#include <asm/percpu.h>
#include <asm/dwarf2.h>
#include <asm/processor-flags.h>
-#include "irq_vectors.h"
+#include <asm/ftrace.h>
+#include <asm/irq_vectors.h>
+
+/* Avoid __ASSEMBLER__'ifying <linux/audit.h> just for this. */
+#include <linux/elf-em.h>
+#define AUDIT_ARCH_I386 (EM_386|__AUDIT_ARCH_LE)
+#define __AUDIT_ARCH_LE 0x40000000
+
+#ifndef CONFIG_AUDITSYSCALL
+#define sysenter_audit syscall_trace_entry
+#define sysexit_audit syscall_exit_work
+#endif
/*
* We use macros for low-level operations which need to be overridden
* for paravirtualization. The following will never clobber any registers:
* INTERRUPT_RETURN (aka. "iret")
* GET_CR0_INTO_EAX (aka. "movl %cr0, %eax")
- * ENABLE_INTERRUPTS_SYSCALL_RET (aka "sti; sysexit").
+ * ENABLE_INTERRUPTS_SYSEXIT (aka "sti; sysexit").
*
* For DISABLE_INTERRUPTS/ENABLE_INTERRUPTS (aka "cli"/"sti"), you must
* specify what registers can be overwritten (CLBR_NONE, CLBR_EAX/EDX/ECX/ANY).
DISABLE_INTERRUPTS(CLBR_ANY) # make sure we don't miss an interrupt
# setting need_resched or sigpending
# between sampling and the iret
+ TRACE_IRQS_OFF
movl TI_flags(%ebp), %ecx
andl $_TIF_WORK_MASK, %ecx # is there any work to be done on
# int/exception return?
GET_THREAD_INFO(%ebp)
/* Note, _TIF_SECCOMP is bit number 8, and so it needs testw and not testb */
- testw $(_TIF_SYSCALL_EMU|_TIF_SYSCALL_TRACE|_TIF_SECCOMP|_TIF_SYSCALL_AUDIT),TI_flags(%ebp)
- jnz syscall_trace_entry
+ testw $_TIF_WORK_SYSCALL_ENTRY,TI_flags(%ebp)
+ jnz sysenter_audit
+sysenter_do_call:
cmpl $(nr_syscalls), %eax
jae syscall_badsys
call *sys_call_table(,%eax,4)
TRACE_IRQS_OFF
movl TI_flags(%ebp), %ecx
testw $_TIF_ALLWORK_MASK, %cx
- jne syscall_exit_work
+ jne sysexit_audit
+sysenter_exit:
/* if something modifies registers it must also disable sysexit */
movl PT_EIP(%esp), %edx
movl PT_OLDESP(%esp), %ecx
xorl %ebp,%ebp
TRACE_IRQS_ON
1: mov PT_FS(%esp), %fs
- ENABLE_INTERRUPTS_SYSCALL_RET
+ ENABLE_INTERRUPTS_SYSEXIT
+
+#ifdef CONFIG_AUDITSYSCALL
+sysenter_audit:
+ testw $(_TIF_WORK_SYSCALL_ENTRY & ~_TIF_SYSCALL_AUDIT),TI_flags(%ebp)
+ jnz syscall_trace_entry
+ addl $4,%esp
+ CFI_ADJUST_CFA_OFFSET -4
+ /* %esi already in 8(%esp) 6th arg: 4th syscall arg */
+ /* %edx already in 4(%esp) 5th arg: 3rd syscall arg */
+ /* %ecx already in 0(%esp) 4th arg: 2nd syscall arg */
+ movl %ebx,%ecx /* 3rd arg: 1st syscall arg */
+ movl %eax,%edx /* 2nd arg: syscall number */
+ movl $AUDIT_ARCH_I386,%eax /* 1st arg: audit arch */
+ call audit_syscall_entry
+ pushl %ebx
+ CFI_ADJUST_CFA_OFFSET 4
+ movl PT_EAX(%esp),%eax /* reload syscall number */
+ jmp sysenter_do_call
+
+sysexit_audit:
+ testw $(_TIF_ALLWORK_MASK & ~_TIF_SYSCALL_AUDIT), %cx
+ jne syscall_exit_work
