/* frame sending functions */
+static void ieee80211_add_ht_ie(struct sk_buff *skb, const u8 *ht_info_ie,
+ struct ieee80211_supported_band *sband,
+ struct ieee80211_channel *channel,
+ enum ieee80211_smps_mode smps)
+{
+ struct ieee80211_ht_info *ht_info;
+ u8 *pos;
+ u32 flags = channel->flags;
+ u16 cap = sband->ht_cap.cap;
+ __le16 tmp;
+
+ if (!sband->ht_cap.ht_supported)
+ return;
+
+ if (!ht_info_ie)
+ return;
+
+ if (ht_info_ie[1] < sizeof(struct ieee80211_ht_info))
+ return;
+
+ ht_info = (struct ieee80211_ht_info *)(ht_info_ie + 2);
+
+ /* determine capability flags */
+
+ if (ieee80211_disable_40mhz_24ghz &&
+ sband->band == IEEE80211_BAND_2GHZ) {
+ cap &= ~IEEE80211_HT_CAP_SUP_WIDTH_20_40;
+ cap &= ~IEEE80211_HT_CAP_SGI_40;
+ }
+
+ switch (ht_info->ht_param & IEEE80211_HT_PARAM_CHA_SEC_OFFSET) {
+ case IEEE80211_HT_PARAM_CHA_SEC_ABOVE:
+ if (flags & IEEE80211_CHAN_NO_HT40PLUS) {
+ cap &= ~IEEE80211_HT_CAP_SUP_WIDTH_20_40;
+ cap &= ~IEEE80211_HT_CAP_SGI_40;
+ }
+ break;
+ case IEEE80211_HT_PARAM_CHA_SEC_BELOW:
+ if (flags & IEEE80211_CHAN_NO_HT40MINUS) {
+ cap &= ~IEEE80211_HT_CAP_SUP_WIDTH_20_40;
+ cap &= ~IEEE80211_HT_CAP_SGI_40;
+ }
+ break;
+ }
+
+ /* set SM PS mode properly */
+ cap &= ~IEEE80211_HT_CAP_SM_PS;
+ switch (smps) {
+ case IEEE80211_SMPS_AUTOMATIC:
+ case IEEE80211_SMPS_NUM_MODES:
+ WARN_ON(1);
+ case IEEE80211_SMPS_OFF:
+ cap |= WLAN_HT_CAP_SM_PS_DISABLED <<
+ IEEE80211_HT_CAP_SM_PS_SHIFT;
+ break;
+ case IEEE80211_SMPS_STATIC:
+ cap |= WLAN_HT_CAP_SM_PS_STATIC <<
+ IEEE80211_HT_CAP_SM_PS_SHIFT;
+ break;
+ case IEEE80211_SMPS_DYNAMIC:
+ cap |= WLAN_HT_CAP_SM_PS_DYNAMIC <<
+ IEEE80211_HT_CAP_SM_PS_SHIFT;
+ break;
+ }
+
+ /* reserve and fill IE */
+
+ pos = skb_put(skb, sizeof(struct ieee80211_ht_cap) + 2);
+ *pos++ = WLAN_EID_HT_CAPABILITY;
+ *pos++ = sizeof(struct ieee80211_ht_cap);
+ memset(pos, 0, sizeof(struct ieee80211_ht_cap));
+
+ /* capability flags */
+ tmp = cpu_to_le16(cap);
+ memcpy(pos, &tmp, sizeof(u16));
+ pos += sizeof(u16);
+
+ /* AMPDU parameters */
+ *pos++ = sband->ht_cap.ampdu_factor |
+ (sband->ht_cap.ampdu_density <<
+ IEEE80211_HT_AMPDU_PARM_DENSITY_SHIFT);
+
+ /* MCS set */
+ memcpy(pos, &sband->ht_cap.mcs, sizeof(sband->ht_cap.mcs));
+ pos += sizeof(sband->ht_cap.mcs);
+
+ /* extended capabilities */
+ pos += sizeof(__le16);
+
+ /* BF capabilities */
+ pos += sizeof(__le32);
+
+ /* antenna selection */
+ pos += sizeof(u8);
+}
+
static void ieee80211_send_assoc(struct ieee80211_sub_if_data *sdata,
struct ieee80211_work *wk)
{
struct sk_buff *skb;
struct ieee80211_mgmt *mgmt;
u8 *pos;
- const u8 *ies, *ht_ie;
+ const u8 *ies;
int i, len, count, rates_len, supp_rates_len;
u16 capab;
struct ieee80211_supported_band *sband;
u32 rates = 0;
- skb = dev_alloc_skb(local->hw.extra_tx_headroom +
- sizeof(*mgmt) + 200 + wk->ie_len +
- wk->assoc.ssid_len);
+ sband = local->hw.wiphy->bands[wk->chan->band];
+
+ /*
+ * Get all rates supported by the device and the AP as
+ * some APs don't like getting a superset of their rates
+ * in the association request (e.g. D-Link DAP 1353 in
+ * b-only mode)...
