**/
s32 e1000e_get_bus_info_pcie(struct e1000_hw *hw)
{
+ struct e1000_mac_info *mac = &hw->mac;
struct e1000_bus_info *bus = &hw->bus;
struct e1000_adapter *adapter = hw->adapter;
- u32 status;
- u16 pcie_link_status, pci_header_type, cap_offset;
+ u16 pcie_link_status, cap_offset;
cap_offset = pci_find_capability(adapter->pdev, PCI_CAP_ID_EXP);
if (!cap_offset) {
PCIE_LINK_WIDTH_SHIFT);
}
- pci_read_config_word(adapter->pdev, PCI_HEADER_TYPE_REGISTER,
- &pci_header_type);
- if (pci_header_type & PCI_HEADER_TYPE_MULTIFUNC) {
- status = er32(STATUS);
- bus->func = (status & E1000_STATUS_FUNC_MASK)
- >> E1000_STATUS_FUNC_SHIFT;
- } else {
- bus->func = 0;
- }
+ mac->ops.set_lan_id(hw);
return 0;
}
/**
+ * e1000_set_lan_id_multi_port_pcie - Set LAN id for PCIe multiple port devices
+ *
+ * @hw: pointer to the HW structure
+ *
+ * Determines the LAN function id by reading memory-mapped registers
+ * and swaps the port value if requested.
+ **/
+void e1000_set_lan_id_multi_port_pcie(struct e1000_hw *hw)
+{
+ struct e1000_bus_info *bus = &hw->bus;
+ u32 reg;
+
+ /*
+ * The status register reports the correct function number
+ * for the device regardless of function swap state.
+ */
+ reg = er32(STATUS);
+ bus->func = (reg & E1000_STATUS_FUNC_MASK) >> E1000_STATUS_FUNC_SHIFT;
+}
+
+/**
+ * e1000_set_lan_id_single_port - Set LAN id for a single port device
+ * @hw: pointer to the HW structure
+ *
+ * Sets the LAN function id to zero for a single port device.
+ **/
+void e1000_set_lan_id_single_port(struct e1000_hw *hw)
+{
+ struct e1000_bus_info *bus = &hw->bus;
+
+ bus->func = 0;
+}
+
+/**
* e1000_clear_vfta_generic - Clear VLAN filter table
* @hw: pointer to the HW structure
*
}
/**
+ * e1000_check_alt_mac_addr_generic - Check for alternate MAC addr
+ * @hw: pointer to the HW structure
+ *
+ * Checks the nvm for an alternate MAC address. An alternate MAC address
+ * can be setup by pre-boot software and must be treated like a permanent
+ * address and must override the actual permanent MAC address. If an
+ * alternate MAC address is found it is programmed into RAR0, replacing
+ * the permanent address that was installed into RAR0 by the Si on reset.
+ * This function will return SUCCESS unless it encounters an error while
+ * reading the EEPROM.
+ **/
+s32 e1000_check_alt_mac_addr_generic(struct e1000_hw *hw)
+{
+ u32 i;
+ s32 ret_val = 0;
+ u16 offset, nvm_alt_mac_addr_offset, nvm_data;
+ u8 alt_mac_addr[ETH_ALEN];
+
+ ret_val = e1000_read_nvm(hw, NVM_ALT_MAC_ADDR_PTR, 1,
+ &nvm_alt_mac_addr_offset);
+ if (ret_val) {
+ e_dbg("NVM Read Error\n");
+ goto out;
+ }
+
+ if (nvm_alt_mac_addr_offset == 0xFFFF) {
+ /* There is no Alternate MAC Address */
+ goto out;
+ }
+
+ if (hw->bus.func == E1000_FUNC_1)
+ nvm_alt_mac_addr_offset += E1000_ALT_MAC_ADDRESS_OFFSET_LAN1;
+ for (i = 0; i < ETH_ALEN; i += 2) {
+ offset = nvm_alt_mac_addr_offset + (i >> 1);
+ ret_val = e1000_read_nvm(hw, offset, 1, &nvm_data);
+ if (ret_val) {
+ e_dbg("NVM Read Error\n");
+ goto out;
+ }
+
+ alt_mac_addr[i] = (u8)(nvm_data & 0xFF);
+ alt_mac_addr[i + 1] = (u8)(nvm_data >> 8);
+ }
+
+ /* if multicast bit is set, the alternate address will not be used */
+ if (alt_mac_addr[0] & 0x01) {
+ e_dbg("Ignoring Alternate Mac Address with MC bit set\n");
+ goto out;
+ }
+
+ /*
+ * We have a valid alternate MAC address, and we want to treat it the
+ * same as the normal permanent MAC address stored by the HW into the
+ * RAR. Do this by mapping this address into RAR0.
+ */
+ e1000e_rar_set(hw, alt_mac_addr, 0);
+
+out:
+ return ret_val;
+}
+
+/**
* e1000e_rar_set - Set receive address register
* @hw: pointer to the HW structure
* @addr: pointer to the receive address
* @hw: pointer to the HW structure
* @mc_addr_list: array of multicast addresses to program
* @mc_addr_count: number of multicast addresses to program
- * @rar_used_count: the first RAR register free to program
- * @rar_count: total number of supported Receive Address Registers
*
- * Updates the Receive Address Registers and Multicast Table Array.
+ * Updates entire Multicast Table Array.
* The caller must have a packed mc_addr_list of multicast addresses.
- * The parameter rar_count will usually be hw->mac.rar_entry_count
- * unless there are workarounds that change this.
