* elements. Allow each command to have at least one ADV_SG_BLOCK structure.
* This allows about 15 commands to have the maximum 17 ADV_SG_BLOCK
* structures or 255 scatter-gather elements.
- *
*/
#define ADV_TOT_SG_BLOCK ASC_DEF_MAX_HOST_QNG
/*
- * Define Adv Library required maximum number of scatter-gather
- * elements per request.
+ * Define maximum number of scatter-gather elements per request.
*/
#define ADV_MAX_SG_LIST 255
+#define NO_OF_SG_PER_BLOCK 15
/* Number of SG blocks needed. */
#define ADV_NUM_SG_BLOCK \
struct adv_dvc_var;
struct adv_scsi_req_q;
-/*
- * Adapter operation variable structure.
- *
- * One structure is required per host adapter.
- *
- * Field naming convention:
- *
- * *_able indicates both whether a feature should be enabled or disabled
- * and whether a device isi capable of the feature. At initialization
- * this field may be set, but later if a device is found to be incapable
- * of the feature, the field is cleared.
- */
-typedef struct adv_dvc_var {
- AdvPortAddr iop_base; /* I/O port address */
- ushort err_code; /* fatal error code */
- ushort bios_ctrl; /* BIOS control word, EEPROM word 12 */
- ushort wdtr_able; /* try WDTR for a device */
- ushort sdtr_able; /* try SDTR for a device */
- ushort ultra_able; /* try SDTR Ultra speed for a device */
- ushort sdtr_speed1; /* EEPROM SDTR Speed for TID 0-3 */
- ushort sdtr_speed2; /* EEPROM SDTR Speed for TID 4-7 */
- ushort sdtr_speed3; /* EEPROM SDTR Speed for TID 8-11 */
- ushort sdtr_speed4; /* EEPROM SDTR Speed for TID 12-15 */
- ushort tagqng_able; /* try tagged queuing with a device */
- ushort ppr_able; /* PPR message capable per TID bitmask. */
- uchar max_dvc_qng; /* maximum number of tagged commands per device */
- ushort start_motor; /* start motor command allowed */
- uchar scsi_reset_wait; /* delay in seconds after scsi bus reset */
- uchar chip_no; /* should be assigned by caller */
- uchar max_host_qng; /* maximum number of Q'ed command allowed */
- ushort no_scam; /* scam_tolerant of EEPROM */
- struct asc_board *drv_ptr; /* driver pointer to private structure */
- uchar chip_scsi_id; /* chip SCSI target ID */
- uchar chip_type;
- uchar bist_err_code;
- ADV_CARR_T *carrier_buf;
- ADV_CARR_T *carr_freelist; /* Carrier free list. */
- ADV_CARR_T *icq_sp; /* Initiator command queue stopper pointer. */
- ADV_CARR_T *irq_sp; /* Initiator response queue stopper pointer. */
- ushort carr_pending_cnt; /* Count of pending carriers. */
- /*
- * Note: The following fields will not be used after initialization. The
- * driver may discard the buffer after initialization is done.
- */
- ADV_DVC_CFG *cfg; /* temporary configuration structure */
-} ADV_DVC_VAR;
-
-#define NO_OF_SG_PER_BLOCK 15
-
typedef struct asc_sg_block {
uchar reserved1;
uchar reserved2;
} ADV_SCSI_REQ_Q;
/*
+ * The following two structures are used to process Wide Board requests.
+ *
+ * The ADV_SCSI_REQ_Q structure in adv_req_t is passed to the Adv Library
+ * and microcode with the ADV_SCSI_REQ_Q field 'srb_ptr' pointing to the
+ * adv_req_t. The adv_req_t structure 'cmndp' field in turn points to the
+ * Mid-Level SCSI request structure.
+ *
+ * Zero or more ADV_SG_BLOCK are used with each ADV_SCSI_REQ_Q. Each
+ * ADV_SG_BLOCK structure holds 15 scatter-gather elements. Under Linux
+ * up to 255 scatter-gather elements may be used per request or
+ * ADV_SCSI_REQ_Q.
+ *
+ * Both structures must be 32 byte aligned.
