/*
+ * Copyright 2004-2009 Analog Devices Inc.
+ * 2008-2009 Cambridge Signal Processing
+ * 2005 National ICT Australia (NICTA)
+ * Aidan Williams <aidan@nicta.com.au>
+ *
+ * Licensed under the GPL-2 or later.
*/
#include <linux/device.h>
#endif
#if defined(CONFIG_BFIN_MAC) || defined(CONFIG_BFIN_MAC_MODULE)
+static struct platform_device bfin_mii_bus = {
+ .name = "bfin_mii_bus",
+};
+
static struct platform_device bfin_mac_device = {
.name = "bfin_mac",
+ .dev.platform_data = &bfin_mii_bus,
};
#endif
};
#endif
-#if defined(CONFIG_SPI_MMC) || defined(CONFIG_SPI_MMC_MODULE)
-static struct bfin5xx_spi_chip spi_mmc_chip_info = {
- .enable_dma = 1,
+#if defined(CONFIG_MMC_SPI) || defined(CONFIG_MMC_SPI_MODULE)
+static struct bfin5xx_spi_chip mmc_spi_chip_info = {
+ .enable_dma = 0,
.bits_per_word = 8,
};
#endif
},
#endif
-#if defined(CONFIG_SPI_MMC) || defined(CONFIG_SPI_MMC_MODULE)
- {
- .modalias = "spi_mmc_dummy",
- .max_speed_hz = 5000000, /* max spi clock (SCK) speed in HZ */
- .bus_num = 0,
- .chip_select = 0,
- .platform_data = NULL,
- .controller_data = &spi_mmc_chip_info,
- .mode = SPI_MODE_3,
- },
+#if defined(CONFIG_MMC_SPI) || defined(CONFIG_MMC_SPI_MODULE)
{
- .modalias = "spi_mmc",
+ .modalias = "mmc_spi",
.max_speed_hz = 5000000, /* max spi clock (SCK) speed in HZ */
.bus_num = 0,
- .chip_select = CONFIG_SPI_MMC_CS_CHAN,
- .platform_data = NULL,
- .controller_data = &spi_mmc_chip_info,
+ .chip_select = 5,
+ .controller_data = &mmc_spi_chip_info,
.mode = SPI_MODE_3,
},
#endif
[1] = {
.start = CH_SPI,
.end = CH_SPI,
+ .flags = IORESOURCE_DMA,
+ },
+ [2] = {
+ .start = IRQ_SPI,
+ .end = IRQ_SPI,
.flags = IORESOURCE_IRQ,
},
};
#endif
#if defined(CONFIG_BFIN_SIR) || defined(CONFIG_BFIN_SIR_MODULE)
-static struct resource bfin_sir_resources[] = {
#ifdef CONFIG_BFIN_SIR0
+static struct resource bfin_sir0_resources[] = {
{
.start = 0xFFC00400,
.end = 0xFFC004FF,
.flags = IORESOURCE_MEM,
},
+ {
+ .start = IRQ_UART0_RX,
+ .end = IRQ_UART0_RX+1,
+ .flags = IORESOURCE_IRQ,
+ },
+ {
+ .start = CH_UART0_RX,
+ .end = CH_UART0_RX+1,
+ .flags = IORESOURCE_DMA,
+ },
+};
+
+static struct platform_device bfin_sir0_device = {
+ .name = "bfin_sir",
+ .id = 0,
+ .num_resources = ARRAY_SIZE(bfin_sir0_resources),
+ .resource = bfin_sir0_resources,
+};
#endif
#ifdef CONFIG_BFIN_SIR1
+static struct resource bfin_sir1_resources[] = {
{
.start = 0xFFC02000,
.end = 0xFFC020FF,
.flags = IORESOURCE_MEM,
},
-#endif
+ {
+ .start = IRQ_UART1_RX,
+ .end = IRQ_UART1_RX+1,
+ .flags = IORESOURCE_IRQ,
+ },
+ {
+ .start = CH_UART1_RX,
+ .end = CH_UART1_RX+1,
+ .flags = IORESOURCE_DMA,
+ },
};
-static struct platform_device bfin_sir_device = {
+static struct platform_device bfin_sir1_device = {
.name = "bfin_sir",
- .id = 0,
- .num_resources = ARRAY_SIZE(bfin_sir_resources),
- .resource = bfin_sir_resources,
+ .id = 1,
+ .num_resources = ARRAY_SIZE(bfin_sir1_resources),
+ .resource = bfin_sir1_resources,
};
#endif
+#endif
#if defined(CONFIG_I2C_BLACKFIN_TWI) || defined(CONFIG_I2C_BLACKFIN_TWI_MODULE)
static struct resource bfin_twi0_resource[] = {
#endif
#if defined(CONFIG_BFIN_MAC) || defined(CONFIG_BFIN_MAC_MODULE)
+ &bfin_mii_bus,
&bfin_mac_device,
#endif
#endif
#if defined(CONFIG_BFIN_SIR) || defined(CONFIG_BFIN_SIR_MODULE)
- &bfin_sir_device,
+#ifdef CONFIG_BFIN_SIR0
+ &bfin_sir0_device,
+#endif
+#ifdef CONFIG_BFIN_SIR1
+ &bfin_sir1_device,
+#endif
#endif
#if defined(CONFIG_I2C_BLACKFIN_TWI) || defined(CONFIG_I2C_BLACKFIN_TWI_MODULE)
{
/* workaround reboot hang when booting from SPI */
if ((bfin_read_SYSCR() & 0x7) == 0x3)
- bfin_gpio_reset_spi0_ssel1();
+ bfin_reset_boot_spi_cs(P_DEFAULT_BOOT_SPI_CS);
}