* @signal: signal strength when receiving this frame, either in dBm, in dB or
* unspecified depending on the hardware capabilities flags
* @IEEE80211_HW_SIGNAL_*
- * @noise: noise when receiving this frame, in dBm (DEPRECATED).
* @antenna: antenna used
* @rate_idx: index of data rate into band's supported rates or MCS index if
* HT rates are use (RX_FLAG_HT)
enum ieee80211_band band;
int freq;
int signal;
- int noise __deprecated;
int antenna;
int rate_idx;
int flag;
* one milliwatt. This is the preferred method since it is standardized
* between different devices. @max_signal does not need to be set.
*
- * @IEEE80211_HW_NOISE_DBM:
- * Hardware can provide noise (radio interference) values in units dBm,
- * decibel difference from one milliwatt.
- *
* @IEEE80211_HW_SPECTRUM_MGMT:
* Hardware supports spectrum management defined in 802.11h
* Measurement, Channel Switch, Quieting, TPC
IEEE80211_HW_2GHZ_SHORT_PREAMBLE_INCAPABLE = 1<<4,
IEEE80211_HW_SIGNAL_UNSPEC = 1<<5,
IEEE80211_HW_SIGNAL_DBM = 1<<6,
- IEEE80211_HW_NOISE_DBM = 1<<7,
+ /* use this hole */
IEEE80211_HW_SPECTRUM_MGMT = 1<<8,
IEEE80211_HW_AMPDU_AGGREGATION = 1<<9,
IEEE80211_HW_SUPPORTS_PS = 1<<10,
struct ieee80211_bss_conf *info,
u32 changed);
u64 (*prepare_multicast)(struct ieee80211_hw *hw,
- int mc_count, struct dev_addr_list *mc_list);
+ struct netdev_hw_addr_list *mc_list);
void (*configure_filter)(struct ieee80211_hw *hw,
unsigned int changed_flags,
unsigned int *total_flags,