+ TRACE_IRQS_ON
+ ENABLE_INTERRUPTS(CLBR_ANY)
+ movl %eax,%edx /* second arg, syscall return value */
+ cmpl $0,%eax /* is it < 0? */
+ setl %al /* 1 if so, 0 if not */
+ movzbl %al,%eax /* zero-extend that */
+ inc %eax /* first arg, 0->1(AUDITSC_SUCCESS), 1->2(AUDITSC_FAILURE) */
+ call audit_syscall_exit
+ DISABLE_INTERRUPTS(CLBR_ANY)
+ TRACE_IRQS_OFF
+ movl TI_flags(%ebp), %ecx
+ testw $(_TIF_ALLWORK_MASK & ~_TIF_SYSCALL_AUDIT), %cx
+ jne syscall_exit_work
+ movl PT_EAX(%esp),%eax /* reload syscall return value */
+ jmp sysenter_exit
+#endif
+
CFI_ENDPROC
.pushsection .fixup,"ax"
2: movl $0,PT_FS(%esp)
GET_THREAD_INFO(%ebp)
# system call tracing in operation / emulation
/* Note, _TIF_SECCOMP is bit number 8, and so it needs testw and not testb */
- testw $(_TIF_SYSCALL_EMU|_TIF_SYSCALL_TRACE|_TIF_SECCOMP|_TIF_SYSCALL_AUDIT),TI_flags(%ebp)
+ testw $_TIF_WORK_SYSCALL_ENTRY,TI_flags(%ebp)
jnz syscall_trace_entry
cmpl $(nr_syscalls), %eax
jae syscall_badsys
# setting need_resched or sigpending
# between sampling and the iret
TRACE_IRQS_OFF
- testl $X86_EFLAGS_TF,PT_EFLAGS(%esp) # If tracing set singlestep flag on exit
- jz no_singlestep
- orl $_TIF_SINGLESTEP,TI_flags(%ebp)
-no_singlestep:
movl TI_flags(%ebp), %ecx
testw $_TIF_ALLWORK_MASK, %cx # current->work
jne syscall_exit_work
syscall_trace_entry:
movl $-ENOSYS,PT_EAX(%esp)
movl %esp, %eax
- xorl %edx,%edx
- call do_syscall_trace
- cmpl $0, %eax
- jne resume_userspace # ret != 0 -> running under PTRACE_SYSEMU,
- # so must skip actual syscall
- movl PT_ORIG_EAX(%esp), %eax
+ call syscall_trace_enter
+ /* What it returned is what we'll actually use. */
cmpl $(nr_syscalls), %eax
jnae syscall_call
jmp syscall_exit
# perform syscall exit tracing
ALIGN
syscall_exit_work:
- testb $(_TIF_SYSCALL_TRACE|_TIF_SYSCALL_AUDIT|_TIF_SINGLESTEP), %cl
+ testb $_TIF_WORK_SYSCALL_EXIT, %cl
jz work_pending
TRACE_IRQS_ON
- ENABLE_INTERRUPTS(CLBR_ANY) # could let do_syscall_trace() call
+ ENABLE_INTERRUPTS(CLBR_ANY) # could let syscall_trace_leave() call
# schedule() instead
movl %esp, %eax
- movl $1, %edx
- call do_syscall_trace
+ call syscall_trace_leave
jmp resume_userspace
END(syscall_exit_work)
CFI_ENDPROC
ENTRY(irq_entries_start)
RING0_INT_FRAME
vector=0
-.rept NR_IRQS
+.rept NR_VECTORS
ALIGN
.if vector
CFI_ADJUST_CFA_OFFSET -4
movl $(__USER_DS), %ecx
movl %ecx, %ds
movl %ecx, %es
+ TRACE_IRQS_OFF
movl %esp,%eax # pt_regs pointer
call *%edi
jmp ret_from_exception
RING0_INT_FRAME
pushl $-1 # mark this as an int
CFI_ADJUST_CFA_OFFSET 4
- SAVE_ALL
- GET_CR0_INTO_EAX
- testl $0x4, %eax # EM (math emulation bit)
- jne device_not_available_emulate
- preempt_stop(CLBR_ANY)
- call math_state_restore
