* kernel mapped memory. Hopefully neither of these should be a huge
* problem.
*/
-#include <linux/config.h>
#include <linux/types.h>
#include <linux/pci.h>
#include <linux/kernel.h>
#include <linux/mm.h>
#include <linux/console.h>
#include <linux/tty.h>
+#include <linux/vt.h>
#include <asm/io.h>
* Macros for calculating offsets into config space given a device
* structure or dev/fun/reg
*/
-#define CFGOFFSET(bus,devfn,where) (((bus)<<16) + ((devfn)<<8) + (where))
-#define CFGADDR(bus,devfn,where) CFGOFFSET((bus)->number,(devfn),where)
+#define CFGOFFSET(bus, devfn, where) (((bus)<<16) + ((devfn)<<8) + (where))
+#define CFGADDR(bus, devfn, where) CFGOFFSET((bus)->number, (devfn), where)
static void *cfg_space;
#define LDT_BUS_ENABLED 2
#define PCI_DEVICE_MODE 4
-static int sb1250_bus_status = 0;
+static int sb1250_bus_status;
#define PCI_BRIDGE_DEVICE 0
#define LDT_BRIDGE_DEVICE 1
*(u32 *) (cfg_space + (addr & ~3)) = data;
}
-int pcibios_map_irq(struct pci_dev *dev, u8 slot, u8 pin)
+int pcibios_map_irq(const struct pci_dev *dev, u8 slot, u8 pin)
{
return dev->irq;
}
static int __init sb1250_pcibios_init(void)
{
+ void __iomem *io_map_base;
uint32_t cmdreg;
uint64_t reg;
- extern int pci_probe_only;
/* CFE will assign PCI resources */
pci_probe_only = 1;
/*
* See if the PCI bus has been configured by the firmware.
*/
- reg = *((volatile uint64_t *) IOADDR(A_SCD_SYSTEM_CFG));
+ reg = __raw_readq(IOADDR(A_SCD_SYSTEM_CFG));
if (!(reg & M_SYS_PCI_HOST)) {
sb1250_bus_status |= PCI_DEVICE_MODE;
} else {
* works correctly with most of Linux's drivers.
* XXX ehs: Should this happen in PCI Device mode?
*/
-
- set_io_port_base((unsigned long)
- ioremap(A_PHYS_LDTPCI_IO_MATCH_BYTES, 65536));
- isa_slot_offset = (unsigned long)
- ioremap(A_PHYS_LDTPCI_IO_MATCH_BYTES_32, 1024 * 1024);
+ io_map_base = ioremap(A_PHYS_LDTPCI_IO_MATCH_BYTES, 1024 * 1024);
+ sb1250_controller.io_map_base = (unsigned long)io_map_base;
+ set_io_port_base((unsigned long)io_map_base);
#ifdef CONFIG_SIBYTE_HAS_LDT
/*