X-Git-Url: http://ftp.safe.ca/?a=blobdiff_plain;f=drivers%2Fscsi%2Fesp_scsi.h;h=28e22acf87ea94f9c703086689da850174495573;hb=8b6649c575e0d8312f62fe643ae43558892da2e1;hp=856e38b14861c6614bb72a81cc0a88a236e00db7;hpb=d73f5222a618a91452d41c29f5996ce3d9c63673;p=safe%2Fjmp%2Flinux-2.6 diff --git a/drivers/scsi/esp_scsi.h b/drivers/scsi/esp_scsi.h index 856e38b..28e22ac 100644 --- a/drivers/scsi/esp_scsi.h +++ b/drivers/scsi/esp_scsi.h @@ -220,11 +220,11 @@ #define ESP_BUSID_RESELID 0x10 #define ESP_BUSID_CTR32BIT 0x40 -#define ESP_BUS_TIMEOUT 275 /* In milli-seconds */ +#define ESP_BUS_TIMEOUT 250 /* In milli-seconds */ #define ESP_TIMEO_CONST 8192 #define ESP_NEG_DEFP(mhz, cfact) \ ((ESP_BUS_TIMEOUT * ((mhz) / 1000)) / (8192 * (cfact))) -#define ESP_MHZ_TO_CYCLE(mhertz) ((1000000000) / ((mhertz) / 1000)) +#define ESP_HZ_TO_CYCLE(hertz) ((1000000000) / ((hertz) / 1000)) #define ESP_TICK(ccf, cycle) ((7682 * (ccf) * (cycle) / 1000)) /* For slow to medium speed input clock rates we shoot for 5mb/s, but for high @@ -240,9 +240,9 @@ struct esp_cmd_priv { int num_sg; } u; - unsigned int cur_residue; + int cur_residue; struct scatterlist *cur_sg; - unsigned int tot_residue; + int tot_residue; }; #define ESP_CMD_PRIV(CMD) ((struct esp_cmd_priv *)(&(CMD)->SCp)) @@ -368,6 +368,12 @@ struct esp_driver_ops { */ int (*irq_pending)(struct esp *esp); + /* Return the maximum allowable size of a DMA transfer for a + * given buffer. + */ + u32 (*dma_length_limit)(struct esp *esp, u32 dma_addr, + u32 dma_len); + /* Reset the DMA engine entirely. On return, ESP interrupts * should be enabled. Often the interrupt enabling is * controlled in the DMA engine. @@ -471,6 +477,7 @@ struct esp { #define ESP_FLAG_DOING_SLOWCMD 0x00000004 #define ESP_FLAG_WIDE_CAPABLE 0x00000008 #define ESP_FLAG_QUICKIRQ_CHECK 0x00000010 +#define ESP_FLAG_DISABLE_SYNC 0x00000020 u8 select_state; #define ESP_SELECT_NONE 0x00 /* Not selecting */ @@ -514,7 +521,8 @@ struct esp { struct completion *eh_reset; - struct sbus_dma *dma; + void *dma; + int dmarev; }; /* A front-end driver for the ESP chip should do the following in