Update the sh7724 processor code to always enable vpu_clk.
On the Ecovec board, set the vpu_clk to 166 Mhz.
The 166MHz setting results in a divide-by-6 setup for
vpu_clk and improves the VPU performance compared to the
power-on-reset/bootloader configuration.
Signed-off-by: Magnus Damm <damm@opensource.se>
Signed-off-by: Paul Mundt <lethal@linux-sh.org>
gpio_request(GPIO_FN_INTC_IRQ1, NULL);
gpio_direction_input(GPIO_FN_INTC_IRQ1);
gpio_request(GPIO_FN_INTC_IRQ1, NULL);
gpio_direction_input(GPIO_FN_INTC_IRQ1);
+ /* set VPU clock to 166 MHz */
+ clk = clk_get(NULL, "vpu_clk");
+ clk_set_rate(clk, clk_round_rate(clk, 166000000));
+ clk_put(clk);
+
/* enable I2C device */
i2c_register_board_info(0, i2c0_devices,
ARRAY_SIZE(i2c0_devices));
/* enable I2C device */
i2c_register_board_info(0, i2c0_devices,
ARRAY_SIZE(i2c0_devices));
[DIV4_SH] = DIV4("shyway_clk", FRQCRA, 12, 0x2f7c, CLK_ENABLE_ON_INIT),
[DIV4_B] = DIV4("bus_clk", FRQCRA, 8, 0x2f7c, CLK_ENABLE_ON_INIT),
[DIV4_P] = DIV4("peripheral_clk", FRQCRA, 0, 0x2f7c, 0),
[DIV4_SH] = DIV4("shyway_clk", FRQCRA, 12, 0x2f7c, CLK_ENABLE_ON_INIT),
[DIV4_B] = DIV4("bus_clk", FRQCRA, 8, 0x2f7c, CLK_ENABLE_ON_INIT),
[DIV4_P] = DIV4("peripheral_clk", FRQCRA, 0, 0x2f7c, 0),
- [DIV4_M1] = DIV4("vpu_clk", FRQCRB, 4, 0x2f7c, 0),
+ [DIV4_M1] = DIV4("vpu_clk", FRQCRB, 4, 0x2f7c, CLK_ENABLE_ON_INIT),
};
struct clk div6_clks[] = {
};
struct clk div6_clks[] = {