* indicates that the bootagent or EFI code has
* improperly left this bit enabled
*/
- hw_dbg(hw, "Please update your 82571 Bootagent\n");
+ e_dbg("Please update your 82571 Bootagent\n");
}
ew32(SWSM, swsm & ~E1000_SWSM_SMBI);
}
}
if (i == sw_timeout) {
- hw_dbg(hw, "Driver can't access device - SMBI bit is set.\n");
+ e_dbg("Driver can't access device - SMBI bit is set.\n");
hw->dev_spec.e82571.smb_counter++;
}
/* Get the FW semaphore. */
if (i == fw_timeout) {
/* Release semaphores */
e1000_put_hw_semaphore_82571(hw);
- hw_dbg(hw, "Driver can't access the NVM\n");
+ e_dbg("Driver can't access the NVM\n");
return -E1000_ERR_NVM;
}
*/
if ((offset >= nvm->word_size) || (words > (nvm->word_size - offset)) ||
(words == 0)) {
- hw_dbg(hw, "nvm parameter(s) out of bounds\n");
+ e_dbg("nvm parameter(s) out of bounds\n");
return -E1000_ERR_NVM;
}
timeout--;
}
if (!timeout) {
- hw_dbg(hw, "MNG configuration cycle has not completed.\n");
+ e_dbg("MNG configuration cycle has not completed.\n");
return -E1000_ERR_RESET;
}
*/
ret_val = e1000e_disable_pcie_master(hw);
if (ret_val)
- hw_dbg(hw, "PCI-E Master disable polling has failed.\n");
+ e_dbg("PCI-E Master disable polling has failed.\n");
- hw_dbg(hw, "Masking off all interrupts\n");
+ e_dbg("Masking off all interrupts\n");
ew32(IMC, 0xffffffff);
ew32(RCTL, 0);
ctrl = er32(CTRL);
- hw_dbg(hw, "Issuing a global reset to MAC\n");
+ e_dbg("Issuing a global reset to MAC\n");
ew32(CTRL, ctrl | E1000_CTRL_RST);
if (hw->nvm.type == e1000_nvm_flash_hw) {
/* Initialize identification LED */
ret_val = e1000e_id_led_init(hw);
if (ret_val) {
- hw_dbg(hw, "Error initializing identification LED\n");
+ e_dbg("Error initializing identification LED\n");
return ret_val;
}
/* Disabling VLAN filtering */
- hw_dbg(hw, "Initializing the IEEE VLAN\n");
+ e_dbg("Initializing the IEEE VLAN\n");
e1000e_clear_vfta(hw);
/* Setup the receive address. */
e1000e_init_rx_addrs(hw, rar_count);
/* Zero out the Multicast HASH table */
- hw_dbg(hw, "Zeroing the MTA\n");
+ e_dbg("Zeroing the MTA\n");
for (i = 0; i < mac->mta_reg_count; i++)
E1000_WRITE_REG_ARRAY(hw, E1000_MTA, i, 0);
*/
mac->serdes_link_state =
e1000_serdes_link_autoneg_progress;
- hw_dbg(hw, "AN_UP -> AN_PROG\n");
+ e_dbg("AN_UP -> AN_PROG\n");
}
break;
(ctrl & ~E1000_CTRL_SLU));
mac->serdes_link_state =
e1000_serdes_link_autoneg_progress;
- hw_dbg(hw, "FORCED_UP -> AN_PROG\n");
+ e_dbg("FORCED_UP -> AN_PROG\n");
}
break;
if (status & E1000_STATUS_LU) {
mac->serdes_link_state =
e1000_serdes_link_autoneg_complete;
- hw_dbg(hw, "AN_PROG -> AN_UP\n");
+ e_dbg("AN_PROG -> AN_UP\n");
} else {
/*
* Disable autoneg, force link up and
ret_val =
e1000e_config_fc_after_link_up(hw);
if (ret_val) {
- hw_dbg(hw, "Error config flow control\n");
+ e_dbg("Error config flow control\n");
break;
}
mac->serdes_link_state =
e1000_serdes_link_forced_up;
- hw_dbg(hw, "AN_PROG -> FORCED_UP\n");
+ e_dbg("AN_PROG -> FORCED_UP\n");
}
mac->serdes_has_link = true;
break;
(ctrl & ~E1000_CTRL_SLU));
mac->serdes_link_state =
e1000_serdes_link_autoneg_progress;
- hw_dbg(hw, "DOWN -> AN_PROG\n");
+ e_dbg("DOWN -> AN_PROG\n");
break;
}
} else {
if (!(rxcw & E1000_RXCW_SYNCH)) {
mac->serdes_has_link = false;
mac->serdes_link_state = e1000_serdes_link_down;
- hw_dbg(hw, "ANYSTATE -> DOWN\n");
+ e_dbg("ANYSTATE -> DOWN\n");
} else {
/*
* We have sync, and can tolerate one
if (rxcw & E1000_RXCW_IV) {
mac->serdes_link_state = e1000_serdes_link_down;
mac->serdes_has_link = false;
- hw_dbg(hw, "ANYSTATE -> DOWN\n");
+ e_dbg("ANYSTATE -> DOWN\n");
}
}
}
ret_val = e1000_read_nvm(hw, NVM_ID_LED_SETTINGS, 1, data);
if (ret_val) {
- hw_dbg(hw, "NVM Read Error\n");
+ e_dbg("NVM Read Error\n");
return ret_val;
}