Staging: et131x: tidy up a bit further

Clean up the minor uglies left from the previous work

Signed-off-by: Alan Cox <alan@linux.intel.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@suse.de>

diff --git a/drivers/staging/et131x/et1310_tx.c b/drivers/staging/et131x/et1310_tx.c
index 4aabfa3..5fe72ba 100644 (file)
--- a/drivers/staging/et131x/et1310_tx.c
+++ b/drivers/staging/et131x/et1310_tx.c
@@ -94,7 +94,6 @@
 #include "et1310_tx.h"
 
 
-static void et131x_update_tcb_list(struct et131x_adapter *etdev);
 static inline void et131x_free_send_packet(struct et131x_adapter *etdev,
                                           struct tcb *tcb);
 static int et131x_send_packet(struct sk_buff *skb,
@@ -230,15 +229,10 @@ void ConfigTxDmaRegs(struct et131x_adapter *etdev)
        /* Initialise the transmit DMA engine */
        writel(NUM_DESC_PER_RING_TX - 1, &txdma->pr_num_des.value);
 
-       /* Load the completion writeback physical address
-        *
-        * NOTE: pci_alloc_consistent(), used above to alloc DMA regions,
-        * ALWAYS returns SAC (32-bit) addresses. If DAC (64-bit) addresses
-        * are ever returned, make sure the high part is retrieved here before
-        * storing the adjusted address.
-        */
-       writel(0, &txdma->dma_wb_base_hi);
-       writel(etdev->tx_ring.pTxStatusPa, &txdma->dma_wb_base_lo);
+       /* Load the completion writeback physical address */
+       writel((u32)((u64)etdev->tx_ring.pTxStatusPa >> 32),
+                                               &txdma->dma_wb_base_hi);
+       writel((u32)etdev->tx_ring.pTxStatusPa, &txdma->dma_wb_base_lo);
 
        memset(etdev->tx_ring.pTxStatusVa, 0, sizeof(TX_STATUS_BLOCK_t));
 
@@ -279,7 +273,7 @@ void et131x_tx_dma_enable(struct et131x_adapter *etdev)
 void et131x_init_send(struct et131x_adapter *adapter)
 {
        struct tcb *tcb;
-       u32 count;
+       u32 ct;
        struct tx_ring *tx_ring;
 
        /* Setup some convenience pointers */
@@ -289,23 +283,22 @@ void et131x_init_send(struct et131x_adapter *adapter)
        tx_ring->TCBReadyQueueHead = tcb;
 
        /* Go through and set up each TCB */
-       for (count = 0; count < NUM_TCB; count++) {
+       for (ct = 0; ct < NUM_TCB; ct++) {
                memset(tcb, 0, sizeof(struct tcb));
 
                /* Set the link pointer in HW TCB to the next TCB in the
                 * chain.  If this is the last TCB in the chain, also set the
                 * tail pointer.
                 */
-               if (count < NUM_TCB - 1) {
+               if (ct < NUM_TCB - 1)
                        tcb->Next = tcb + 1;
-               } else {
+               else {
                        tx_ring->TCBReadyQueueTail = tcb;
                        tcb->Next = NULL;
                }
 
                tcb++;
        }
-
        /* Curr send queue should now be empty */
        tx_ring->CurrSendHead = NULL;
        tx_ring->CurrSendTail = NULL;
@@ -332,7 +325,7 @@ int et131x_send_packets(struct sk_buff *skb, struct net_device *netdev)
         */
 
        /* TCB is not available */
-       if (MP_TCB_RESOURCES_NOT_AVAILABLE(etdev)) {
+       if (etdev->tx_ring.nBusySend >= NUM_TCB) {
                /* NOTE: If there's an error on send, no need to queue the
                 * packet under Linux; if we just send an error up to the
                 * netif layer, it will resend the skb to us.
@@ -342,26 +335,15 @@ int et131x_send_packets(struct sk_buff *skb, struct net_device *netdev)
                /* We need to see if the link is up; if it's not, make the
                 * netif layer think we're good and drop the packet
                 */
-               /*
-                * if( MP_SHOULD_FAIL_SEND( etdev ) ||
-                *  etdev->DriverNoPhyAccess )
-                */
-               if (MP_SHOULD_FAIL_SEND(etdev) || !netif_carrier_ok(netdev)) {
+               if ((etdev->Flags & fMP_ADAPTER_FAIL_SEND_MASK) ||
+                                       !netif_carrier_ok(netdev)) {
                        dev_kfree_skb_any(skb);
                        skb = NULL;
 