+ */
+ rates_len = ieee80211_compatible_rates(wk->assoc.supp_rates,
+ wk->assoc.supp_rates_len,
+ sband, &rates);
+
+ skb = alloc_skb(local->hw.extra_tx_headroom +
+ sizeof(*mgmt) + /* bit too much but doesn't matter */
+ 2 + wk->assoc.ssid_len + /* SSID */
+ 4 + rates_len + /* (extended) rates */
+ 4 + /* power capability */
+ 2 + 2 * sband->n_channels + /* supported channels */
+ 2 + sizeof(struct ieee80211_ht_cap) + /* HT */
+ wk->ie_len + /* extra IEs */
+ 9, /* WMM */
+ GFP_KERNEL);
if (!skb) {
printk(KERN_DEBUG "%s: failed to allocate buffer for assoc "
"frame\n", sdata->name);
}
skb_reserve(skb, local->hw.extra_tx_headroom);
- sband = local->hw.wiphy->bands[wk->chan->band];
-
capab = WLAN_CAPABILITY_ESS;
if (sband->band == IEEE80211_BAND_2GHZ) {
if (wk->assoc.capability & WLAN_CAPABILITY_PRIVACY)
capab |= WLAN_CAPABILITY_PRIVACY;
- /*
- * Get all rates supported by the device and the AP as
- * some APs don't like getting a superset of their rates
- * in the association request (e.g. D-Link DAP 1353 in
- * b-only mode)...
- */
- rates_len = ieee80211_compatible_rates(wk->assoc.supp_rates,
- wk->assoc.supp_rates_len,
- sband, &rates);
-
if ((wk->assoc.capability & WLAN_CAPABILITY_SPECTRUM_MGMT) &&
(local->hw.flags & IEEE80211_HW_SPECTRUM_MGMT))
capab |= WLAN_CAPABILITY_SPECTRUM_MGMT;
*pos++ = WLAN_EID_PWR_CAPABILITY;
*pos++ = 2;
*pos++ = 0; /* min tx power */
- *pos++ = local->hw.conf.channel->max_power; /* max tx power */
+ *pos++ = wk->chan->max_power; /* max tx power */
/* 2. supported channels */
/* TODO: get this in reg domain format */
}
}
+ /*
+ * XXX: These IEs could contain (vendor-specified)
+ * IEs that belong after HT -- the buffer may
+ * need to be split up.
+ */
if (wk->ie_len && wk->ie) {
pos = skb_put(skb, wk->ie_len);
memcpy(pos, wk->ie, wk->ie_len);
}
+ if (wk->assoc.use_11n && wk->assoc.wmm_used &&
+ local->hw.queues >= 4)
+ ieee80211_add_ht_ie(skb, wk->assoc.ht_information_ie,
+ sband, wk->chan, wk->assoc.smps);
+
if (wk->assoc.wmm_used && local->hw.queues >= 4) {
pos = skb_put(skb, 9);
*pos++ = WLAN_EID_VENDOR_SPECIFIC;
*pos++ = 0;
}
- /* wmm support is a must to HT */
- /*
- * IEEE802.11n does not allow TKIP/WEP as pairwise
- * ciphers in HT mode. We still associate in non-ht
- * mode (11a/b/g) if any one of these ciphers is
- * configured as pairwise.
