sh: Correct the offset of the return address in ret_from_exception
[safe/jmp/linux-2.6] / arch / arm / mach-omap2 /
2010-02-03 Tony Lindgrenomap: Disable serial port autoidle by default
2010-02-03 Tony Lindgrenomap: Fix arch/arm/mach-omap2/mux.c: Off by one error
2010-02-03 Tony Lindgrenomap: Fix 3630 mux errors
2010-02-03 Kevin HilmanOMAP2/3: GPMC: ensure valid clock pointer
2010-02-03 Kevin HilmanOMAP2/3: IRQ: ensure valid base address
2010-01-21 Tony LindgrenMerge branch 'omap-fixes' into omap-fixes-for-linus
2010-01-21 Tony LindgrenMerge branch 'pm-fixes' of /linux/kernel/git/khilman...
2010-01-21 Sergio AguirrePM debug: Fix warning when no CONFIG_DEBUG_FS
2010-01-21 Subramani VenkateshOMAP3: PM: DSS PM_WKEN to refill DMA
2010-01-21 Tero KristoOMAP3: PM: Force write last pad config register into...
2010-01-21 Roel KluinOMAP: omap3_pm_get_suspend_state() error ignored in...
2010-01-21 Peter UjfalusiOMAP3: PM: Enable wake-up from McBSP2, 3 and 4 modules
2010-01-21 Manjunatha GKOMAP3: PM debug: fix build error when !CONFIG_DEBUG_FS
2010-01-21 Sripathy, VishwanathOMAP3: PM: Removing redundant and potentially dangerous...
2010-01-21 Tero KristoOMAP3: Fixed ARM aux ctrl register save/restore
2010-01-21 Tero KristoOMAP3: CPUidle: Fixed timer resolution
2010-01-21 Sanjeev PremiOMAP3: PM: Remove duplicate code blocks
2010-01-21 Tero KristoOMAP3: PM: Disable interrupt controller AUTOIDLE before WFI
2010-01-21 Tero KristoOMAP3: PM: Enable system control module autoidle
2010-01-21 Tero KristoOMAP3: PM: Ack pending interrupts before entering suspend
2010-01-21 Olof Johanssonomap: Enable GPMC clock in gpmc_init
2010-01-20 Rajendra NayakOMAP4: clocks: Fix the clksel_rate struct DPLL divs
2010-01-20 Rajendra NayakOMAP4: PRCM: Fix the base address for CHIRONSS reg...
2010-01-20 Tony Lindgrenomap3: Fix cpu detection
2010-01-20 Tony Lindgrenomap: Fix functions for dynamic remuxing of pins
2010-01-20 Tony Lindgrenomap: Fix cmdline muxing
2010-01-20 Russell KingOMAP3: clock: Remove unnecessarily .init initializers...
2010-01-20 Thara GopinathOMAP3: hwmod: Adding flag to prevent caching of sysconf...
2010-01-08 Tony LindgrenMerge branch 'for_2.6.33rc_c' of git://git.pwsan.com...
2010-01-08 Paul WalmsleyOMAP2 clock: dynamically allocate CPUFreq frequency...
2010-01-08 Paul WalmsleyOMAP2xxx OPP: clean up comments in OPP data
2010-01-08 Felipe BalbiOMAP2xxx clock: clk2xxx.c doesn't compile if CPUFREQ...
2010-01-08 Tuukka ToivonenOMAP3 clock: Add capability to change rate of dpll4_m5_ck
2010-01-08 Paul WalmsleyOMAP3 clock: McBSP 2, 3, 4 functional clock parent...
2010-01-08 Kevin HilmanOMAP3: clock: add clockdomains for UART1 & 2
2010-01-08 Paul WalmsleyOMAP2xxx IO mapping: mark DSP mappings as being 2420...
2010-01-08 Abhijit PagareARM: OMAP3: PM: Fix the Invalid CM_CLKSTCTRL reg access.
2010-01-08 Huang WeiyiOMAP2: remove duplicated #include
2010-01-08 Vaibhav Hiremathomap3: EVM: Choose OMAP_PACKAGE_CBB
2010-01-08 Tony Lindgrenomap3: Fix booting if package is uninitialized
2010-01-08 Roel Kluinomap3: add missing parentheses
2010-01-08 Vimal Singhomap2/3: ZOOM: Correcting key mapping for few keys
2010-01-08 Alexander Shishkinomap2/3: make serial_in_override() address the right...
2009-12-16 Mika WesterbergOMAP3: serial - fix bug introduced in
2009-12-16 Balaji T Kmfd: twl: fix twl4030 rename for remaining driver,...
2009-12-15 Olof Johanssonomap3: Allow EHCI to be built on OMAP3
2009-12-13 Santosh Shilimkarmfd: Rename twl4030* driver files to enable re-use
2009-12-13 Amit Kucheriamfd: Optimised twl4030-power power scripts for the...
