-/* --------------------------------------------------------------------------
- Errata Handling
- -------------------------------------------------------------------------- */
-
-static int acpi_processor_errata_piix4(struct pci_dev *dev)
-{
- u8 value1 = 0;
- u8 value2 = 0;
-
-
- if (!dev)
- return -EINVAL;
-
- /*
- * Note that 'dev' references the PIIX4 ACPI Controller.
- */
-
- switch (dev->revision) {
- case 0:
- ACPI_DEBUG_PRINT((ACPI_DB_INFO, "Found PIIX4 A-step\n"));
- break;
- case 1:
- ACPI_DEBUG_PRINT((ACPI_DB_INFO, "Found PIIX4 B-step\n"));
- break;
- case 2:
- ACPI_DEBUG_PRINT((ACPI_DB_INFO, "Found PIIX4E\n"));
- break;
- case 3:
- ACPI_DEBUG_PRINT((ACPI_DB_INFO, "Found PIIX4M\n"));
- break;
- default:
- ACPI_DEBUG_PRINT((ACPI_DB_INFO, "Found unknown PIIX4\n"));
- break;
- }
-
- switch (dev->revision) {
-
- case 0: /* PIIX4 A-step */
- case 1: /* PIIX4 B-step */
- /*
- * See specification changes #13 ("Manual Throttle Duty Cycle")
- * and #14 ("Enabling and Disabling Manual Throttle"), plus
- * erratum #5 ("STPCLK# Deassertion Time") from the January
- * 2002 PIIX4 specification update. Applies to only older
- * PIIX4 models.
- */
- errata.piix4.throttle = 1;
-
- case 2: /* PIIX4E */
- case 3: /* PIIX4M */
- /*
- * See erratum #18 ("C3 Power State/BMIDE and Type-F DMA
- * Livelock") from the January 2002 PIIX4 specification update.
- * Applies to all PIIX4 models.
- */
-
- /*
- * BM-IDE
- * ------
- * Find the PIIX4 IDE Controller and get the Bus Master IDE
- * Status register address. We'll use this later to read
- * each IDE controller's DMA status to make sure we catch all
- * DMA activity.
- */
- dev = pci_get_subsys(PCI_VENDOR_ID_INTEL,
- PCI_DEVICE_ID_INTEL_82371AB,
- PCI_ANY_ID, PCI_ANY_ID, NULL);
- if (dev) {
- errata.piix4.bmisx = pci_resource_start(dev, 4);
- pci_dev_put(dev);
- }
-
- /*
- * Type-F DMA
- * ----------
- * Find the PIIX4 ISA Controller and read the Motherboard
- * DMA controller's status to see if Type-F (Fast) DMA mode
- * is enabled (bit 7) on either channel. Note that we'll
- * disable C3 support if this is enabled, as some legacy
- * devices won't operate well if fast DMA is disabled.
- */
- dev = pci_get_subsys(PCI_VENDOR_ID_INTEL,
- PCI_DEVICE_ID_INTEL_82371AB_0,
- PCI_ANY_ID, PCI_ANY_ID, NULL);
- if (dev) {
- pci_read_config_byte(dev, 0x76, &value1);
- pci_read_config_byte(dev, 0x77, &value2);
- if ((value1 & 0x80) || (value2 & 0x80))
- errata.piix4.fdma = 1;
- pci_dev_put(dev);
- }
-
- break;
- }
-
- if (errata.piix4.bmisx)
- ACPI_DEBUG_PRINT((ACPI_DB_INFO,
- "Bus master activity detection (BM-IDE) erratum enabled\n"));
- if (errata.piix4.fdma)
- ACPI_DEBUG_PRINT((ACPI_DB_INFO,
- "Type-F DMA livelock erratum (C3 disabled)\n"));
-
- return 0;
-}
-
-static int acpi_processor_errata(struct acpi_processor *pr)
-{
- int result = 0;
- struct pci_dev *dev = NULL;
-
-
- if (!pr)
- return -EINVAL;
-
- /*
- * PIIX4
- */
- dev = pci_get_subsys(PCI_VENDOR_ID_INTEL,
- PCI_DEVICE_ID_INTEL_82371AB_3, PCI_ANY_ID,
- PCI_ANY_ID, NULL);
- if (dev) {
- result = acpi_processor_errata_piix4(dev);
- pci_dev_put(dev);
- }
-
- return result;
-}
-
-/* --------------------------------------------------------------------------
- Common ACPI processor functions
- -------------------------------------------------------------------------- */
-
-/*
- * _PDC is required for a BIOS-OS handshake for most of the newer
- * ACPI processor features.
