# Makefile for the PCI bus specific drivers.
#
-obj-y += access.o bus.o probe.o remove.o pci.o quirks.o slot.o \
- pci-driver.o search.o pci-sysfs.o rom.o setup-res.o
+obj-y += access.o bus.o probe.o remove.o pci.o \
+ pci-driver.o search.o pci-sysfs.o rom.o setup-res.o \
+ irq.o vpd.o
obj-$(CONFIG_PROC_FS) += proc.o
+obj-$(CONFIG_SYSFS) += slot.o
+
+obj-$(CONFIG_PCI_QUIRKS) += quirks.o
# Build PCI Express stuff if needed
obj-$(CONFIG_PCIEPORTBUS) += pcie/
+obj-$(CONFIG_PCI_IOAPIC) += ioapic.o
+
obj-$(CONFIG_HOTPLUG) += hotplug.o
# Build the PCI Hotplug drivers if we were asked to
# Build Intel IOMMU support
obj-$(CONFIG_DMAR) += dmar.o iova.o intel-iommu.o
+obj-$(CONFIG_INTR_REMAP) += dmar.o intr_remapping.o
+
+obj-$(CONFIG_PCI_IOV) += iov.o
+
#
# Some architectures use the generic PCI setup functions
#
obj-$(CONFIG_ARM) += setup-bus.o setup-irq.o
obj-$(CONFIG_PARISC) += setup-bus.o
obj-$(CONFIG_SUPERH) += setup-bus.o setup-irq.o
-obj-$(CONFIG_PPC32) += setup-irq.o
obj-$(CONFIG_PPC) += setup-bus.o
obj-$(CONFIG_MIPS) += setup-bus.o setup-irq.o
obj-$(CONFIG_X86_VISWS) += setup-irq.o
obj-$(CONFIG_PCI_SYSCALL) += syscall.o
+obj-$(CONFIG_PCI_STUB) += pci-stub.o
+
ifeq ($(CONFIG_PCI_DEBUG),y)
EXTRA_CFLAGS += -DDEBUG
endif
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff