#ifdef CONFIG_MAC80211_MESH
case NL80211_IFTYPE_MESH_POINT:
#endif
+ case NL80211_IFTYPE_AP:
+ case NL80211_IFTYPE_AP_VLAN:
case NL80211_IFTYPE_WDS:
return true;
default:
sinfo->filled = STATION_INFO_INACTIVE_TIME |
STATION_INFO_RX_BYTES |
- STATION_INFO_TX_BYTES;
+ STATION_INFO_TX_BYTES |
+ STATION_INFO_TX_BITRATE;
sinfo->inactive_time = jiffies_to_msecs(jiffies - sta->last_rx);
sinfo->rx_bytes = sta->rx_bytes;
sinfo->tx_bytes = sta->tx_bytes;
+ if (sta->local->hw.flags & IEEE80211_HW_SIGNAL_DBM) {
+ sinfo->filled |= STATION_INFO_SIGNAL;
+ sinfo->signal = (s8)sta->last_signal;
+ }
+
+ sinfo->txrate.flags = 0;
+ if (sta->last_tx_rate.flags & IEEE80211_TX_RC_MCS)
+ sinfo->txrate.flags |= RATE_INFO_FLAGS_MCS;
+ if (sta->last_tx_rate.flags & IEEE80211_TX_RC_40_MHZ_WIDTH)
+ sinfo->txrate.flags |= RATE_INFO_FLAGS_40_MHZ_WIDTH;
+ if (sta->last_tx_rate.flags & IEEE80211_TX_RC_SHORT_GI)
+ sinfo->txrate.flags |= RATE_INFO_FLAGS_SHORT_GI;
+
+ if (!(sta->last_tx_rate.flags & IEEE80211_TX_RC_MCS)) {
+ struct ieee80211_supported_band *sband;
+ sband = sta->local->hw.wiphy->bands[
+ sta->local->hw.conf.channel->band];
+ sinfo->txrate.legacy =
+ sband->bitrates[sta->last_tx_rate.idx].bitrate;
+ } else
+ sinfo->txrate.mcs = sta->last_tx_rate.idx;
+
if (ieee80211_vif_is_mesh(&sdata->vif)) {
#ifdef CONFIG_MAC80211_MESH
sinfo->filled |= STATION_INFO_LLID |
*/
if (params->interval) {
sdata->local->hw.conf.beacon_int = params->interval;
- ieee80211_hw_config(sdata->local,
- IEEE80211_CONF_CHANGE_BEACON_INTERVAL);
+ err = ieee80211_hw_config(sdata->local,
+ IEEE80211_CONF_CHANGE_BEACON_INTERVAL);
+ if (err < 0)
+ return err;
/*
* We updated some parameter so if below bails out
* it's not an error.
struct ieee80211_supported_band *sband;
struct ieee80211_sub_if_data *sdata = sta->sdata;
+ sband = local->hw.wiphy->bands[local->oper_channel->band];
+
/*
* FIXME: updating the flags is racy when this function is
* called from ieee80211_change_station(), this will
if (params->supported_rates) {
rates = 0;
- sband = local->hw.wiphy->bands[local->oper_channel->band];
for (i = 0; i < params->supported_rates_len; i++) {
int rate = (params->supported_rates[i] & 0x7f) * 5;
}
if (params->ht_capa)
- ieee80211_ht_cap_ie_to_sta_ht_cap(params->ht_capa,
+ ieee80211_ht_cap_ie_to_sta_ht_cap(sband,
+ params->ht_capa,
&sta->sta.ht_cap);
if (ieee80211_vif_is_mesh(&sdata->vif) && params->plink_action) {
struct sta_info *sta;
struct ieee80211_sub_if_data *sdata;
int err;
+ int layer2_update;
/* Prevent a race with changing the rate control algorithm */
if (!netif_running(dev))
rate_control_rate_init(sta);
+ layer2_update = sdata->vif.type == NL80211_IFTYPE_AP_VLAN ||
+ sdata->vif.type == NL80211_IFTYPE_AP;
+
rcu_read_lock();
err = sta_info_insert(sta);
if (err) {
/* STA has been freed */
+ if (err == -EEXIST && layer2_update) {
+ /* Need to update layer 2 devices on reassociation */
+ sta = sta_info_get(local, mac);
+ if (sta)
+ ieee80211_send_layer2_update(sta);
+ }
rcu_read_unlock();
return err;
}
- if (sdata->vif.type == NL80211_IFTYPE_AP_VLAN ||
- sdata->vif.type == NL80211_IFTYPE_AP)
+ if (layer2_update)
ieee80211_send_layer2_update(sta);
rcu_read_unlock();
rcu_read_unlock();
return 0;
}
+
+static int ieee80211_get_mesh_params(struct wiphy *wiphy,
+ struct net_device *dev,
+ struct mesh_config *conf)
+{
+ struct ieee80211_sub_if_data *sdata;
+ sdata = IEEE80211_DEV_TO_SUB_IF(dev);
+
+ if (sdata->vif.type != NL80211_IFTYPE_MESH_POINT)
+ return -ENOTSUPP;
+ memcpy(conf, &(sdata->u.mesh.mshcfg), sizeof(struct mesh_config));
+ return 0;
+}
+
+static inline bool _chg_mesh_attr(enum nl80211_meshconf_params parm, u32 mask)
+{
+ return (mask >> (parm-1)) & 0x1;
+}
+
+static int ieee80211_set_mesh_params(struct wiphy *wiphy,
+ struct net_device *dev,
+ const struct mesh_config *nconf, u32 mask)
+{
+ struct mesh_config *conf;
+ struct ieee80211_sub_if_data *sdata;
+ sdata = IEEE80211_DEV_TO_SUB_IF(dev);
+
+ if (sdata->vif.type != NL80211_IFTYPE_MESH_POINT)
+ return -ENOTSUPP;
+
+ /* Set the config options which we are interested in setting */
+ conf = &(sdata->u.mesh.mshcfg);
+ if (_chg_mesh_attr(NL80211_MESHCONF_RETRY_TIMEOUT, mask))
+ conf->dot11MeshRetryTimeout = nconf->dot11MeshRetryTimeout;
+ if (_chg_mesh_attr(NL80211_MESHCONF_CONFIRM_TIMEOUT, mask))
+ conf->dot11MeshConfirmTimeout = nconf->dot11MeshConfirmTimeout;
+ if (_chg_mesh_attr(NL80211_MESHCONF_HOLDING_TIMEOUT, mask))
+ conf->dot11MeshHoldingTimeout = nconf->dot11MeshHoldingTimeout;
+ if (_chg_mesh_attr(NL80211_MESHCONF_MAX_PEER_LINKS, mask))
+ conf->dot11MeshMaxPeerLinks = nconf->dot11MeshMaxPeerLinks;
+ if (_chg_mesh_attr(NL80211_MESHCONF_MAX_RETRIES, mask))
+ conf->dot11MeshMaxRetries = nconf->dot11MeshMaxRetries;
+ if (_chg_mesh_attr(NL80211_MESHCONF_TTL, mask))
+ conf->dot11MeshTTL = nconf->dot11MeshTTL;
+ if (_chg_mesh_attr(NL80211_MESHCONF_AUTO_OPEN_PLINKS, mask))
+ conf->auto_open_plinks = nconf->auto_open_plinks;
+ if (_chg_mesh_attr(NL80211_MESHCONF_HWMP_MAX_PREQ_RETRIES, mask))
+ conf->dot11MeshHWMPmaxPREQretries =
+ nconf->dot11MeshHWMPmaxPREQretries;
+ if (_chg_mesh_attr(NL80211_MESHCONF_PATH_REFRESH_TIME, mask))
+ conf->path_refresh_time = nconf->path_refresh_time;
+ if (_chg_mesh_attr(NL80211_MESHCONF_MIN_DISCOVERY_TIMEOUT, mask))
+ conf->min_discovery_timeout = nconf->min_discovery_timeout;
+ if (_chg_mesh_attr(NL80211_MESHCONF_HWMP_ACTIVE_PATH_TIMEOUT, mask))
+ conf->dot11MeshHWMPactivePathTimeout =
+ nconf->dot11MeshHWMPactivePathTimeout;
+ if (_chg_mesh_attr(NL80211_MESHCONF_HWMP_PREQ_MIN_INTERVAL, mask))
+ conf->dot11MeshHWMPpreqMinInterval =
+ nconf->dot11MeshHWMPpreqMinInterval;