**/
void e1000e_update_mc_addr_list_generic(struct e1000_hw *hw,
- u8 *mc_addr_list, u32 mc_addr_count,
- u32 rar_used_count, u32 rar_count)
+ u8 *mc_addr_list, u32 mc_addr_count)
{
- u32 i;
- u32 *mcarray = kzalloc(hw->mac.mta_reg_count * sizeof(u32), GFP_ATOMIC);
+ u32 hash_value, hash_bit, hash_reg;
+ int i;
- if (!mcarray) {
- printk(KERN_ERR "multicast array memory allocation failed\n");
- return;
- }
+ /* clear mta_shadow */
+ memset(&hw->mac.mta_shadow, 0, sizeof(hw->mac.mta_shadow));
- /*
- * Load the first set of multicast addresses into the exact
- * filters (RAR). If there are not enough to fill the RAR
- * array, clear the filters.
- */
- for (i = rar_used_count; i < rar_count; i++) {
- if (mc_addr_count) {
- e1000e_rar_set(hw, mc_addr_list, i);
- mc_addr_count--;
- mc_addr_list += ETH_ALEN;
- } else {
- E1000_WRITE_REG_ARRAY(hw, E1000_RA, i << 1, 0);
- e1e_flush();
- E1000_WRITE_REG_ARRAY(hw, E1000_RA, (i << 1) + 1, 0);
- e1e_flush();
- }
- }
-
- /* Load any remaining multicast addresses into the hash table. */
- for (; mc_addr_count > 0; mc_addr_count--) {
- u32 hash_value, hash_reg, hash_bit, mta;
+ /* update mta_shadow from mc_addr_list */
+ for (i = 0; (u32) i < mc_addr_count; i++) {
hash_value = e1000_hash_mc_addr(hw, mc_addr_list);
- e_dbg("Hash value = 0x%03X\n", hash_value);
+
hash_reg = (hash_value >> 5) & (hw->mac.mta_reg_count - 1);
hash_bit = hash_value & 0x1F;
- mta = (1 << hash_bit);
- mcarray[hash_reg] |= mta;
- mc_addr_list += ETH_ALEN;
- }
- /* write the hash table completely */
- for (i = 0; i < hw->mac.mta_reg_count; i++)
- E1000_WRITE_REG_ARRAY(hw, E1000_MTA, i, mcarray[i]);
+ hw->mac.mta_shadow[hash_reg] |= (1 << hash_bit);
+ mc_addr_list += (ETH_ALEN);
+ }
+ /* replace the entire MTA table */
+ for (i = hw->mac.mta_reg_count - 1; i >= 0; i--)
+ E1000_WRITE_REG_ARRAY(hw, E1000_MTA, i, hw->mac.mta_shadow[i]);
e1e_flush();
- kfree(mcarray);
}
/**
}
/**
- * e1000e_read_mac_addr - Read device MAC address
+ * e1000_read_mac_addr_generic - Read device MAC address
* @hw: pointer to the HW structure
*
* Reads the device MAC address from the EEPROM and stores the value.
* Since devices with two ports use the same EEPROM, we increment the
* last bit in the MAC address for the second port.
**/
-s32 e1000e_read_mac_addr(struct e1000_hw *hw)
+s32 e1000_read_mac_addr_generic(struct e1000_hw *hw)
{
- s32 ret_val;
- u16 offset, nvm_data, i;
- u16 mac_addr_offset = 0;
-
- if (hw->mac.type == e1000_82571) {
- /* Check for an alternate MAC address. An alternate MAC
- * address can be setup by pre-boot software and must be
- * treated like a permanent address and must override the
- * actual permanent MAC address.*/
- ret_val = e1000_read_nvm(hw, NVM_ALT_MAC_ADDR_PTR, 1,
- &mac_addr_offset);
- if (ret_val) {
- e_dbg("NVM Read Error\n");
- return ret_val;
- }
- if (mac_addr_offset == 0xFFFF)
- mac_addr_offset = 0;
-
- if (mac_addr_offset) {
- if (hw->bus.func == E1000_FUNC_1)
- mac_addr_offset += ETH_ALEN/sizeof(u16);
-
- /* make sure we have a valid mac address here
- * before using it */
- ret_val = e1000_read_nvm(hw, mac_addr_offset, 1,
- &nvm_data);
- if (ret_val) {
- e_dbg("NVM Read Error\n");
- return ret_val;
- }
- if (nvm_data & 0x0001)
- mac_addr_offset = 0;
- }
+ u32 rar_high;
+ u32 rar_low;
+ u16 i;
- if (mac_addr_offset)
- hw->dev_spec.e82571.alt_mac_addr_is_present = 1;
- }
+ rar_high = er32(RAH(0));
+ rar_low = er32(RAL(0));
- for (i = 0; i < ETH_ALEN; i += 2) {
- offset = mac_addr_offset + (i >> 1);
- ret_val = e1000_read_nvm(hw, offset, 1, &nvm_data);
- if (ret_val) {
- e_dbg("NVM Read Error\n");
- return ret_val;
- }
- hw->mac.perm_addr[i] = (u8)(nvm_data & 0xFF);
- hw->mac.perm_addr[i+1] = (u8)(nvm_data >> 8);
- }
+ for (i = 0; i < E1000_RAL_MAC_ADDR_LEN; i++)
+ hw->mac.perm_addr[i] = (u8)(rar_low >> (i*8));
- /* Flip last bit of mac address if we're on second port */
- if (!mac_addr_offset && hw->bus.func == E1000_FUNC_1)
- hw->mac.perm_addr[5] ^= 1;
+ for (i = 0; i < E1000_RAH_MAC_ADDR_LEN; i++)
+ hw->mac.perm_addr[i+4] = (u8)(rar_high >> (i*8));
for (i = 0; i < ETH_ALEN; i++)
hw->mac.addr[i] = hw->mac.perm_addr[i];
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff