So far, CORB/RIRB still remains even if the driver is switched to the
single_cmd mode. The specification says that this should be disabled,
but I hoped this isn't the case; indeed most devices worked together with
CORB/RIRB.
However, Poulsbo (US15W) seems problematic with this setup, and it
requires to disable CORB/RIRB when single_cmd is used.
Now this patch disables CORB/RIRB initialization when the single_cmd
mode is used. Also the unsolicited event is disabled because it can't
work without RIRB.
Reported-and-tested-by: Troy Kisky <troy.kisky@boundarydevices.com>
Signed-off-by: Takashi Iwai <tiwai@suse.de>
chip->last_cmd[addr]);
chip->single_cmd = 1;
bus->response_reset = 0;
chip->last_cmd[addr]);
chip->single_cmd = 1;
bus->response_reset = 0;
- /* re-initialize CORB/RIRB */
+ /* release CORB/RIRB */
+ /* disable unsolicited responses */
+ azx_writel(chip, GCTL, azx_readl(chip, GCTL) & ~ICH6_GCTL_UNSOL);
}
/* Accept unsolicited responses */
}
/* Accept unsolicited responses */
- azx_writel(chip, GCTL, azx_readl(chip, GCTL) | ICH6_GCTL_UNSOL);
+ if (!chip->single_cmd)
+ azx_writel(chip, GCTL, azx_readl(chip, GCTL) |
+ ICH6_GCTL_UNSOL);
/* detect codecs */
if (!chip->codec_mask) {
/* detect codecs */
if (!chip->codec_mask) {
azx_int_enable(chip);
/* initialize the codec command I/O */
azx_int_enable(chip);
/* initialize the codec command I/O */
+ if (!chip->single_cmd)
+ azx_init_cmd_io(chip);
/* program the position buffer */
azx_writel(chip, DPLBASE, (u32)chip->posbuf.addr);
/* program the position buffer */
azx_writel(chip, DPLBASE, (u32)chip->posbuf.addr);