+ if (_chg_mesh_attr(NL80211_MESHCONF_HWMP_NET_DIAM_TRVS_TIME,
+ mask))
+ conf->dot11MeshHWMPnetDiameterTraversalTime =
+ nconf->dot11MeshHWMPnetDiameterTraversalTime;
+ return 0;
+}
+
#endif
static int ieee80211_change_bss(struct wiphy *wiphy,
return -EINVAL;
if (params->use_cts_prot >= 0) {
- sdata->bss_conf.use_cts_prot = params->use_cts_prot;
+ sdata->vif.bss_conf.use_cts_prot = params->use_cts_prot;
changed |= BSS_CHANGED_ERP_CTS_PROT;
}
if (params->use_short_preamble >= 0) {
- sdata->bss_conf.use_short_preamble =
+ sdata->vif.bss_conf.use_short_preamble =
params->use_short_preamble;
changed |= BSS_CHANGED_ERP_PREAMBLE;
}
if (params->use_short_slot_time >= 0) {
- sdata->bss_conf.use_short_slot =
+ sdata->vif.bss_conf.use_short_slot =
params->use_short_slot_time;
changed |= BSS_CHANGED_ERP_SLOT;
}
+ if (params->basic_rates) {
+ int i, j;
+ u32 rates = 0;
+ struct ieee80211_local *local = wiphy_priv(wiphy);
+ struct ieee80211_supported_band *sband =
+ wiphy->bands[local->oper_channel->band];
+
+ for (i = 0; i < params->basic_rates_len; i++) {
+ int rate = (params->basic_rates[i] & 0x7f) * 5;
+ for (j = 0; j < sband->n_bitrates; j++) {
+ if (sband->bitrates[j].bitrate == rate)
+ rates |= BIT(j);
+ }
+ }
+ sdata->vif.bss_conf.basic_rates = rates;
+ changed |= BSS_CHANGED_BASIC_RATES;
+ }
+
ieee80211_bss_info_change_notify(sdata, changed);
return 0;
}
+static int ieee80211_set_txq_params(struct wiphy *wiphy,
+ struct ieee80211_txq_params *params)
+{
+ struct ieee80211_local *local = wiphy_priv(wiphy);
+ struct ieee80211_tx_queue_params p;
+
+ if (!local->ops->conf_tx)
+ return -EOPNOTSUPP;
+
+ memset(&p, 0, sizeof(p));
+ p.aifs = params->aifs;
+ p.cw_max = params->cwmax;
+ p.cw_min = params->cwmin;
+ p.txop = params->txop;
+ if (local->ops->conf_tx(local_to_hw(local), params->queue, &p)) {
+ printk(KERN_DEBUG "%s: failed to set TX queue "
+ "parameters for queue %d\n", local->mdev->name,
+ params->queue);
+ return -EINVAL;
+ }
+
+ return 0;
+}
+
+static int ieee80211_set_channel(struct wiphy *wiphy,
+ struct ieee80211_channel *chan,
+ enum nl80211_channel_type channel_type)
+{
+ struct ieee80211_local *local = wiphy_priv(wiphy);
+
+ local->oper_channel = chan;
+ local->oper_channel_type = channel_type;
+
+ return ieee80211_hw_config(local, IEEE80211_CONF_CHANGE_CHANNEL);
+}
+
struct cfg80211_ops mac80211_config_ops = {
.add_virtual_intf = ieee80211_add_iface,
.del_virtual_intf = ieee80211_del_iface,
.change_mpath = ieee80211_change_mpath,
.get_mpath = ieee80211_get_mpath,
.dump_mpath = ieee80211_dump_mpath,
+ .set_mesh_params = ieee80211_set_mesh_params,
+ .get_mesh_params = ieee80211_get_mesh_params,
#endif
.change_bss = ieee80211_change_bss,
+ .set_txq_params = ieee80211_set_txq_params,
+ .set_channel = ieee80211_set_channel,
};
git://ftp.safe.ca / safe / jmp / linux-2.6 / blobdiff