static struct console_cmdline console_cmdline[MAX_CMDLINECONSOLES];
static int selected_console = -1;
static int preferred_console = -1;
+int console_set_on_cmdline;
+EXPORT_SYMBOL(console_set_on_cmdline);
/* Flag: console code may call schedule() */
static int console_may_schedule;
*s = 0;
__add_preferred_console(buf, idx, options, brl_options);
+ console_set_on_cmdline = 1;
return 1;
}
__setup("console=", console_setup);
{
if (!console_suspend_enabled)
return;
- printk("Suspending console(s)\n");
+ printk("Suspending console(s) (use no_console_suspend to debug)\n");
acquire_console_sem();
console_suspended = 1;
}
_log_end = log_end;
con_start = log_end; /* Flush */
spin_unlock(&logbuf_lock);
+ stop_critical_timings(); /* don't trace print latency */
call_console_drivers(_con_start, _log_end);
+ start_critical_timings();
local_irq_restore(flags);
}
console_locked = 0;
}
late_initcall(disable_boot_consoles);
-/**
- * tty_write_message - write a message to a certain tty, not just the console.
- * @tty: the destination tty_struct
- * @msg: the message to write
- *
- * This is used for messages that need to be redirected to a specific tty.
- * We don't put it into the syslog queue right now maybe in the future if
- * really needed.
- */
-void tty_write_message(struct tty_struct *tty, char *msg)
-{
- if (tty && tty->ops->write)
- tty->ops->write(tty, msg, strlen(msg));
- return;
-}
-
#if defined CONFIG_PRINTK
+
/*
* printk rate limiting, lifted from the networking subsystem.
*
- * This enforces a rate limit: not more than one kernel message
- * every printk_ratelimit_jiffies to make a denial-of-service
- * attack impossible.
+ * This enforces a rate limit: not more than 10 kernel messages
+ * every 5s to make a denial-of-service attack impossible.
*/
-int __printk_ratelimit(int ratelimit_jiffies, int ratelimit_burst)
-{
- return __ratelimit(ratelimit_jiffies, ratelimit_burst);
-}
-EXPORT_SYMBOL(__printk_ratelimit);
-
-/* minimum time in jiffies between messages */
-int printk_ratelimit_jiffies = 5 * HZ;
-
-/* number of messages we send before ratelimiting */
-int printk_ratelimit_burst = 10;
+DEFINE_RATELIMIT_STATE(printk_ratelimit_state, 5 * HZ, 10);
int printk_ratelimit(void)
{
- return __printk_ratelimit(printk_ratelimit_jiffies,
- printk_ratelimit_burst);
+ return __ratelimit(&printk_ratelimit_state);
}
EXPORT_SYMBOL(printk_ratelimit);