- */
-static int acpi_processor_set_pdc(struct acpi_processor *pr)
-{
- struct acpi_object_list *pdc_in = pr->pdc;
- acpi_status status = AE_OK;
-
-
- if (!pdc_in)
- return status;
- if (idle_nomwait) {
- /*
- * If mwait is disabled for CPU C-states, the C2C3_FFH access
- * mode will be disabled in the parameter of _PDC object.
- * Of course C1_FFH access mode will also be disabled.
- */
- union acpi_object *obj;
- u32 *buffer = NULL;
-
- obj = pdc_in->pointer;
- buffer = (u32 *)(obj->buffer.pointer);
- buffer[2] &= ~(ACPI_PDC_C_C2C3_FFH | ACPI_PDC_C_C1_FFH);
-
- }
- status = acpi_evaluate_object(pr->handle, "_PDC", pdc_in, NULL);
-
- if (ACPI_FAILURE(status))
- ACPI_DEBUG_PRINT((ACPI_DB_INFO,
- "Could not evaluate _PDC, using legacy perf. control...\n"));
-
- return status;
-}
-
-/* --------------------------------------------------------------------------
- FS Interface (/proc)
- -------------------------------------------------------------------------- */
-
-#ifdef CONFIG_ACPI_PROCFS
-static struct proc_dir_entry *acpi_processor_dir = NULL;
-
-static int acpi_processor_info_seq_show(struct seq_file *seq, void *offset)
-{
- struct acpi_processor *pr = seq->private;
-
-
- if (!pr)
- goto end;
-
- seq_printf(seq, "processor id: %d\n"
- "acpi id: %d\n"
- "bus mastering control: %s\n"
- "power management: %s\n"
- "throttling control: %s\n"
- "limit interface: %s\n",
- pr->id,
- pr->acpi_id,
- pr->flags.bm_control ? "yes" : "no",
- pr->flags.power ? "yes" : "no",
- pr->flags.throttling ? "yes" : "no",
- pr->flags.limit ? "yes" : "no");
-
- end:
- return 0;
-}
-
-static int acpi_processor_info_open_fs(struct inode *inode, struct file *file)
-{
- return single_open(file, acpi_processor_info_seq_show,
- PDE(inode)->data);
-}
-
-static int acpi_processor_add_fs(struct acpi_device *device)
-{
- struct proc_dir_entry *entry = NULL;
-
-
- if (!acpi_device_dir(device)) {
- acpi_device_dir(device) = proc_mkdir(acpi_device_bid(device),
- acpi_processor_dir);
- if (!acpi_device_dir(device))
- return -ENODEV;
- }
-
- /* 'info' [R] */
- entry = proc_create_data(ACPI_PROCESSOR_FILE_INFO,
- S_IRUGO, acpi_device_dir(device),
- &acpi_processor_info_fops,
- acpi_driver_data(device));
- if (!entry)
- return -EIO;
-
- /* 'throttling' [R/W] */
- entry = proc_create_data(ACPI_PROCESSOR_FILE_THROTTLING,
- S_IFREG | S_IRUGO | S_IWUSR,
- acpi_device_dir(device),
- &acpi_processor_throttling_fops,
- acpi_driver_data(device));
- if (!entry)
- return -EIO;
-
- /* 'limit' [R/W] */
- entry = proc_create_data(ACPI_PROCESSOR_FILE_LIMIT,
- S_IFREG | S_IRUGO | S_IWUSR,
- acpi_device_dir(device),
- &acpi_processor_limit_fops,
- acpi_driver_data(device));
- if (!entry)
- return -EIO;
- return 0;
-}
-static int acpi_processor_remove_fs(struct acpi_device *device)
-{
-
- if (acpi_device_dir(device)) {
- remove_proc_entry(ACPI_PROCESSOR_FILE_INFO,
- acpi_device_dir(device));
- remove_proc_entry(ACPI_PROCESSOR_FILE_THROTTLING,
- acpi_device_dir(device));
- remove_proc_entry(ACPI_PROCESSOR_FILE_LIMIT,
- acpi_device_dir(device));
- remove_proc_entry(acpi_device_bid(device), acpi_processor_dir);
- acpi_device_dir(device) = NULL;
- }
-
- return 0;
-}
-#else
-static inline int acpi_processor_add_fs(struct acpi_device *device)
-{
- return 0;
-}
-static inline int acpi_processor_remove_fs(struct acpi_device *device)
-{
- return 0;
-}
-#endif
-
-/* Use the acpiid in MADT to map cpus in case of SMP */
-
-#ifndef CONFIG_SMP
-static int get_cpu_id(acpi_handle handle, int type, u32 acpi_id) { return -1; }
-#else
-
-static struct acpi_table_madt *madt;
-