X-Git-Url: http://ftp.safe.ca/?a=blobdiff_plain;f=Documentation%2Fnetworking%2Fs2io.txt;h=c3d6b4d5d014ab5dfe2c4cc39248b3c01f00a912;hb=e902a358c753b93245083201c02312a580cf13d4;hp=bd528ffbeb4b6c5b0add3dfdd626d2cfd7e843df;hpb=571de88b87e978b21ac4da481d317678aac9e562;p=safe%2Fjmp%2Flinux-2.6

diff --git a/Documentation/networking/s2io.txt b/Documentation/networking/s2io.txt
index bd528ff..c3d6b4d 100644
--- a/Documentation/networking/s2io.txt
+++ b/Documentation/networking/s2io.txt
@@ -52,13 +52,10 @@ d. MSI/MSI-X. Can be enabled on platforms which support this feature
 (IA64, Xeon) resulting in noticeable performance improvement(upto 7%
 on certain platforms).
 
-e. NAPI. Compile-time option(CONFIG_S2IO_NAPI) for better Rx interrupt 
-moderation.
-
-f. Statistics. Comprehensive MAC-level and software statistics displayed
+e. Statistics. Comprehensive MAC-level and software statistics displayed
 using "ethtool -S" option.
 
-g. Multi-FIFO/Ring. Supports up to 8 transmit queues and receive rings, 
+f. Multi-FIFO/Ring. Supports up to 8 transmit queues and receive rings,
 with multiple steering options.
 
 4.  Command line parameters
@@ -83,9 +80,9 @@ Valid range: Limited by memory on system
 Default: 30 
 
 e. intr_type
-Specifies interrupt type. Possible values 1(INTA), 2(MSI), 3(MSI-X)
-Valid range: 1-3
-Default: 1 
+Specifies interrupt type. Possible values 0(INTA), 2(MSI-X)
+Valid values: 0, 2
+Default: 2
 
 5.  Performance suggestions
 General:
@@ -126,7 +123,7 @@ However, you may want to set PCI latency timer to 248.
 #setpci -d 17d5:* LATENCY_TIMER=f8
 For detailed description of the PCI registers, please see Xframe User Guide.
 b. Use 2-buffer mode. This results in large performance boost on
-on certain platforms(eg. SGI Altix, IBM xSeries).
+certain platforms(eg. SGI Altix, IBM xSeries).
 c. Ensure Receive Checksum offload is enabled. Use "ethtool -K ethX" command to 
 set/verify this option.
 d. Enable NAPI feature(in kernel configuration Device Drivers ---> Network