+ */
+typedef struct adv_sgblk {
+ ADV_SG_BLOCK sg_block; /* Sgblock structure. */
+ uchar align[32]; /* Sgblock structure padding. */
+ struct adv_sgblk *next_sgblkp; /* Next scatter-gather structure. */
+} adv_sgblk_t;
+
+typedef struct adv_req {
+ ADV_SCSI_REQ_Q scsi_req_q; /* Adv Library request structure. */
+ uchar align[32]; /* Request structure padding. */
+ struct scsi_cmnd *cmndp; /* Mid-Level SCSI command pointer. */
+ adv_sgblk_t *sgblkp; /* Adv Library scatter-gather pointer. */
+ struct adv_req *next_reqp; /* Next Request Structure. */
+} adv_req_t;
+
+/*
+ * Adapter operation variable structure.
+ *
+ * One structure is required per host adapter.
+ *
+ * Field naming convention:
+ *
+ * *_able indicates both whether a feature should be enabled or disabled
+ * and whether a device isi capable of the feature. At initialization
+ * this field may be set, but later if a device is found to be incapable
+ * of the feature, the field is cleared.
+ */
+typedef struct adv_dvc_var {
+ AdvPortAddr iop_base; /* I/O port address */
+ ushort err_code; /* fatal error code */
+ ushort bios_ctrl; /* BIOS control word, EEPROM word 12 */
+ ushort wdtr_able; /* try WDTR for a device */
+ ushort sdtr_able; /* try SDTR for a device */
+ ushort ultra_able; /* try SDTR Ultra speed for a device */
+ ushort sdtr_speed1; /* EEPROM SDTR Speed for TID 0-3 */
+ ushort sdtr_speed2; /* EEPROM SDTR Speed for TID 4-7 */
+ ushort sdtr_speed3; /* EEPROM SDTR Speed for TID 8-11 */
+ ushort sdtr_speed4; /* EEPROM SDTR Speed for TID 12-15 */
+ ushort tagqng_able; /* try tagged queuing with a device */
+ ushort ppr_able; /* PPR message capable per TID bitmask. */
+ uchar max_dvc_qng; /* maximum number of tagged commands per device */
+ ushort start_motor; /* start motor command allowed */
+ uchar scsi_reset_wait; /* delay in seconds after scsi bus reset */
+ uchar chip_no; /* should be assigned by caller */
+ uchar max_host_qng; /* maximum number of Q'ed command allowed */
+ ushort no_scam; /* scam_tolerant of EEPROM */
+ struct asc_board *drv_ptr; /* driver pointer to private structure */
+ uchar chip_scsi_id; /* chip SCSI target ID */
+ uchar chip_type;
+ uchar bist_err_code;
+ ADV_CARR_T *carrier_buf;
+ ADV_CARR_T *carr_freelist; /* Carrier free list. */
+ ADV_CARR_T *icq_sp; /* Initiator command queue stopper pointer. */
+ ADV_CARR_T *irq_sp; /* Initiator response queue stopper pointer. */
+ ushort carr_pending_cnt; /* Count of pending carriers. */
+ struct adv_req *orig_reqp; /* adv_req_t memory block. */
+ /*
+ * Note: The following fields will not be used after initialization. The
+ * driver may discard the buffer after initialization is done.
+ */
+ ADV_DVC_CFG *cfg; /* temporary configuration structure */
+} ADV_DVC_VAR;
+
+/*
* Microcode idle loop commands
*/
#define IDLE_CMD_COMPLETED 0
#endif /* ADVANSYS_STATS */
/*
- * Adv Library Request Structures
- *
- * The following two structures are used to process Wide Board requests.
- *
- * The ADV_SCSI_REQ_Q structure in adv_req_t is passed to the Adv Library
- * and microcode with the ADV_SCSI_REQ_Q field 'srb_ptr' pointing to the
- * adv_req_t. The adv_req_t structure 'cmndp' field in turn points to the
- * Mid-Level SCSI request structure.
