static void
ahc_restart(struct ahc_softc *ahc)
{
+ uint8_t sblkctl;
ahc_pause(ahc);
ahc_outb(ahc, SEQADDR0, 0);
ahc_outb(ahc, SEQADDR1, 0);
+ /*
+ * Take the LED out of diagnostic mode on PM resume, too
+ */
+ sblkctl = ahc_inb(ahc, SBLKCTL);
+ ahc_outb(ahc, SBLKCTL, (sblkctl & ~(DIAGLEDEN|DIAGLEDON)));
+
ahc_unpause(ahc);
}
/*
* Although the driver does not care about the
* 'Selection in Progress' status bit, the busy
- * LED does. SELINGO is only cleared by a sucessfull
+ * LED does. SELINGO is only cleared by a successfull
* selection, so we must manually clear it to insure
* the LED turns off just incase no future successful
* selections occur (e.g. no devices on the bus).
/*
* Setup the allowed SCSI Sequences based on operational mode.
- * If we are a target, we'll enalbe select in operations once
+ * If we are a target, we'll enable select in operations once
* we've had a lun enabled.
*/
scsiseq_template = ENSELO|ENAUTOATNO|ENAUTOATNP;