mm: add numa node symlink for memory section in sysfs

[safe/jmp/linux-2.6] / Documentation / cpu-hotplug.txt

diff --git a/Documentation/cpu-hotplug.txt b/Documentation/cpu-hotplug.txt
index fb94f5a..4d4a644 100644 (file)
--- a/Documentation/cpu-hotplug.txt
+++ b/Documentation/cpu-hotplug.txt
@@ -49,25 +49,27 @@ maxcpus=n    Restrict boot time cpus to n. Say if you have 4 cpus, using
 additional_cpus=n (*)  Use this to limit hotpluggable cpus. This option sets
                        cpu_possible_map = cpu_present_map + additional_cpus
 
-(*) Option valid only for following architectures
-- x86_64, ia64, s390
+cede_offline={"off","on"}  Use this option to disable/enable putting offlined
+                           processors to an extended H_CEDE state on
+                           supported pseries platforms.
+                           If nothing is specified,
+                           cede_offline is set to "on".
 
-ia64 and x86_64 use the number of disabled local apics in ACPI tables MADT
-to determine the number of potentially hot-pluggable cpus. The implementation
-should only rely on this to count the # of cpus, but *MUST* not rely on the
-apicid values in those tables for disabled apics. In the event BIOS doesn't
-mark such hot-pluggable cpus as disabled entries, one could use this
-parameter "additional_cpus=x" to represent those cpus in the cpu_possible_map.
+(*) Option valid only for following architectures
+- ia64
 
-s390 uses the number of cpus it detects at IPL time to also the number of bits
-in cpu_possible_map. If it is desired to add additional cpus at a later time
-the number should be specified using this option or the possible_cpus option.
+ia64 uses the number of disabled local apics in ACPI tables MADT to
+determine the number of potentially hot-pluggable cpus. The implementation
+should only rely on this to count the # of cpus, but *MUST* not rely
+on the apicid values in those tables for disabled apics. In the event
+BIOS doesn't mark such hot-pluggable cpus as disabled entries, one could
+use this parameter "additional_cpus=x" to represent those cpus in the
+cpu_possible_map.
 
-possible_cpus=n                [s390 only] use this to set hotpluggable cpus.
+possible_cpus=n                [s390,x86_64] use this to set hotpluggable cpus.
                        This option sets possible_cpus bits in
                        cpu_possible_map. Thus keeping the numbers of bits set
                        constant even if the machine gets rebooted.
-                       This option overrides additional_cpus.
 
 CPU maps and such
 -----------------