[PATCH] md: Don't clear bits in bitmap when writing to one device fails during recovery

Currently a device failure during recovery leaves bits set in the bitmap.
This normally isn't a problem as the offending device will be rejected because
of errors.  However if device re-adding is being used with non-persistent
bitmaps, this can be a problem.

Signed-off-by: Neil Brown <neilb@suse.de>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

diff --git a/drivers/md/raid1.c b/drivers/md/raid1.c
index 3cb0872..9b374c9 100644 (file)
--- a/drivers/md/raid1.c
+++ b/drivers/md/raid1.c
@@ -1135,8 +1135,19 @@ static int end_sync_write(struct bio *bio, unsigned int bytes_done, int error)
                        mirror = i;
                        break;
                }
-       if (!uptodate)
+       if (!uptodate) {
+               int sync_blocks = 0;
+               sector_t s = r1_bio->sector;
+               long sectors_to_go = r1_bio->sectors;
+               /* make sure these bits doesn't get cleared. */
+               do {
+                       bitmap_end_sync(mddev->bitmap, r1_bio->sector,
+                                       &sync_blocks, 1);
+                       s += sync_blocks;
+                       sectors_to_go -= sync_blocks;
+               } while (sectors_to_go > 0);
                md_error(mddev, conf->mirrors[mirror].rdev);
+       }
 
        update_head_pos(mirror, r1_bio);