[SPARC64]: In sunsu driver, make sure to fully init chip for kbd/ms

We were forgetting to call sunsu_change_speed().  The reason
that replugging in the mouse cable "fixes things" is that
causes a BREAK interrupt which in turn caused a call to
sunsu_change_speed() which would get the chip setup properly.

Signed-off-by: David S. Miller <davem@davemloft.net>

diff --git a/drivers/serial/sunsu.c b/drivers/serial/sunsu.c
index 23d19d3..ddc97c9 100644 (file)
--- a/drivers/serial/sunsu.c
+++ b/drivers/serial/sunsu.c
@@ -1285,6 +1285,7 @@ static struct uart_driver sunsu_reg = {
 
 static int __init sunsu_kbd_ms_init(struct uart_sunsu_port *up, int channel)
 {
+       int quot, baud;
 #ifdef CONFIG_SERIO
        struct serio *serio;
 #endif
@@ -1293,10 +1294,14 @@ static int __init sunsu_kbd_ms_init(struct uart_sunsu_port *up, int channel)
        up->port.type = PORT_UNKNOWN;
        up->port.uartclk = (SU_BASE_BAUD * 16);
 
-       if (up->su_type == SU_PORT_KBD)
+       if (up->su_type == SU_PORT_KBD) {
                up->cflag = B1200 | CS8 | CLOCAL | CREAD;
-       else
+               baud = 1200;
+       } else {
                up->cflag = B4800 | CS8 | CLOCAL | CREAD;
+               baud = 4800;
+       }
+       quot = up->port.uartclk / (16 * baud);
 
        sunsu_autoconfig(up);
        if (up->port.type == PORT_UNKNOWN)
@@ -1337,6 +1342,8 @@ static int __init sunsu_kbd_ms_init(struct uart_sunsu_port *up, int channel)
        }
 #endif
 
+       sunsu_change_speed(&up->port, up->cflag, 0, quot);
+
        sunsu_startup(&up->port);
        return 0;
 }