X-Git-Url: http://ftp.safe.ca/?a=blobdiff_plain;ds=sidebyside;f=drivers%2Fserial%2Fpmac_zilog.h;h=cbc34fbb1b20a408ad0c135549b190c8800a278f;hb=bb8a356088db8a2a50365d417a71ac9e83b9b530;hp=c03f9bfacdd897022d1d3d20f065830447e44975;hpb=1da177e4c3f41524e886b7f1b8a0c1fc7321cac2;p=safe%2Fjmp%2Flinux-2.6

diff --git a/drivers/serial/pmac_zilog.h b/drivers/serial/pmac_zilog.h
index c03f9bf..cbc34fb 100644
--- a/drivers/serial/pmac_zilog.h
+++ b/drivers/serial/pmac_zilog.h
@@ -1,7 +1,15 @@
 #ifndef __PMAC_ZILOG_H__
 #define __PMAC_ZILOG_H__
 
-#define pmz_debug(fmt,arg...)	dev_dbg(&uap->dev->ofdev.dev, fmt, ## arg)
+#ifdef CONFIG_PPC_PMAC
+#define pmz_debug(fmt, arg...)	dev_dbg(&uap->dev->ofdev.dev, fmt, ## arg)
+#define pmz_error(fmt, arg...)	dev_err(&uap->dev->ofdev.dev, fmt, ## arg)
+#define pmz_info(fmt, arg...)	dev_info(&uap->dev->ofdev.dev, fmt, ## arg)
+#else
+#define pmz_debug(fmt, arg...)	dev_dbg(&uap->node->dev, fmt, ## arg)
+#define pmz_error(fmt, arg...)	dev_err(&uap->node->dev, fmt, ## arg)
+#define pmz_info(fmt, arg...)	dev_info(&uap->node->dev, fmt, ## arg)
+#endif
 
 /*
  * At most 2 ESCCs with 2 ports each
@@ -17,6 +25,7 @@ struct uart_pmac_port {
 	struct uart_port		port;
 	struct uart_pmac_port		*mate;
 
+#ifdef CONFIG_PPC_PMAC
 	/* macio_dev for the escc holding this port (maybe be null on
 	 * early inited port)
 	 */
@@ -25,6 +34,9 @@ struct uart_pmac_port {
 	 * of "escc" node (ie. ch-a or ch-b)
 	 */
 	struct device_node		*node;
+#else
+	struct platform_device		*node;
+#endif
 
 	/* Port type as obtained from device tree (IRDA, modem, ...) */
 	int				port_type;
@@ -55,12 +67,14 @@ struct uart_pmac_port {
 	volatile u8			__iomem *control_reg;
 	volatile u8			__iomem *data_reg;
 
+#ifdef CONFIG_PPC_PMAC
 	unsigned int			tx_dma_irq;
 	unsigned int			rx_dma_irq;
 	volatile struct dbdma_regs	__iomem *tx_dma_regs;
 	volatile struct dbdma_regs	__iomem *rx_dma_regs;
+#endif
 
-	struct termios			termios_cache;
+	struct ktermios			termios_cache;
 };
 
 #define to_pmz(p) ((struct uart_pmac_port *)(p))
@@ -73,7 +87,7 @@ static inline struct uart_pmac_port *pmz_get_port_A(struct uart_pmac_port *uap)
 }
 
 /*
- * Register acessors. Note that we don't need to enforce a recovery
+ * Register accessors. Note that we don't need to enforce a recovery
  * delay on PCI PowerMac hardware, it's dealt in HW by the MacIO chip,
  * though if we try to use this driver on older machines, we might have
  * to add it back
@@ -113,7 +127,7 @@ static inline void zssync(struct uart_pmac_port *port)
 #define BRG_TO_BPS(brg, freq) ((freq) / 2 / ((brg) + 2))
 #define BPS_TO_BRG(bps, freq) ((((freq) + (bps)) / (2 * (bps))) - 2)
 
