[ARM] 5391/1: AT91: Enable GPIO clocks earlier

Enable the GPIO clocks earlier in the initialization sequence.  This
allow the board-setup code to read and set GPIO pins.

Signed-off-by: Marc Pignat <marc.pignat@hevs.ch>
Signed-off-by: Andrew Victor <linux@maxim.org.za>
Signed-off-by: Russell King <rmk+kernel@arm.linux.org.uk>

diff --git a/arch/arm/mach-at91/gpio.c b/arch/arm/mach-at91/gpio.c
index 9b0447c..2f7d497 100644 (file)
--- a/arch/arm/mach-at91/gpio.c
+++ b/arch/arm/mach-at91/gpio.c
@@ -490,7 +490,8 @@ postcore_initcall(at91_gpio_debugfs_init);
 
 /*--------------------------------------------------------------------------*/
 
-/* This lock class tells lockdep that GPIO irqs are in a different
+/*
+ * This lock class tells lockdep that GPIO irqs are in a different
  * category than their parents, so it won't report false recursion.
  */
 static struct lock_class_key gpio_lock_class;
@@ -509,9 +510,6 @@ void __init at91_gpio_irq_setup(void)
                unsigned        id = this->id;
                unsigned        i;
 
-               /* enable PIO controller's clock */
-               clk_enable(this->clock);
-
                __raw_writel(~0, this->regbase + PIO_IDR);
 
                for (i = 0, pin = this->chipbase; i < 32; i++, pin++) {
@@ -556,7 +554,14 @@ void __init at91_gpio_init(struct at91_gpio_bank *data, int nr_banks)
                data->chipbase = PIN_BASE + i * 32;
                data->regbase = data->offset + (void __iomem *)AT91_VA_BASE_SYS;
 
-               /* AT91SAM9263_ID_PIOCDE groups PIOC, PIOD, PIOE */
+               /* enable PIO controller's clock */
+               clk_enable(data->clock);
+
+               /*
+                * Some processors share peripheral ID between multiple GPIO banks.
+                *  SAM9263 (PIOC, PIOD, PIOE)
+                *  CAP9 (PIOA, PIOB, PIOC, PIOD)
+                */
                if (last && last->id == data->id)
                        last->next = data;
        }