- *
- * Zero or more ADV_SG_BLOCK are used with each ADV_SCSI_REQ_Q. Each
- * ADV_SG_BLOCK structure holds 15 scatter-gather elements. Under Linux
- * up to 255 scatter-gather elements may be used per request or
- * ADV_SCSI_REQ_Q.
- *
- * Both structures must be 32 byte aligned.
- */
-typedef struct adv_sgblk {
- ADV_SG_BLOCK sg_block; /* Sgblock structure. */
- uchar align[32]; /* Sgblock structure padding. */
- struct adv_sgblk *next_sgblkp; /* Next scatter-gather structure. */
-} adv_sgblk_t;
-
-typedef struct adv_req {
- ADV_SCSI_REQ_Q scsi_req_q; /* Adv Library request structure. */
- uchar align[32]; /* Request structure padding. */
- struct scsi_cmnd *cmndp; /* Mid-Level SCSI command pointer. */
- adv_sgblk_t *sgblkp; /* Adv Library scatter-gather pointer. */
- struct adv_req *next_reqp; /* Next Request Structure. */
-} adv_req_t;
-
-/*
* Structure allocated for each board.
*
* This structure is allocated by scsi_host_alloc() at the end
*/
void __iomem *ioremap_addr; /* I/O Memory remap address. */
ushort ioport; /* I/O Port address. */
- ADV_CARR_T *carrp; /* ADV_CARR_T memory block. */
- adv_req_t *orig_reqp; /* adv_req_t memory block. */
adv_req_t *adv_reqp; /* Request structures. */
adv_sgblk_t *adv_sgblkp; /* Scatter-gather structures. */
ushort bios_signature; /* BIOS Signature. */
ADV_SDCNT buf_size;
ADV_PADDR carr_paddr;
- BUG_ON(!asc_dvc->carrier_buf);
-
carrp = (ADV_CARR_T *) ADV_16BALIGN(asc_dvc->carrier_buf);
asc_dvc->carr_freelist = NULL;
if (carrp == asc_dvc->carrier_buf) {
* Allocate buffer carrier structures. The total size
* is about 4 KB, so allocate all at once.
*/
- board->carrp = kmalloc(ADV_CARRIER_BUFSIZE, GFP_KERNEL);
- ASC_DBG(1, "carrp 0x%p\n", board->carrp);
+ adv_dvc->carrier_buf = kmalloc(ADV_CARRIER_BUFSIZE, GFP_KERNEL);
+ ASC_DBG(1, "carrier_buf 0x%p\n", adv_dvc->carrier_buf);
- if (!board->carrp)
+ if (!adv_dvc->carrier_buf)
goto kmalloc_failed;
/*
if (!reqp)
goto kmalloc_failed;
- board->orig_reqp = reqp;
+ adv_dvc->orig_reqp = reqp;
/*
* Allocate up to ADV_TOT_SG_BLOCK request structures for
if (!board->adv_sgblkp)
goto kmalloc_failed;
- adv_dvc->carrier_buf = board->carrp;
-
/*
* Point 'adv_reqp' to the request structures and
* link them together.
return err_code;
}
-static void advansys_wide_free_mem(struct asc_board *boardp)
+static void advansys_wide_free_mem(struct asc_board *board)
{
- kfree(boardp->carrp);
- boardp->carrp = NULL;
- kfree(boardp->orig_reqp);
- boardp->orig_reqp = boardp->adv_reqp = NULL;
- while (boardp->adv_sgblkp) {
- adv_sgblk_t *sgp = boardp->adv_sgblkp;
- boardp->adv_sgblkp = sgp->next_sgblkp;
+ struct adv_dvc_var *adv_dvc = &board->dvc_var.adv_dvc_var;
+ kfree(adv_dvc->carrier_buf);
+ adv_dvc->carrier_buf = NULL;
+ kfree(adv_dvc->orig_reqp);
+ adv_dvc->orig_reqp = board->adv_reqp = NULL;
+ while (board->adv_sgblkp) {
+ adv_sgblk_t *sgp = board->adv_sgblkp;
+ board->adv_sgblkp = sgp->next_sgblkp;
kfree(sgp);
}
}
git://ftp.safe.ca / safe / jmp / linux-2.6 / commitdiff