static void hardware_init(struct net_device *dev);
static void write_packet(long ioaddr, int length, unsigned char *packet, int pad, int mode);
static void trigger_send(long ioaddr, int length);
-static int atp_send_packet(struct sk_buff *skb, struct net_device *dev);
+static netdev_tx_t atp_send_packet(struct sk_buff *skb,
+ struct net_device *dev);
static irqreturn_t atp_interrupt(int irq, void *dev_id);
static void net_rx(struct net_device *dev);
static void read_block(long ioaddr, int length, unsigned char *buffer, int data_mode);
static int net_close(struct net_device *dev);
-static void set_rx_mode_8002(struct net_device *dev);
-static void set_rx_mode_8012(struct net_device *dev);
+static void set_rx_mode(struct net_device *dev);
static void tx_timeout(struct net_device *dev);
return -ENODEV;
}
+static const struct net_device_ops atp_netdev_ops = {
+ .ndo_open = net_open,
+ .ndo_stop = net_close,
+ .ndo_start_xmit = atp_send_packet,
+ .ndo_set_multicast_list = set_rx_mode,
+ .ndo_tx_timeout = tx_timeout,
+ .ndo_change_mtu = eth_change_mtu,
+ .ndo_set_mac_address = eth_mac_addr,
+ .ndo_validate_addr = eth_validate_addr,
+};
+
static int __init atp_probe1(long ioaddr)
{
struct net_device *dev = NULL;
printk(KERN_INFO "%s", version);
#endif
- printk(KERN_NOTICE "%s: Pocket adapter found at %#3lx, IRQ %d, SAPROM "
- "%02X:%02X:%02X:%02X:%02X:%02X.\n", dev->name, dev->base_addr,
- dev->irq, dev->dev_addr[0], dev->dev_addr[1], dev->dev_addr[2],
- dev->dev_addr[3], dev->dev_addr[4], dev->dev_addr[5]);
+ printk(KERN_NOTICE "%s: Pocket adapter found at %#3lx, IRQ %d, "
+ "SAPROM %pM.\n",
+ dev->name, dev->base_addr, dev->irq, dev->dev_addr);
/* Reset the ethernet hardware and activate the printer pass-through. */
write_reg_high(ioaddr, CMR1, CMR1h_RESET | CMR1h_MUX);
if (dev->mem_end & 0xf)
net_debug = dev->mem_end & 7;
- dev->open = net_open;
- dev->stop = net_close;
- dev->hard_start_xmit = atp_send_packet;
- dev->set_multicast_list =
- lp->chip_type == RTL8002 ? &set_rx_mode_8002 : &set_rx_mode_8012;
- dev->tx_timeout = tx_timeout;
+ dev->netdev_ops = &atp_netdev_ops;
dev->watchdog_timeo = TX_TIMEOUT;
res = register_netdev(dev);
sa_offset = 15;
for (i = 0; i < 3; i++)
- ((u16 *)dev->dev_addr)[i] =
- be16_to_cpu(eeprom_op(ioaddr, EE_READ(sa_offset + i)));
+ ((__be16 *)dev->dev_addr)[i] =
+ cpu_to_be16(eeprom_op(ioaddr, EE_READ(sa_offset + i)));
write_reg(ioaddr, CMR2, CMR2_NULL);
}
registers that "should" only need to be set once at boot, so that
there is non-reboot way to recover if something goes wrong.
- This is an attachable device: if there is no dev->priv entry then it wasn't
+ This is an attachable device: if there is no private entry then it wasn't
probed for at boot-time, and we need to probe for it again.