- jmp ret_from_exception
-device_not_available_emulate:
- pushl $0 # temporary storage for ORIG_EIP
+ pushl $do_device_not_available
CFI_ADJUST_CFA_OFFSET 4
- call math_emulate
- addl $4, %esp
- CFI_ADJUST_CFA_OFFSET -4
- jmp ret_from_exception
+ jmp error_code
CFI_ENDPROC
END(device_not_available)
pushl $-1 # mark this as an int
CFI_ADJUST_CFA_OFFSET 4
SAVE_ALL
+ TRACE_IRQS_OFF
xorl %edx,%edx # error code 0
movl %esp,%eax # pt_regs pointer
call do_debug
pushl %eax
CFI_ADJUST_CFA_OFFSET 4
SAVE_ALL
+ TRACE_IRQS_OFF
xorl %edx,%edx # zero error code
movl %esp,%eax # pt_regs pointer
call do_nmi
pushl %eax
CFI_ADJUST_CFA_OFFSET 4
SAVE_ALL
+ TRACE_IRQS_OFF
FIXUP_ESPFIX_STACK # %eax == %esp
xorl %edx,%edx # zero error code
call do_nmi
.previous
END(native_iret)
-ENTRY(native_irq_enable_syscall_ret)
+ENTRY(native_irq_enable_sysexit)
sti
sysexit
-END(native_irq_enable_syscall_ret)
+END(native_irq_enable_sysexit)
#endif
KPROBE_ENTRY(int3)
pushl $-1 # mark this as an int
CFI_ADJUST_CFA_OFFSET 4
SAVE_ALL
+ TRACE_IRQS_OFF
xorl %edx,%edx # zero error code
movl %esp,%eax # pt_regs pointer
call do_int3
RING0_INT_FRAME
pushl $0
CFI_ADJUST_CFA_OFFSET 4
- pushl machine_check_vector
+ pushl $do_machine_check
CFI_ADJUST_CFA_OFFSET 4
jmp error_code
CFI_ENDPROC
ENTRY(xen_sysenter_target)
RING0_INT_FRAME
addl $5*4, %esp /* remove xen-provided frame */
+ CFI_ADJUST_CFA_OFFSET -5*4
jmp sysenter_past_esp
+ CFI_ENDPROC
ENTRY(xen_hypervisor_callback)
CFI_STARTPROC
jmp xen_iret_crit_fixup
-1: cmpl $xen_sysexit_start_crit,%eax
- jb 2f
- cmpl $xen_sysexit_end_crit,%eax
- jae 2f
-
- jmp xen_sysexit_crit_fixup
-
ENTRY(xen_do_upcall)
-2: mov %esp, %eax
+1: mov %esp, %eax
call xen_evtchn_do_upcall
jmp ret_from_intr
CFI_ENDPROC
#endif /* CONFIG_XEN */
+#ifdef CONFIG_FTRACE
+#ifdef CONFIG_DYNAMIC_FTRACE
+
+ENTRY(mcount)
+ ret
+END(mcount)
+
+ENTRY(ftrace_caller)
+ pushl %eax
+ pushl %ecx
+ pushl %edx
+ movl 0xc(%esp), %eax
+ movl 0x4(%ebp), %edx
+ subl $MCOUNT_INSN_SIZE, %eax
+
+.globl ftrace_call
+ftrace_call:
+ call ftrace_stub
+
+ popl %edx
+ popl %ecx
+ popl %eax
+
+.globl ftrace_stub
+ftrace_stub:
+ ret
+END(ftrace_caller)
+
+#else /* ! CONFIG_DYNAMIC_FTRACE */
+
+ENTRY(mcount)
+ cmpl $ftrace_stub, ftrace_trace_function
+ jnz trace
+.globl ftrace_stub
+ftrace_stub:
+ ret
+
+ /* taken from glibc */
+trace:
+ pushl %eax
+ pushl %ecx
+ pushl %edx
+ movl 0xc(%esp), %eax
+ movl 0x4(%ebp), %edx
+ subl $MCOUNT_INSN_SIZE, %eax
+
+ call *ftrace_trace_function
+
+ popl %edx
+ popl %ecx
+ popl %eax
+
+ jmp ftrace_stub
+END(mcount)
+#endif /* CONFIG_DYNAMIC_FTRACE */
+#endif /* CONFIG_FTRACE */
+
.section .rodata,"a"
#include "syscall_table_32.S"
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff