RPC/RDMA: correct the reconnect timer backoff

The RPC/RDMA code had a constant 5-second reconnect backoff, and
always performed it, even when re-establishing a connection to a
server after the RPC layer closed it due to being idle. Make it
an geometric backoff (up to 30 seconds), and don't delay idle
reconnect.

Signed-off-by: Tom Talpey <talpey@netapp.com>
Signed-off-by: Trond Myklebust <Trond.Myklebust@netapp.com>

diff --git a/net/sunrpc/xprtrdma/transport.c b/net/sunrpc/xprtrdma/transport.c
index c2da680..9839c3d 100644 (file)
--- a/net/sunrpc/xprtrdma/transport.c
+++ b/net/sunrpc/xprtrdma/transport.c
@@ -463,6 +463,8 @@ xprt_rdma_close(struct rpc_xprt *xprt)
        struct rpcrdma_xprt *r_xprt = rpcx_to_rdmax(xprt);
 
        dprintk("RPC:       %s: closing\n", __func__);
+       if (r_xprt->rx_ep.rep_connected > 0)
+               xprt->reestablish_timeout = 0;
        xprt_disconnect_done(xprt);
        (void) rpcrdma_ep_disconnect(&r_xprt->rx_ep, &r_xprt->rx_ia);
 }
@@ -490,6 +492,11 @@ xprt_rdma_connect(struct rpc_task *task)
                        /* Reconnect */
                        schedule_delayed_work(&r_xprt->rdma_connect,
                                xprt->reestablish_timeout);
+                       xprt->reestablish_timeout <<= 1;
+                       if (xprt->reestablish_timeout > (30 * HZ))
+                               xprt->reestablish_timeout = (30 * HZ);
+                       else if (xprt->reestablish_timeout < (5 * HZ))
+                               xprt->reestablish_timeout = (5 * HZ);
                } else {
                        schedule_delayed_work(&r_xprt->rdma_connect, 0);
                        if (!RPC_IS_ASYNC(task))