2009-12-12 vikram panditaomap: serial: fix non-empty uart fifo read abort
2009-12-12 Madhusudhan Chikkatureomap3: Zoom2/3: Update hsmmc board config params
2009-12-12 Sergey Lapinomap3: id code detection 3525 vs 3515
2009-12-12 Kalle Valoomap3: rx51: Use wl1251 in SPI mode 3
2009-12-12 Anand Gadiyaromap3: zoom2/3: make MMC slot work again
2009-12-12 Mika WesterbergOMAP3: serial - allow platforms specify which UARTs...
2009-12-12 Mike Rapoportomap3: cm-t35: add mux initialization
2009-12-12 Santosh ShilimkarOMAP4: Remove the secondary wait loop
2009-12-12 Santosh ShilimkarOMAP4: AuxCoreBoot registers only accessible in secure...
2009-12-12 Santosh ShilimkarOMAP4: Fix cpu detection
2009-12-12 Grazvydas Ignotasomap3: pandora: board file updates for .33
2009-12-12 Gregoire Gentilomap3: Board file of Always Innovating OMAP3-based...
2009-12-12 Ladislav Michlomap: use smc91x_platdata to setup smc91x
2009-12-12 Tony Lindgrenomap: mux: Add 36xx CBP package support
2009-12-12 Tony Lindgrenomap: mux: Remove old mux code for 34xx
2009-12-12 Tony Lindgrenomap: mux: Replace omap_cfg_reg() with new style signal...
2009-12-12 Tony Lindgrenomap: Split i2c platform init for mach-omap1 and mach...
2009-12-12 Tony Lindgrenomap: mux: Add debugfs support for new mux code
2009-12-12 Tony Lindgrenomap: mux: Add new style init functions to omap3 board...
2009-12-12 Tony Lindgrenomap: mux: Add new style pin multiplexing data for...
2009-12-12 Tony Lindgrenomap: mux: Add new style pin multiplexing code for...
2009-12-12 Mike Rapoportomap2: mux: intoduce omap_mux_{read,write}
2009-12-12 Rajendra NayakARM: OMAP4: PM: Add init api for DPLL nodes
2009-12-12 Rajendra NayakARM: OMAP4: PM: Add support for OMAP4 dpll api's
2009-12-12 Rajendra NayakARM: OMAP4: PM: Move DPLL control apis to dpll.c
2009-12-12 Rajendra NayakARM: OMAP4: PM: Add dummy hooks for OMAP4 dpll api's
2009-12-12 Rajendra NayakARM: OMAP4: PM: OMAP4 clock tree and clkdev registration
2009-12-12 Rajendra NayakARM: OMAP4: PM: Adds CM1/2 register field masks
2009-12-12 Rajendra NayakARM: OMAP4: PM: Adds PRM register shift and mask bits
2009-12-12 Rajendra NayakARM: OMAP4: PM: Adds PRM register defs for OMAP4
2009-12-12 Rajendra NayakARM: OMAP4: PM: Adds CM1/2 register defs for OMAP4
2009-12-12 Rajendra NayakARM: OMAP4: PM: PRM/CM module offsets for OMAP4
2009-12-12 Rajendra NayakARM: OMAP4: PM: Fix the PRM and CM base addresses
2009-12-12 Kevin HilmanOMAP: hwmod: warn on missing clockdomain
2009-12-12 Paul WalmsleyOMAP3 hwmod: drop most of the OCP_SYSCONFIG.CLOCKACTIVI...
2009-12-12 Paul WalmsleyOMAP hwmod: add names to module MPU IRQ lines
2009-12-12 Paul WalmsleyOMAP3 hwmod: Add automatic OCP_SYSCONFIG AUTOIDLE handling
2009-12-12 Paul WalmsleyOMAP3 hwmod: reprogram OCP_SYSCONFIG register after...
2009-12-12 Paul WalmsleyOMAP clock/hwmod: fix off-by-one errors
2009-12-12 Thara GopinathOMAP3: PM: Fix for MPU power domain MEM BANK position
2009-12-12 Paul WalmsleyOMAP3: SDRC: Place SDRC AC timing and MR changes in...
2009-12-12 Roel KluinOMAP2/3 powerdomain: return errors rather than returnin...
2009-12-12 Paul WalmsleyOMAP powerdomain/PM: use symbolic constants for the...
2009-12-12 Paul WalmsleyOMAP clockdomain/powerdomain: optimize out sleepdep...
2009-12-12 Paul WalmsleyOMAP clockdomain/powerdomain: remove CONFIG_OMAP_DEBUG_...
2009-12-12 Paul WalmsleyOMAP2/3 PRCM: don't export prm_*(), cm_*() functions
2009-12-11 Paul WalmsleyOMAP2 clock: convert clock24xx.h to clock2xxx_data...
2009-12-11 Paul WalmsleyOMAP3 clock: convert clock34xx.h to clock34xx_data.c
2009-12-11 Paul WalmsleyOMAP2xxx clock: remove implicit dependency between...
2009-12-11 Paul WalmsleyOMAP2/3: move SDRC macros to mach-omap2/sdrc.h
2009-12-11 Paul WalmsleyOMAP2 clock: APLL code shouldn't rely on static clocks...
2009-12-11 Paul WalmsleyOMAP1/2/3 clock: remove paranoid checks in preparation...
next