Driver core: device_attribute parameters can often be const*

[safe/jmp/linux-2.6] / Documentation / kernel-parameters.txt

diff --git a/Documentation/kernel-parameters.txt b/Documentation/kernel-parameters.txt
index 3f886e2..5ba4d9d 100644 (file)
--- a/Documentation/kernel-parameters.txt
+++ b/Documentation/kernel-parameters.txt
@@ -1032,7 +1032,7 @@ and is between 256 and 4096 characters. It is defined in the file
                        No delay
 
        ip=             [IP_PNP]
-                       See Documentation/filesystems/nfsroot.txt.
+                       See Documentation/filesystems/nfs/nfsroot.txt.
 
        ip2=            [HW] Set IO/IRQ pairs for up to 4 IntelliPort boards
                        See comment before ip2_setup() in
@@ -1553,10 +1553,10 @@ and is between 256 and 4096 characters. It is defined in the file
                        going to be removed in 2.6.29.
 
        nfsaddrs=       [NFS]
-                       See Documentation/filesystems/nfsroot.txt.
+                       See Documentation/filesystems/nfs/nfsroot.txt.
 
        nfsroot=        [NFS] nfs root filesystem for disk-less boxes.
-                       See Documentation/filesystems/nfsroot.txt.
+                       See Documentation/filesystems/nfs/nfsroot.txt.
 
        nfs.callback_tcpport=
                        [NFS] set the TCP port on which the NFSv4 callback
@@ -1787,6 +1787,11 @@ and is between 256 and 4096 characters. It is defined in the file
                        waiting for the ACK, so if this is set too high
                        interrupts *may* be lost!
 
+       omap_mux=       [OMAP] Override bootloader pin multiplexing.
+                       Format: <mux_mode0.mode_name=value>...
+                       For example, to override I2C bus2:
+                       omap_mux=i2c2_scl.i2c2_scl=0x100,i2c2_sda.i2c2_sda=0x100
+
        opl3=           [HW,OSS]
                        Format: <io>
 
@@ -2724,6 +2729,11 @@ and is between 256 and 4096 characters. It is defined in the file
        vmpoff=         [KNL,S390] Perform z/VM CP command after power off.
                        Format: <command>
 
+       vt.cur_default= [VT] Default cursor shape.
+                       Format: 0xCCBBAA, where AA, BB, and CC are the same as
+                       the parameters of the <Esc>[?A;B;Cc escape sequence;
+                       see VGA-softcursor.txt. Default: 2 = underline.
+
        vt.default_blu= [VT]
                        Format: <blue0>,<blue1>,<blue2>,...,<blue15>
                        Change the default blue palette of the console.