- */
- if (wk->assoc.use_11n && wk->assoc.wmm_used &&
- (local->hw.queues >= 4) &&
- sband->ht_cap.ht_supported &&
- (ht_ie = wk->assoc.ht_information_ie) &&
- ht_ie[1] >= sizeof(struct ieee80211_ht_info)) {
- struct ieee80211_ht_info *ht_info =
- (struct ieee80211_ht_info *)(ht_ie + 2);
- u16 cap = sband->ht_cap.cap;
- __le16 tmp;
- u32 flags = local->hw.conf.channel->flags;
-
- /* determine capability flags */
-
- if (ieee80211_disable_40mhz_24ghz &&
- sband->band == IEEE80211_BAND_2GHZ) {
- cap &= ~IEEE80211_HT_CAP_SUP_WIDTH_20_40;
- cap &= ~IEEE80211_HT_CAP_SGI_40;
- }
-
- switch (ht_info->ht_param & IEEE80211_HT_PARAM_CHA_SEC_OFFSET) {
- case IEEE80211_HT_PARAM_CHA_SEC_ABOVE:
- if (flags & IEEE80211_CHAN_NO_HT40PLUS) {
- cap &= ~IEEE80211_HT_CAP_SUP_WIDTH_20_40;
- cap &= ~IEEE80211_HT_CAP_SGI_40;
- }
- break;
- case IEEE80211_HT_PARAM_CHA_SEC_BELOW:
- if (flags & IEEE80211_CHAN_NO_HT40MINUS) {
- cap &= ~IEEE80211_HT_CAP_SUP_WIDTH_20_40;
- cap &= ~IEEE80211_HT_CAP_SGI_40;
- }
- break;
- }
-
- /* set SM PS mode properly */
- cap &= ~IEEE80211_HT_CAP_SM_PS;
- switch (wk->assoc.smps) {
- case IEEE80211_SMPS_AUTOMATIC:
- case IEEE80211_SMPS_NUM_MODES:
- WARN_ON(1);
- case IEEE80211_SMPS_OFF:
- cap |= WLAN_HT_CAP_SM_PS_DISABLED <<
- IEEE80211_HT_CAP_SM_PS_SHIFT;
- break;
- case IEEE80211_SMPS_STATIC:
- cap |= WLAN_HT_CAP_SM_PS_STATIC <<
- IEEE80211_HT_CAP_SM_PS_SHIFT;
- break;
- case IEEE80211_SMPS_DYNAMIC:
- cap |= WLAN_HT_CAP_SM_PS_DYNAMIC <<
- IEEE80211_HT_CAP_SM_PS_SHIFT;
- break;
- }
-
- /* reserve and fill IE */
-
- pos = skb_put(skb, sizeof(struct ieee80211_ht_cap) + 2);
- *pos++ = WLAN_EID_HT_CAPABILITY;
- *pos++ = sizeof(struct ieee80211_ht_cap);
- memset(pos, 0, sizeof(struct ieee80211_ht_cap));
-
- /* capability flags */
- tmp = cpu_to_le16(cap);
- memcpy(pos, &tmp, sizeof(u16));
- pos += sizeof(u16);
-
- /* AMPDU parameters */
- *pos++ = sband->ht_cap.ampdu_factor |
- (sband->ht_cap.ampdu_density <<
- IEEE80211_HT_AMPDU_PARM_DENSITY_SHIFT);
-
- /* MCS set */
- memcpy(pos, &sband->ht_cap.mcs, sizeof(sband->ht_cap.mcs));
- pos += sizeof(sband->ht_cap.mcs);
-
- /* extended capabilities */
- pos += sizeof(__le16);
-
- /* BF capabilities */
- pos += sizeof(__le32);
-
- /* antenna selection */
- pos += sizeof(u8);
- }
-
IEEE80211_SKB_CB(skb)->flags |= IEEE80211_TX_INTFL_DONT_ENCRYPT;
ieee80211_tx_skb(sdata, skb);
}
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff