avr32: configure MCI detect and write protect pins for EVKLCD10x boards

This patch removes the special handling of MCI platform data for
EVKLCD10x boards. This is now possible since the pin mask for the LCD
controller is no longer reserving the I/O lines used for MCI card
detection and write protect.

Signed-off-by: Hans-Christian Egtvedt <hans-christian.egtvedt@atmel.com>
Signed-off-by: Haavard Skinnemoen <haavard.skinnemoen@atmel.com>

diff --git a/arch/avr32/boards/atngw100/setup.c b/arch/avr32/boards/atngw100/setup.c
index 05d3722..feac003 100644 (file)
--- a/arch/avr32/boards/atngw100/setup.c
+++ b/arch/avr32/boards/atngw100/setup.c
@@ -56,13 +56,8 @@ static struct spi_board_info spi0_board_info[] __initdata = {
 static struct mci_platform_data __initdata mci0_data = {
        .slot[0] = {
                .bus_width      = 4,
-#ifndef CONFIG_BOARD_ATNGW100_EVKLCD10X
                .detect_pin     = GPIO_PIN_PC(25),
                .wp_pin         = GPIO_PIN_PE(0),
-#else
-               .detect_pin     = GPIO_PIN_NONE,
-               .wp_pin         = GPIO_PIN_NONE,
-#endif
        },
 };