[SCSI] libiscsi: Use SCSI_MLQUEUE_TARGET_BUSY

For the conditions below we do not want the queuecommand
function to call us right back, so return SCSI_MLQUEUE_TARGET_BUSY.

Signed-off-by: Mike Christie <michaelc@cs.wisc.edu>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

diff --git a/drivers/scsi/libiscsi.c b/drivers/scsi/libiscsi.c
index da7b67d..521dbf7 100644 (file)
--- a/drivers/scsi/libiscsi.c
+++ b/drivers/scsi/libiscsi.c
@@ -1194,12 +1194,10 @@ int iscsi_queuecommand(struct scsi_cmnd *sc, void (*done)(struct scsi_cmnd *))
                switch (session->state) {
                case ISCSI_STATE_IN_RECOVERY:
                        reason = FAILURE_SESSION_IN_RECOVERY;
-                       sc->result = DID_IMM_RETRY << 16;
-                       break;
+                       goto reject;
                case ISCSI_STATE_LOGGING_OUT:
                        reason = FAILURE_SESSION_LOGGING_OUT;
-                       sc->result = DID_IMM_RETRY << 16;
-                       break;
+                       goto reject;
                case ISCSI_STATE_RECOVERY_FAILED:
                        reason = FAILURE_SESSION_RECOVERY_TIMEOUT;
                        sc->result = DID_NO_CONNECT << 16;
@@ -1267,7 +1265,7 @@ reject:
        spin_unlock(&session->lock);
        debug_scsi("cmd 0x%x rejected (%d)\n", sc->cmnd[0], reason);
        spin_lock(host->host_lock);
-       return SCSI_MLQUEUE_HOST_BUSY;
+       return SCSI_MLQUEUE_TARGET_BUSY;
 
 fault:
        spin_unlock(&session->lock);