return 0;
pci_read_config_byte(amd_smbus_dev, PCI_REVISION_ID, &rev);
+
+ /* SB800 needs pre-fetch fix */
+ if ((rev >= 0x40) && (rev <= 0x4f)) {
+ ohci->flags |= OHCI_QUIRK_AMD_PREFETCH;
+ ohci_dbg(ohci, "enabled AMD prefetch quirk\n");
+ }
+
if ((rev > 0x3b) || (rev < 0x30)) {
pci_dev_put(amd_smbus_dev);
amd_smbus_dev = NULL;
}
+static void sb800_prefetch(struct ohci_hcd *ohci, int on)
+{
+ struct pci_dev *pdev;
+ u16 misc;
+
+ pdev = to_pci_dev(ohci_to_hcd(ohci)->self.controller);
+ pci_read_config_word(pdev, 0x50, &misc);
+ if (on == 0)
+ pci_write_config_word(pdev, 0x50, misc & 0xfcff);
+ else
+ pci_write_config_word(pdev, 0x50, misc | 0x0300);
+}
+
/* List of quirks for OHCI */
static const struct pci_device_id ohci_pci_quirks[] = {
{
/* RWC may not be set for add-in PCI cards, since boot
* firmware probably ignored them. This transfers PCI
- * PM wakeup capabilities (once the PCI layer is fixed).
+ * PM wakeup capabilities.
*/
- if (device_may_wakeup(&pdev->dev))
+ if (device_can_wakeup(&pdev->dev))
ohci->hc_control |= OHCI_CTRL_RWC;
}
#endif /* CONFIG_PM */
#ifdef CONFIG_PM
-static int ohci_pci_suspend (struct usb_hcd *hcd, pm_message_t message)
+static int ohci_pci_suspend(struct usb_hcd *hcd)
{
struct ohci_hcd *ohci = hcd_to_ohci (hcd);
unsigned long flags;
ohci_writel(ohci, OHCI_INTR_MIE, &ohci->regs->intrdisable);
(void)ohci_readl(ohci, &ohci->regs->intrdisable);
- /* make sure snapshot being resumed re-enumerates everything */
- if (message.event == PM_EVENT_PRETHAW)
- ohci_usb_reset(ohci);
-
clear_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
bail:
spin_unlock_irqrestore (&ohci->lock, flags);
}
-static int ohci_pci_resume (struct usb_hcd *hcd)
+static int ohci_pci_resume(struct usb_hcd *hcd, bool hibernated)
{
set_bit(HCD_FLAG_HW_ACCESSIBLE, &hcd->flags);
+
+ /* Make sure resume from hibernation re-enumerates everything */
+ if (hibernated)
+ ohci_usb_reset(hcd_to_ohci(hcd));
+
ohci_finish_controller_resume(hcd);
return 0;
}
.probe = usb_hcd_pci_probe,
.remove = usb_hcd_pci_remove,
+ .shutdown = usb_hcd_pci_shutdown,
-#ifdef CONFIG_PM
- .suspend = usb_hcd_pci_suspend,
- .resume = usb_hcd_pci_resume,
+#ifdef CONFIG_PM_SLEEP
+ .driver = {
+ .pm = &usb_hcd_pci_pm_ops
+ },
#endif
-
- .shutdown = usb_hcd_pci_shutdown,
};
-