ever saw this when bringing up a new chip type and driver
was buggy.

Signed-off-by: Stephen Hemminger <shemminger@vyatta.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/net/sky2.c b/drivers/net/sky2.c
index 1aa1f33..478288b 100644 (file)
--- a/drivers/net/sky2.c
+++ b/drivers/net/sky2.c
@@ -2484,6 +2484,32 @@ static inline void sky2_rx_done(struct sky2_hw *hw, unsigned port,
        }
 }
 
+static void sky2_rx_checksum(struct sky2_port *sky2, u32 status)
+{
+       /* If this happens then driver assuming wrong format for chip type */
+       BUG_ON(sky2->hw->flags & SKY2_HW_NEW_LE);
+
+       /* Both checksum counters are programmed to start at
+        * the same offset, so unless there is a problem they
+        * should match. This failure is an early indication that
+        * hardware receive checksumming won't work.
+        */
+       if (likely((u16)(status >> 16) == (u16)status)) {
+               struct sk_buff *skb = sky2->rx_ring[sky2->rx_next].skb;
+               skb->ip_summed = CHECKSUM_COMPLETE;
+               skb->csum = le16_to_cpu(status);
+       } else {
+               dev_notice(&sky2->hw->pdev->dev,
+                          "%s: receive checksum problem (status = %#x)\n",
+                          sky2->netdev->name, status);
+
+               /* Disable checksum offload */
+               sky2->flags &= ~SKY2_FLAG_RX_CHECKSUM;
+               sky2_write32(sky2->hw, Q_ADDR(rxqaddr[sky2->port], Q_CSR),
+                            BMU_DIS_RX_CHKSUM);
+       }
+}
+
 /* Process status response ring */
 static int sky2_status_intr(struct sky2_hw *hw, int to_do, u16 idx)
 {
@@ -2552,37 +2578,8 @@ static int sky2_status_intr(struct sky2_hw *hw, int to_do, u16 idx)
                        /* fall through */
 #endif
                case OP_RXCHKS:
-                       if (!(sky2->flags & SKY2_FLAG_RX_CHECKSUM))
-                               break;
-
-                       /* If this happens then driver assuming wrong format */
-                       if (unlikely(hw->flags & SKY2_HW_NEW_LE)) {
-                               if (net_ratelimit())
-                                       printk(KERN_NOTICE "%s: unexpected"
-                                              " checksum status\n",
-                                              dev->name);
-                               break;
-                       }
-
-                       /* Both checksum counters are programmed to start at
-                        * the same offset, so unless there is a problem they
-                        * should match. This failure is an early indication that
-                        * hardware receive checksumming won't work.
-                        */
-                       if (likely(status >> 16 == (status & 0xffff))) {
-                               skb = sky2->rx_ring[sky2->rx_next].skb;
-                               skb->ip_summed = CHECKSUM_COMPLETE;
-                               skb->csum = le16_to_cpu(status);
-                       } else {
-                               printk(KERN_NOTICE PFX "%s: hardware receive "
-                                      "checksum problem (status = %#x)\n",
-                                      dev->name, status);
-                               sky2->flags &= ~SKY2_FLAG_RX_CHECKSUM;
-
-                               sky2_write32(sky2->hw,
-                                            Q_ADDR(rxqaddr[port], Q_CSR),
-                                            BMU_DIS_RX_CHKSUM);
-                       }
+                       if (likely(sky2->flags & SKY2_FLAG_RX_CHECKSUM))
+                               sky2_rx_checksum(sky2, status);
                        break;
 
                case OP_TXINDEXLE: