#define LCD_CONN_TYPE(_x) ((_x) & 0x0f)
#define LCD_CONN_WIDTH(_x) (((_x) >> 4) & 0x1f)
+#define LCD_TYPE_MASK 0xf
#define LCD_TYPE_UNKNOWN 0
#define LCD_TYPE_MONO_STN 1
#define LCD_TYPE_MONO_DSTN 2
u32 *mem_resume_unknown = phys_to_virt(RESUME_UNKNOWN_ADDR);
/* Devices prepare suspend */
- is_bt_on = gpio_get_value(GPIO83_BT_ON);
+ is_bt_on = !!gpio_get_value(GPIO83_BT_ON);
pxa2xx_mfp_set_lpm(GPIO83_BT_ON,
is_bt_on ? MFP_LPM_DRIVE_HIGH : MFP_LPM_DRIVE_LOW);
1:
mov r0, #0xa0000000 @ Don't suppose memory access works
orr r0, r0, #0x00200000 @ even if it's supposed to
+ orr r0, r0, #0x0000b000
mov r1, #0
str r1, [r0] @ Early disable resume for next boot
ldr r0, mioa701_jumpaddr @ (Murphy's Law)
/* Jump into ROM at address 0 */
cpu_reset(0);
break;
- case 'h':
- do_hw_reset();
- break;
case 'g':
do_gpio_reset();
break;
+ case 'h':
+ default:
+ do_hw_reset();
+ break;
}
}
static unsigned long spitz_pin_config[] __initdata = {
/* Chip Selects */
GPIO78_nCS_2, /* SCOOP #2 */
+ GPIO79_nCS_3, /* NAND */
GPIO80_nCS_4, /* SCOOP #1 */
/* LCD - 16bpp Active TFT */
GPIO51_nPIOW,
GPIO85_nPCE_1,
GPIO54_nPCE_2,
- GPIO79_PSKTSEL,
GPIO55_nPREG,
GPIO56_nPWAIT,
GPIO57_nIOIS16,
+ GPIO104_PSKTSEL,
/* MMC */
GPIO32_MMC_CLK,
spitz_pcmcia_config.num_devs = 1;
platform_scoop_config = &spitz_pcmcia_config;
- pxa_set_i2c_info(NULL);
i2c_register_board_info(0, ARRAY_AND_SIZE(akita_i2c_board_info));
common_init();
if (mach->gpio_vbus) {
int value = gpio_get_value(mach->gpio_vbus);
- return mach->gpio_vbus_inverted ? !value : value;
+
+ if (mach->gpio_vbus_inverted)
+ return !value;
+ else
+ return !!value;
}
if (mach->udc_is_connected)
return mach->udc_is_connected();
struct pxa25x_udc *udc;
udc = container_of(_gadget, struct pxa25x_udc, gadget);
- udc->vbus = (is_active != 0);
+ udc->vbus = is_active;
DMSG("vbus %s\n", is_active ? "supplied" : "inactive");
pullup(udc);
return 0;
static irqreturn_t udc_vbus_irq(int irq, void *_dev)
{
struct pxa25x_udc *dev = _dev;
- int vbus = gpio_get_value(dev->mach->gpio_vbus);
- if (dev->mach->gpio_vbus_inverted)
- vbus = !vbus;
-
- pxa25x_udc_vbus_session(&dev->gadget, vbus);
+ pxa25x_udc_vbus_session(&dev->gadget, is_vbus_present());
return IRQ_HANDLED;
}
static int pxafb_smart_init(struct pxafb_info *fbi)
{
+ if (!(fbi->lccr0 | LCCR0_LCDT))
+ return 0;
+
fbi->smart_thread = kthread_run(pxafb_smart_thread, fbi,
"lcd_refresh");
if (IS_ERR(fbi->smart_thread)) {
fbi->cmap_inverse = inf->cmap_inverse;
fbi->cmap_static = inf->cmap_static;
- switch (lcd_conn & 0xf) {
+ switch (lcd_conn & LCD_TYPE_MASK) {
case LCD_TYPE_MONO_STN:
fbi->lccr0 = LCCR0_CMS;
break;