                        etdev->net_stats.tx_dropped++;
                } else {
                        status = et131x_send_packet(skb, etdev);
-
-                       if (status == -ENOMEM) {
-
-                               /* NOTE: If there's an error on send, no need
-                                * to queue the packet under Linux; if we just
-                                * send an error up to the netif layer, it
-                                * will resend the skb to us.
-                                */
-                       } else if (status != 0) {
+                       if (status != 0 && status != -ENOMEM) {
                                /* On any other error, make netif think we're
                                 * OK and drop the packet
                                 */
@@ -386,7 +368,7 @@ int et131x_send_packets(struct sk_buff *skb, struct net_device *netdev)
 static int et131x_send_packet(struct sk_buff *skb,
                              struct et131x_adapter *etdev)
 {
-       int status = 0;
+       int status;
        struct tcb *tcb = NULL;
        u16 *shbufva;
        unsigned long flags;
@@ -429,8 +411,7 @@ static int et131x_send_packet(struct sk_buff *skb,
        tcb->Next = NULL;
 
        /* Call the NIC specific send handler. */
-       if (status == 0)
-               status = nic_send_packet(etdev, tcb);
+       status = nic_send_packet(etdev, tcb);
 
        if (status != 0) {
                spin_lock_irqsave(&etdev->TCBReadyQLock, flags);
@@ -725,12 +706,11 @@ inline void et131x_free_send_packet(struct et131x_adapter *etdev,
 
        etdev->Stats.opackets++;
 
-       if (etdev->tx_ring.TCBReadyQueueTail) {
+       if (etdev->tx_ring.TCBReadyQueueTail)
                etdev->tx_ring.TCBReadyQueueTail->Next = tcb;
-       } else {
+       else
                /* Apparently ready Q is empty. */
                etdev->tx_ring.TCBReadyQueueHead = tcb;
-       }
 
        etdev->tx_ring.TCBReadyQueueTail = tcb;
 
@@ -747,7 +727,6 @@ inline void et131x_free_send_packet(struct et131x_adapter *etdev,
 void et131x_free_busy_send_packets(struct et131x_adapter *etdev)
 {
        struct tcb *tcb;
-       struct list_head *entry;
        unsigned long flags;
        u32 freed = 0;
 
@@ -794,20 +773,6 @@ void et131x_free_busy_send_packets(struct et131x_adapter *etdev)
  */
 void et131x_handle_send_interrupt(struct et131x_adapter *etdev)
 {
-       /* Mark as completed any packets which have been sent by the device. */
-       et131x_update_tcb_list(etdev);
-}
-
-/**
- * et131x_update_tcb_list - Helper routine for Send Interrupt handler
- * @etdev: pointer to our adapter
- *
- * Re-claims the send resources and completes sends.  Can also be called as
- * part of the NIC send routine when the "ServiceComplete" indication has
- * wrapped.
- */
-static void et131x_update_tcb_list(struct et131x_adapter *etdev)
-{
        unsigned long flags;
        u32 serviced;
        struct tcb * tcb;

diff --git a/drivers/staging/et131x/et131x_adapter.h b/drivers/staging/et131x/et131x_adapter.h
index a512f62..cc5a6ba 100644 (file)
--- a/drivers/staging/et131x/et131x_adapter.h
+++ b/drivers/staging/et131x/et131x_adapter.h
@@ -100,12 +100,6 @@
 #define LO_MARK_PERCENT_FOR_PSR     15
 #define LO_MARK_PERCENT_FOR_RX      15
 
-/* Macros specific to the private adapter structure */
-#define MP_TCB_RESOURCES_AVAILABLE(_M) ((_M)->tx_ring.nBusySend < NUM_TCB)
-#define MP_TCB_RESOURCES_NOT_AVAILABLE(_M) ((_M)->tx_ring.nBusySend >= NUM_TCB)
-
-#define MP_SHOULD_FAIL_SEND(_M)   ((_M)->Flags & fMP_ADAPTER_FAIL_SEND_MASK)
-
 /* Counters for error rate monitoring */
 typedef struct _MP_ERR_COUNTERS {
        u32 PktCountTxPackets;