*/
static int net_open(struct net_device *dev)
/* The interrupt line is turned off (tri-stated) when the device isn't in
use. That's especially important for "attached" interfaces where the
port or interrupt may be shared. */
- ret = request_irq(dev->irq, &atp_interrupt, 0, dev->name, dev);
+ ret = request_irq(dev->irq, atp_interrupt, 0, dev->name, dev);
if (ret)
return ret;
dev->stats.tx_errors++;
}
-static int atp_send_packet(struct sk_buff *skb, struct net_device *dev)
+static netdev_tx_t atp_send_packet(struct sk_buff *skb,
+ struct net_device *dev)
{
struct net_local *lp = netdev_priv(dev);
long ioaddr = dev->base_addr;
dev->trans_start = jiffies;
dev_kfree_skb (skb);
- return 0;
+ return NETDEV_TX_OK;
}
netif_wake_queue(dev); /* Inform upper layers. */
}
num_tx_since_rx++;
- } else if (num_tx_since_rx > 8
- && time_after(jiffies, dev->last_rx + HZ)) {
+ } else if (num_tx_since_rx > 8 &&
+ time_after(jiffies, dev->last_rx + HZ)) {
if (net_debug > 2)
printk(KERN_DEBUG "%s: Missed packet? No Rx after %d Tx and "
"%ld jiffies status %02x CMR1 %02x.\n", dev->name,
static void read_block(long ioaddr, int length, unsigned char *p, int data_mode)
{
-
if (data_mode <= 3) { /* Mode 0 or 1 */
outb(Ctrl_LNibRead, ioaddr + PAR_CONTROL);
outb(length == 8 ? RdAddr | HNib | MAR : RdAddr | MAR,
ioaddr + PAR_DATA);
if (data_mode <= 1) { /* Mode 0 or 1 */
- do *p++ = read_byte_mode0(ioaddr); while (--length > 0);
- } else /* Mode 2 or 3 */
- do *p++ = read_byte_mode2(ioaddr); while (--length > 0);
- } else if (data_mode <= 5)
- do *p++ = read_byte_mode4(ioaddr); while (--length > 0);
- else
- do *p++ = read_byte_mode6(ioaddr); while (--length > 0);
+ do { *p++ = read_byte_mode0(ioaddr); } while (--length > 0);
+ } else { /* Mode 2 or 3 */
+ do { *p++ = read_byte_mode2(ioaddr); } while (--length > 0);
+ }
+ } else if (data_mode <= 5) {
+ do { *p++ = read_byte_mode4(ioaddr); } while (--length > 0);
+ } else {
+ do { *p++ = read_byte_mode6(ioaddr); } while (--length > 0);
+ }
- outb(EOC+HNib+MAR, ioaddr + PAR_DATA);
+ outb(EOC+HNib+MAR, ioaddr + PAR_DATA);
outb(Ctrl_SelData, ioaddr + PAR_CONTROL);
}
struct net_local *lp = netdev_priv(dev);
long ioaddr = dev->base_addr;
- if ( dev->mc_count > 0 || (dev->flags & (IFF_ALLMULTI|IFF_PROMISC))) {
- /* We must make the kernel realise we had to move
- * into promisc mode or we start all out war on
- * the cable. - AC
- */
- dev->flags|=IFF_PROMISC;
+ if (!netdev_mc_empty(dev) || (dev->flags & (IFF_ALLMULTI|IFF_PROMISC)))
lp->addr_mode = CMR2h_PROMISC;
- } else
+ else
lp->addr_mode = CMR2h_Normal;
write_reg_high(ioaddr, CMR2, lp->addr_mode);
}
if (dev->flags & IFF_PROMISC) { /* Set promiscuous. */
new_mode = CMR2h_PROMISC;
- } else if ((dev->mc_count > 1000) || (dev->flags & IFF_ALLMULTI)) {
+ } else if ((netdev_mc_count(dev) > 1000) ||
+ (dev->flags & IFF_ALLMULTI)) {
/* Too many to filter perfectly -- accept all multicasts. */
memset(mc_filter, 0xff, sizeof(mc_filter));
new_mode = CMR2h_Normal;
struct dev_mc_list *mclist;
memset(mc_filter, 0, sizeof(mc_filter));
- for (i = 0, mclist = dev->mc_list; mclist && i < dev->mc_count;
+ for (i = 0, mclist = dev->mc_list; mclist && i < netdev_mc_count(dev);
i++, mclist = mclist->next)
{
int filterbit = ether_crc_le(ETH_ALEN, mclist->dmi_addr) & 0x3f;
write_reg(ioaddr, CMR2, CMR2_IRQOUT); /* Switch back to page 0 */
}
+static void set_rx_mode(struct net_device *dev)
+{
+ struct net_local *lp = netdev_priv(dev);
+
+ if (lp->chip_type == RTL8002)
+ return set_rx_mode_8002(dev);
+ else
+ return set_rx_mode_8012(dev);
+}
+
+
static int __init atp_init_module(void) {
if (debug) /* Emit version even if no cards detected. */
printk(KERN_INFO "%s", version);
struct net_device *next_dev;
while (root_atp_dev) {
- next_dev = ((struct net_local *)root_atp_dev->priv)->next_module;
+ struct net_local *atp_local = netdev_priv(root_atp_dev);
+ next_dev = atp_local->next_module;
unregister_netdev(root_atp_dev);
/* No need to release_region(), since we never snarf it. */
free_netdev(root_atp_dev);
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff