From: Ian Abbott Date: Fri, 29 Jul 2005 19:16:31 +0000 (-0700) Subject: [PATCH] USB: ftdi_sio: new microHAM and Evolution Robotics devices X-Git-Tag: v2.6.13-rc5~83 X-Git-Url: http://ftp.safe.ca/?a=commitdiff_plain;h=9b1513d91e195af46b8e59626f74d3d41a7565af;p=safe%2Fjmp%2Flinux-2.6 [PATCH] USB: ftdi_sio: new microHAM and Evolution Robotics devices The attached patch adds the following new devices to the ftdi_sio driver: * microHAM USB-Y6 and USB-Y8 devices submitted by Justin Burket (KL1RL). * Evolution Robotics ER1 Control Module submitted by Shawn M. Lavelle. Signed-off-by: Ian Abbott Signed-off-by: Greg Kroah-Hartman Signed-off-by: Linus Torvalds --- diff --git a/drivers/usb/serial/ftdi_sio.c b/drivers/usb/serial/ftdi_sio.c index 0b03dda..cfb77ce 100644 --- a/drivers/usb/serial/ftdi_sio.c +++ b/drivers/usb/serial/ftdi_sio.c @@ -429,6 +429,9 @@ static struct usb_device_id id_table_combined [] = { { USB_DEVICE(FTDI_VID, FTDI_4N_GALAXY_DE_2_PID) }, { USB_DEVICE(MOBILITY_VID, MOBILITY_USB_SERIAL_PID) }, { USB_DEVICE(FTDI_VID, FTDI_ACTIVE_ROBOTS_PID) }, + { USB_DEVICE(FTDI_VID, FTDI_MHAM_Y6_PID) }, + { USB_DEVICE(FTDI_VID, FTDI_MHAM_Y8_PID) }, + { USB_DEVICE(EVOLUTION_VID, EVOLUTION_ER1_PID) }, { } /* Terminating entry */ }; diff --git a/drivers/usb/serial/ftdi_sio.h b/drivers/usb/serial/ftdi_sio.h index 8866376..9f43420 100644 --- a/drivers/usb/serial/ftdi_sio.h +++ b/drivers/usb/serial/ftdi_sio.h @@ -265,10 +265,24 @@ #define MOBILITY_USB_SERIAL_PID 0x0202 /* EasiDock USB 200 serial */ /* + * microHAM product IDs (http://www.microham.com). + * Submitted by Justin Burket (KL1RL) . + */ +#define FTDI_MHAM_Y6_PID 0xEEEA /* USB-Y6 interface */ +#define FTDI_MHAM_Y8_PID 0xEEEB /* USB-Y8 interface */ + +/* * Active Robots product ids. */ #define FTDI_ACTIVE_ROBOTS_PID 0xE548 /* USB comms board */ +/* + * Evolution Robotics products (http://www.evolution.com/). + * Submitted by Shawn M. Lavelle. + */ +#define EVOLUTION_VID 0xDEEE /* Vendor ID */ +#define EVOLUTION_ER1_PID 0x0300 /* ER1 Control Module */ + /* Commands */ #define FTDI_SIO_RESET 0 /* Reset the port */ #define FTDI_SIO_MODEM_CTRL 1 /* Set the modem control register */