-#define ZS_CLOCK         3686400 	/* Z8530 RTxC input clock rate */
+#define ZS_CLOCK         3686400	/* Z8530 RTxC input clock rate */
 
 /* The Zilog register set */
 
@@ -171,7 +185,7 @@ static inline void zssync(struct uart_pmac_port *port)
 
 /* Write Register 3 */
 
-#define	RxENABLE       	0x1	/* Rx Enable */
+#define	RxENABLE	0x1	/* Rx Enable */
 #define	SYNC_L_INH	0x2	/* Sync Character Load Inhibit */
 #define	ADD_SM		0x4	/* Address Search Mode (SDLC) */
 #define	RxCRC_ENAB	0x8	/* Rx CRC Enable */
@@ -185,7 +199,7 @@ static inline void zssync(struct uart_pmac_port *port)
 
 /* Write Register 4 */
 
-#define	PAR_ENAB       	0x1	/* Parity Enable */
+#define	PAR_ENAB	0x1	/* Parity Enable */
 #define	PAR_EVEN	0x2	/* Parity Even/Odd* */
 
 #define	SYNC_ENAB	0	/* Sync Modes Enable */
@@ -210,7 +224,7 @@ static inline void zssync(struct uart_pmac_port *port)
 #define	TxCRC_ENAB	0x1	/* Tx CRC Enable */
 #define	RTS		0x2	/* RTS */
 #define	SDLC_CRC	0x4	/* SDLC/CRC-16 */
-#define	TxENABLE       	0x8	/* Tx Enable */
+#define	TxENABLE	0x8	/* Tx Enable */
 #define	SND_BRK		0x10	/* Send Break */
 #define	Tx5		0x0	/* Tx 5 bits (or less)/character */
 #define	Tx7		0x20	/* Tx 7 bits/character */
@@ -372,11 +386,11 @@ static inline void zssync(struct uart_pmac_port *port)
 #define ZS_TX_ACTIVE(UP)		((UP)->flags & PMACZILOG_FLAG_TX_ACTIVE)
 #define ZS_WANTS_MODEM_STATUS(UP)	((UP)->flags & PMACZILOG_FLAG_MODEM_STATUS)
 #define ZS_IS_IRDA(UP)			((UP)->flags & PMACZILOG_FLAG_IS_IRDA)
-#define ZS_IS_INTMODEM(UP)	       	((UP)->flags & PMACZILOG_FLAG_IS_INTMODEM)
+#define ZS_IS_INTMODEM(UP)		((UP)->flags & PMACZILOG_FLAG_IS_INTMODEM)
 #define ZS_HAS_DMA(UP)			((UP)->flags & PMACZILOG_FLAG_HAS_DMA)
-#define ZS_IS_ASLEEP(UP)       		((UP)->flags & PMACZILOG_FLAG_IS_ASLEEP)
-#define ZS_IS_OPEN(UP)       		((UP)->flags & PMACZILOG_FLAG_IS_OPEN)
-#define ZS_IS_IRQ_ON(UP)       		((UP)->flags & PMACZILOG_FLAG_IS_IRQ_ON)
-#define ZS_IS_EXTCLK(UP)       		((UP)->flags & PMACZILOG_FLAG_IS_EXTCLK)
+#define ZS_IS_ASLEEP(UP)		((UP)->flags & PMACZILOG_FLAG_IS_ASLEEP)
+#define ZS_IS_OPEN(UP)			((UP)->flags & PMACZILOG_FLAG_IS_OPEN)
+#define ZS_IS_IRQ_ON(UP)		((UP)->flags & PMACZILOG_FLAG_IS_IRQ_ON)
+#define ZS_IS_EXTCLK(UP)		((UP)->flags & PMACZILOG_FLAG_IS_EXTCLK)
 
 #endif /* __PMAC_ZILOG_H__ */